ページ1に含まれる内容の要旨
Setting the jumpers
Refer to the jumper settings in Figure 1 or on your drive label to configure
the drive for your system. Jumper settings can also be accessed online
from our web site at www.seagate.com.
Master or single drive: Use the options jumper block shown in Figure 1 to
Momentus 4200.2 Installation Guide
configure the drive for operation. This jumper block is the 4-pin header
ST9100822A, ST9808210A, ST960821A, ST950212A,
adjacent to pins 1 and 2 of the I/O signal pins.
ST9402113A and S
ページ2に含まれる内容の要旨
Note. If these tips do not answer your question or solve the problem, con- Configuring the BIOS tact your dealer or visit http://seatools.seagate.com to download After completing the drive installation, restart your computer. Your com- SeaTools™ disc diagnostics software and more troubleshooting puter may automatically detect your new drive. If your computer does not advice. automatically detect your new drive, follow the steps below. 1. Restart your computer. While the computer restarts, run th
