ページ1に含まれる内容の要旨
C141-E221-02EN
MHV2080AS, MHV2060AS, MHV2040AS
DISK DRIVE
PRODUCT MANUAL
ページ2に含まれる内容の要旨
FOR SAFE OPERATION Handling of This Manual This manual contains important information for using this product. Read thoroughly before using the product. Use this product only after thoroughly reading and understanding especially the section “Important Alert Items” in this manual. Keep this manual handy, and keep it carefully. FUJITSU makes every effort to prevent users and bystanders from being injured or from suffering damage to their property. Use the product according to this manua
ページ3に含まれる内容の要旨
Revision History (1/1) Revised section (*1) Edition Date Details (Added/Deleted/Altered) 01 2005-02-25 02 2005-03-18 Section 1.1.2 (Altered) Change of description Section 1.5 (Altered) Change of Table 1.5 *1 Section(s) with asterisk (*) refer to the previous edition when those were deleted. C141-E221
ページ4に含まれる内容の要旨
This page is intentionally left blank.
ページ5に含まれる内容の要旨
Preface This manual describes MHV2080AS, MHV2060AS, MHV2040AS model of the MHV Series, 2.5-inch hard disk drives. These drives have a built-in controller that is compatible with the ATA interface. This manual describes the specifications and functions of the drives and explains in detail how to incorporate the drives into user systems. This manual assumes that the reader has a basic knowledge of hard disk drives and their implementations in computer systems. This manual consists of s
ページ6に含まれる内容の要旨
Preface Conventions for Alert Messages This manual uses the following conventions to show the alert messages. An alert message consists of an alert signal and alert statements. The alert signal consists of an alert symbol and a signal word or just a signal word. The following are the alert signals and their meanings: This indicates a hazardous situation could result in minor or moderate personal injury if the user does not perform the procedure correctly. This alert signal also
ページ7に含まれる内容の要旨
Preface Attention Please forward any comments you may have regarding this manual. To make this manual easier for users to understand, opinions from readers are needed. Please write your opinions or requests on the Comment at the back of this manual and forward it to the address described in the sheet. Liability Exception “Disk drive defects” refers to defects that involve adjustment, repair, or replacement. Fujitsu is not liable for any other disk drive defects, such as those caused b
ページ8に含まれる内容の要旨
This page is intentionally left blank.
ページ9に含まれる内容の要旨
Important Alert Items Important Alert Messages The important alert messages in this manual are as follows: A hazardous situation could result in minor or moderate personal injury if the user does not perform the procedure correctly. Also, damage to the product or other property, may occur if the user does not perform the procedure correctly. Task Alert message Page Normal Operation 3-7 Data corruption: Avoid mounting the disk near strong magnetic sources such as loud speakers
ページ10に含まれる内容の要旨
This page is intentionally left blank.
ページ11に含まれる内容の要旨
Manual Organization MHV2080AS • Device Overview MHV2060AS, MHV2040AS Device Configuration Installation Conditions DISK DRIVE Theory of Device Operation PRODUCT MANUAL Interface (C141-E221) Operations MHV2080AS Maintenance and Diagnosis MHV2060AS, MHV2040AS Removal and Replacement Procedure DISK DRIVE MAINTENANCE MANUAL (C141-F073) C141-E221 vii
ページ12に含まれる内容の要旨
This page is intentionally left blank.
ページ13に含まれる内容の要旨
Contents CHAPTER 1 Device Overview........................................................................1-1 1.1 Features ..............................................................................................................1-2 1.1.1 Functions and performance .....................................................................1-2 1.1.2 Adaptability.............................................................................................1-2 1.1.3 Interface.................
ページ14に含まれる内容の要旨
Contents CHAPTER 3 Installation Conditions ............................................................. 3-1 3.1 Dimensions ........................................................................................................ 3-2 3.2 Mounting............................................................................................................ 3-3 3.3 Cable Connections............................................................................................. 3-9 3.3.1 Device
ページ15に含まれる内容の要旨
Contents 4.6.2 Write circuit.............................................................................................4-9 4.6.3 Read circuit............................................................................................4-10 4.6.4 Digital PLL circuit.................................................................................4-11 4.7 Servo Control ...................................................................................................4-12 4.7.1 Servo cont
ページ16に含まれる内容の要旨
Contents (12) STANDBY (X’96’ or X’E2’) .......................................................5-36 (13) IDLE (X’97’ or X’E3’) .................................................................5-37 (14) CHECK POWER MODE (X’98’ or X’E5’).................................5-39 (15) SLEEP (X’99’ or X’E6’) ..............................................................5-40 (16) SMART (X’B0) ............................................................................5-41 (17) DEVICE CONFIGURA
ページ17に含まれる内容の要旨
Contents (45) WRITE MULTIPLE EXT (X’39’): Option (customizing)........5-120 (46) WRITE DMA FUA EXT (X’3D’): Option (customizing) ........5-121 (47) WRITE LOG EXT (X’3F’) [Optional command (Customize)]...............................................................................5-122 (48) READ VERIFY SECTOR(S) EXT (X’42): Option (customizing)..............................................................................5-124 (49) WRITE MULTIPLE FUA EXT (X’CE’): Option (customizi
ページ18に含まれる内容の要旨
Contents 5.6.3 Ultra DMA data transfer..................................................................... 5-151 5.6.3.1 Initiating an Ultra DMA data in burst ..................................... 5-151 5.6.3.2 Ultra DMA data burst timing requirements ............................ 5-152 5.6.3.3 Sustained Ultra DMA data in burst......................................... 5-155 5.6.3.4 Host pausing an Ultra DMA data in burst............................... 5-156 5.6.3.5 Device terminatin
ページ19に含まれる内容の要旨
Contents 6.4.3.1 Miss-hit ......................................................................................6-15 6.4.3.2 Sequential hit..............................................................................6-16 6.4.3.3 Full hit ........................................................................................6-17 6.4.3.4 Partial hit....................................................................................6-18 6.5 Write Cache..................................
ページ20に含まれる内容の要旨
Contents Illustrations Figures Figure 1.1 Negative voltage at +5 V when power is turned off............................ 1-6 Figure 1.2 Current fluctuation (Typ.) at +5 V when power is turned on............................................................................................ 1-8 Figure 2.1 Disk drive outer view........................................................................... 2-2 Figure 2.2 1 drive system configuration ...........................................
