ページ1に含まれる内容の要旨
Quickview 40 20/30/40GB AT
Product Manual
May 24, 2005
Part Number: 000001925
ページ2に含まれる内容の要旨
May 24, 2005 Maxtor Corporation. All rights reserved. Printed in U.S.A.This publication could include technical inaccuracies or typographical errors. Changes are periodically made to the information herein – which will be incorporated in revised editions of the publication. Maxtor may make changes or improvements in the product(s) described in this publication at any time and without notice. UL/CSA/VDE/TUV/RoHS UL standard 1954 recognition granted under File No. E78016 CSA standard C22.2-950 cer
ページ3に含まれる内容の要旨
Maxtor reserves the right to make changes and improvements to its products, without incurring any obliga- tion to incorporate such changes or improvements into units previously sold or shipped. This product or document is protected by copyright and distributed under licences restricting its use, copy- ing, distributing, and decompilation. No part of this product or document may be reproduced in any form by any means without prior written authorization of Maxtor and its licensors, if any. RESTRIC
ページ4に含まれる内容の要旨
Please do not remove or cover up Maxtor factory-installed drive labels. They contain information required should the drive ever need repair.Thank you for your interest in Maxtor hard disk drives. This manual pro- vides technical information for OEM engineers and systems integrators regarding the installation and use of Maxtor hard drives. Drive repair should be performed only at an authorized repair center. For repair infor- mation, contact the Maxtor Customer Service Center at 800-2MAXTOR or 1-
ページ5に含まれる内容の要旨
Table of Content Chapter 1 INTRODUCTION 1.1 MAXTOR CORPORATION................................................................. 1-1 1.2 AUDIENCE ..................................................................................... 1-1 1.3 MANUAL ORGANIZATION.................................................................1-2 1.4 TERMINOLOGY AND CONVENTIONS................................................. 1-2 1.5 REFERENCES..........................................................................
ページ6に含まれる内容の要旨
Table of Contents Chapter 4 INSTALLATION 4.1 SPACE REQUIREMENTS................................................................... 4-1 4.2 UNPACKING INSTRUCTIONS............................................................ 4-2 4.3 HARDWARE OPTIONS..................................................................... 4-5 4.3.1 CABLE SELECT (CS) JUMPER ....................................................4-6 4.3.2 DRIVE SELECT (DS) JUMPER ....................................................4-7 4.3.
ページ7に含まれる内容の要旨
Table of Contents Chapter 6 SERVICE AND SUPPORT 6.1 PRODUCT SUPPORT/TECHNICAL ASSISTANCE/CUSTOMER SERVICE. 6-1 Glossary................................................................................................G-1 Quickview 40 20/30/40GB AT iii
ページ8に含まれる内容の要旨
List of Figures Figure 4-1 Mechanical Dimensions...........................................................4-1 Figure 4-2 Single-Pack Shipping Container ..............................................4-3 Figure 4-3 25-Pack Shipping Container ...................................................4-4 Figure 4-4 Jumper Locations on the Interface Connector ..........................4-5 Figure 4-5 AT Connector and Jumper Location ........................................4-8 Figure 4-6 Mounting Screw Clear
ページ9に含まれる内容の要旨
List of Tables Table 4-1 AT Jumper Option.........................................................................4-6 Table 4-2 J1 Power Connector, Section A......................................................4-12 Table 4-3 Logical Addressing Form.................................................................4-19 Table 5-1 Supported Commands.................................................................... 5-2 Table 5-2 Identify Drive Command Parameters.....................................
ページ10に含まれる内容の要旨
Chapter 1 Introduction 1.1 Maxtor Corporation Maxtor corporation is one of the world’s largest suppliers of hard disk drive products-products that help store the digital world for millions of users. Maxtor products serve a range of markets, including personal and entertainment, small office/home office, mid-sized business and enterprise Products Maxtor storage products include drives and accessories for PC’s, workstations, RAID products, enterprise applications, enterprise servers, high-en
ページ11に含まれる内容の要旨
Introduction 1.3 MANUAL ORGANIZATION This manual is organized into the following chapters: Chapter 1 – Introduction Chapter 2 – Product Description Chapter 3 – Product Specifications Chapter 4 – Installation Chapter 5 – ATA Bus Interface and ATA Commands Chapter 6 – Service and Support Glossary 1.4 TERMINOLOGY AND CONVENTIONS In the Glossary at the back of this manual, you can find definitions for many of the terms used in this manual. In addition, the following abbreviations are
ページ12に含まれる内容の要旨
Introduction MB/s megabytes per second MHz megahertz ms milliseconds MSB most significant bit mV millivolts ns nanoseconds tpi tracks per inch µs microseconds V volts The typographical and naming conventions used in this manual are listed below. Conventions that are unique to a specific table appear in the notes that follow that table. Typographical Conventions: Names of Bits: Bit names are presented in initial capitals. An example is the Host Software Reset bit. Commands:
ページ13に含まれる内容の要旨
Introduction 1.5 REFERENCE For additional information about the ATA interface, refer to the latest revision of the draft standard on the internet at http://www.t13/ using the link under “1410DAT Attachment - 6 with Packet Interface (ATA/ATAPI - 6).” 1-4 Quickview 40 20/30/40GB AT
ページ14に含まれる内容の要旨
Chapter 2 PRODUCT DESCRIPTION 2.1 PRODUCT DESCRIPTION Maxtor’s Quickview 40 PATA hard disk drives are part of a family of high performance, 1-inch-high hard disk drives manufactured to meet the highest product quality standards. These hard disk drives are non-removable, 3 1/2-inch hard disks and are available with the PATA interface. The Quickview 40 20/30/40GB PATA hard disk drives feature an embedded hard disk drive controller, and use PATA commands to optimize system performance. Because
ページ15に含まれる内容の要旨
General Description Performance 10.0 ms seek time (Increased in Quiet Mode) Average rotational latency of 4.17ms New Ultra ATA interface with Maxtor-patented Ultra ATA/133 protocol supporting burst data transfer rates of 133MB/s. 2 MB buffer with 1.9MB (approximate) Advance Cache Management (ACM). Advanced Multi-burst ECC on-the-fly Support of all standard ATA data transfer modes with PIO mode 4 and multiword DMA mode 2, and Ultra DMA modes 0, 1, 2, 3, 4, 5 and 6 Reliability 57
ページ16に含まれる内容の要旨
General Description 2.2 REGULATORY COMPLIANCE STANDARDS Maxtor Corporation’s disk drive products meet all domestic and international product safety regulatory compliance requirements. Maxtor’s disk drive products conform to the following specifically marked Product Safety Standards: Underwriters Laboratories (UL) Standard 1950. This certificate is a category certification pertaining to all 3.5-inch series drives models. Canadian Standards Association (CSA) Standard C.22.2 No. 1950. This
ページ17に含まれる内容の要旨
Chapter 3 PRODUCT SPECIFICATIONS 3.1 Models and Capacities MODELS NUMBERS RoHS Compliant 6K020L0 6K030L0 6K040L0 Formatted Capacity (GB LBA Mode) 20GB 30GB 40GB GB means 1 billion bytes. Total accessible capacity varies depending on operating environment. * Complies with European Union Directive on Restriction of Hazardous Substances (Section 3.13) 3.2 Drive Configuration MODELS 20GB 30GB 40GB Data Surfaces/Number of Heads 1 1 1 Number of Disks 111 Sectors per Drive (max LBA) 40,718,160 60,058
ページ18に含まれる内容の要旨
Product Specifications MODELS 20GB 30GB 40GB Recording Density (kbpi, ID/OD) ID = 446/613/713 OD = 338/476/560 Track Density (ktpi) 75.9/75.9/88.7 3-2 Quickview 40 20/30/40GB AT
ページ19に含まれる内容の要旨
Product Specifications 3.3 Performance Specifications MODELS 20GB 30GB 40GB Seek Times (typical read, ms) Track-to-Track 0.8 Average (normal seek) ≤ 10.0 Full Stroke (normal seek) ≤ 18.0 Average Latency (ms) 4.17 Controller Overhead (ms) <0.3 Rotation Speed (RPM ±0.1%) 7200 Data Transfer Speed (MByte/sec max) To/From Interface 133 (Maxtor Ultra ATA/133, up to) To/From Media (ID/OD up to nn.n, where ID = 290/399/463 nn.n is the maximum transfer rate possible) OD = 454/636/738 Sustained (ID/OD up
ページ20に含まれる内容の要旨
Product Specifications 3.5 Power Requirements MODE 12V (MA) 5V (MA) POWER (W) Spin-up (peak) 1554.20 756.04 22.43 Seek 440.42 562.13 8.10 Read/Write 489.99 442.42 8.09 Idle 380.57 396.41 7.27 Standby 34.35 65.83 0.75 Sleep 34.25 65.77 0.75 3.6 Power Mode Definitions Spin-up The drive is spinning up following initial application of power and has not yet reached full speed. Seek A random access operation by the drive. Read/Write Data is being read from or written to the drive. Idle The drive is
