Maxtor MaxAttach NAS 4000 Seriesの取扱説明書

ページ1に含まれる内容の要旨

MaxAttach NAS 4000 Series Quick Start Card
Thank you for choosing a Maxtor MaxAttach™ NAS 4000 Series file server. Take a moment to verify the
contents in your box and note the serial number of your MaxAttach for future reference. The procedures out-
lined here assume that you are familiar with networking and system administration basics. If not, please refer to
the Installation and Configuration Guide on the enclosed MaxAttach NAS 4000 Series CD.
Box Contents
• MaxAttach NAS 4000 Series file

ページ2に含まれる内容の要旨

Connect the MaxAttach to your Network 1. Connect one of the enclosed CAT-5 Ethernet cables to either 10/100 Base T Ethernet port on the back of your MaxAttach. Insert the other end of this cable into a 10/100 Ethernet connection on your network hub or switch. If you connect both Ethernet ports to your network, they are pre- configured to enable fail-over and load balancing. Use the power cord to connect the MaxAttach to a power source. 2. Make sure the main power On/Off rocker switch located