Compaq 400000の取扱説明書

ページ1に含まれる内容の要旨

Using the Wedge
Attaching the Wedge to Your Computer
To attach the Wedge to your computer, complete the following steps:
1. Line up your computer with the alignment hooks on the Wedge.
2. Pivot your computer down and press it firmly into place on the Wedge.
Your computer will snap into place.
Attaching the Wedge

ページ2に含まれる内容の要旨

Detaching the Wedge from Your Computer Before detaching the Wedge from your computer, you must first shut down the computer, using one of the following methods: • Turn off the computer using the standard Windows shutdown method. • Press the Power ¹ button to initiate Hibernation mode. • Click the Start button on the Windows taskbar, then click Eject PC. When the computer has shut down, detach the computer from the Wedge by completing the following steps: 1. Press in the Wedge Release button loc

ページ3に含まれる内容の要旨

Inserting the Battery To insert the battery, complete the following steps: 1. If the AC adapter is not connected, turn off your computer. 2. Close the computer cover. 3. Slide the battery label side up into the compartment until you hear a click. Inserting the Battery Removing the Battery To remove the battery, complete the following steps: 1. Save and close any open files. 2. If the AC adapter is not connected, turn off your computer. 3. Release the battery by sliding the switch on the un

ページ4に含まれる内容の要旨

NOTICE The information in this card is subject to change without notice. COMPAQ COMPUTER CORPORATION SHALL NOT BE LIABLE FOR TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN; NOR FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE FURNISHING, PERFORMANCE, OR USE OF THIS MATERIAL. This card contains information protected by copyright. No part of this card may be photocopied or reproduced in any form without prior written consent from Compaq Computer Corporation. ©1999 Compaq Com