DB Link DB ResearchDB driveの取扱説明書

ページ1に含まれる内容の要旨

E5 HLC6
6 Channel Line Output Converter

ページ2に含まれる内容の要旨

We would like to congratulate you on your purchase of the E5 HLC6; a 6 channel, high-performance line output converter. The E5 HLC6 will accept two, four, or six channels of Speaker-level signal from a factory-installed amplier or Source unit and convert it into a high-quality, low-noise pre-amp signal. Therefore the E5 HLC6 will allow you to use your factory installed source unit but give you the ability to add any high performance aftermarket amplier and processor. Wether th

ページ3に含まれる内容の要旨

FRONT PANEL CONTROLS ELECTRICAL INSTALLATION 4 3 RCA Connectors Rear AMPLIF IER Speakers Factory Installed 5 Radio SUB REMOTE SUB REAR FRONT LEVEL OUTPUT SUB REAR 220 Summed Summed POWER ISO Separate Separate SHORT SIX CHANNEL LINE OUTPUT CONVERTER 6 SUB REAR FRONT OUTPUT VOLUME OUTPUT VOLUME OUTPUT VOLUME Front AMPLIF IER Speakers Speaker Level -4 Channel RCA Connectors AMPLIF IER Factory Installed Subwoofers 2 Radio SUB REMOTE LEVEL SUB REAR FRONT OUTPUT SUB REAR 220 Summed Summed 1 POWER

ページ4に含まれる内容の要旨

BLOCK DIAGRAM SPECIFICATIONS All specifications are measured at 14.4VDC >Maximum speaker-level input 60 watts @ 4 ohm >Maximum output level 9.5 V rms >Output gain +/-12dB >Frequency response 10Hz-25kHz >T otal harmonic distortion 0.01% >Input Impedance 180 ohms >Power supply PWM switching >Power draw 200 mA >Recommended fuse rating 1 Amp >Remote Trigger Output Current 1 Amp Max -4-