Apple XSERVE RAIDの取扱説明書

ページ1に含まれる内容の要旨

 Xserve, Xserve G5, Xserve RAID
Hard Drive
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Online instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Note: Blank drive carriers, which may fill some of the hard drive bays, follow the same
replacement procedure as hard drives. If you are replacing a blank carri

ページ2に含まれる内容の要旨

Removing the Installed Hard Drive 1. Make sure the drive being replaced is not in use by any application and that removing it will not disrupt the RAID scheme in use. 2. Press the handle on the front of the drive module so the handle pops out. (Figure 1) Note: The illustrations below are for Xserve drives; Xserve RAID drives, although oriented vertically, are removed in a similar way. Figure 1 3. Wait for the upper or right LED on the drive to go out. Then grasp the drive handle, and

ページ3に含まれる内容の要旨

Installing the Replacement Hard Drive 1. Press the handle on the front of the replacement drive module so that the handle pops out. 2. Place your fingers on the center of the drive faceplate directly below the handle. Push the drive into the empty bay until its connector clicks into place. 3. Press in the handle on the drive module so that it is flush with the front panel. 4. Wait for the upper or right LED to turn green, indicating normal operation.  Apple Computer, Inc. © 2004 Apple