Vulcan-Hart 60RRGの取扱説明書

デバイスVulcan-Hart 60RRGの取扱説明書

デバイス: Vulcan-Hart 60RRG
カテゴリ: オーブンプレート
メーカー: Vulcan-Hart
サイズ: 2.61 MB
追加した日付: 11/20/2014
ページ数: 22
説明書を印刷

ダウンロード

使い方は?

私たちの目的は、皆様方にデバイスVulcan-Hart 60RRGの取扱説明書に含まれたコンテンツを可能な限り早く提供することです。オンラインプレビューを使用すると、Vulcan-Hart 60RRGに関してあなたが抱えている問題に対する解決策の内容が素早く表示されます。

便宜上

説明書Vulcan-Hart 60RRGをこちらのサイトで閲覧するのに不都合がある場合は、2つの解決策があります:

  • フルスクリーン表示 – 説明書を(お使いのコンピュータにダウンロードすることなく)便利に表示させるには、フルスクリーン表示モードをご使用ください。説明書Vulcan-Hart 60RRGのフルスクリーン表示を起動するには、全画面表示ボタンを押してください。
  • コンピュータにダウンロード - Vulcan-Hart 60RRGの説明書をお使いのコンピュータにダウンロードし、ご自身のコレクションに加えることもできます。デバイス上のスペースを無駄にしたくない場合は、いつでもManualsBaseサイトでダウンロードすることもできます。
Vulcan-Hart 60RRG 取扱説明書 - Online PDF
Advertisement
« Page 1 of 22 »
Advertisement
印刷版

多くの人々は画面表示ではなく印刷された説明書を読むほうを好みます。説明書を印刷するオプションも提供されており、上記のリンクをクリックすることによりそれを利用できます - 説明書を印刷。説明書Vulcan-Hart 60RRGを全部印刷する必要はなく、選択したページだけを印刷できます。紙を節約しましょう。

要旨

次のページにある説明書Vulcan-Hart 60RRGの内容のプレビューは、以下にあります。次のページにある説明書の内容をすぐに表示したい場合は、こちらをご利用ください。

内容要旨
ページ1に含まれる内容の要旨

SERVICE MANUAL
Heavy Duty Gas Griddles






MODEL MLS
24RRG ML-135339-00024
36RRG ML-135340-00036
48RRG ML-135341-00048
60RRG ML-135342-00060

www.vulcanhart.com






48RRG


ITW Food Equipment Group, LLC
3600 North Point Blvd.
Baltimore, MD 21222 FORM F-36986 (Rev. 11-08)

ページ2に含まれる内容の要旨

TABLE OF CONTENTS INSTALLATION………………………………………………………….. 4 OPERATION……………………………………………………………... 4 CLEANING……………………………………………………………….. 4 LUBRICATION…………………………………………………………… 4 SPECIFICATIONS………………………………………………………. 4 COMPONENT LOCATION……………………………………………... 5 CONTROL PANEL………………………………………………………. 6 BULLNOSE………………………………………………………………. 6 BACK PANEL……………………………………………………………. 6 IDENTIFICATION PLATE………………………………………………. 6 FLUE………………………………………………………………………. 6 THERMOSTAT…………………………………………………………... 7 THERMOSTAT

ページ3に含まれる内容の要旨

BURNER………………………………………………………………….. 15 BURNER TROUBLESHOOTING………………………………………. 15 BURNER REMOVAL……………………………………………………. 15 BURNER ADJUSTMENT……………………………………………….. 16 GAS REGULATOR……………………………………………………… 17 REGULATOR TROUBLESHOOTING…………………………………. 17 SYMPTOM-UNIT WILL NOT MAINTAIN CONSISTENT GAS PRESSURE………………………………………………………………. 17 GAS PRESSURE MEASUREMENT…………………………………... 17 PRESSURE TAP LOCATION………………………………………….. 18 SEQUENCE OF OPERATION…………………………………………. 18 WIRING DIAGRAM

ページ4に含まれる内容の要旨

GENERAL INTRODUCTION This manual is prepared for the use of trained service technicians and should only be used by those who are properly qualified. This manual is not intended to be all encompassing. You should read, in it's entirety, the repair procedure you wish to perform to determine if you have the necessary tools, instruments and skills required to perform the procedure. Procedures for which you do not have the necessary tools, instruments and skills should not be attempted.

ページ5に含まれる内容の要旨

COMPONENT LOCATION GAS MANIFOLD 720122 PRESSURE CHECK PLUG PILOT SPARK ASSEMBLY 713930 ¼” FLEX TUBE BURNER ORIFICE TEMPERATURE CONTROLLER 498438 SAFETY IGNITION MODULE 498443 DUAL SOLENOID VALVE 713656 KNOB 498438-1 3/8” FLEX TUBE PILOT ADJUSTMENT VALVE INDICATOR LIGHT 719194 720017 POWER SWITCH

ページ6に含まれる内容の要旨

EXTERIOR PANELS CONTROL PANEL FLUE Disconnect the electrical power and follow lockout BACK PANEL / tagout procedures BULLNOSE The Control Panel holds the thermostats, indicator lights and power switch. REMOVAL 1. Remove the four screws securing the front of the control panel. There are two screws at each end of the panel. 2. Remove the screws that secure the bottom of the control panel to the underside of the chassis. 3. Pull the control panel forward and lay face

ページ7に含まれる内容の要旨

THERMOSTAT WIRING CONFIGURATION FRONT VIEW The thermostat is a solid state control. The thermostat supplies power to the burner solenoid valves and indicator lights when turned on or until the temperature setpoint is reached. Disconnect the electrical power and follow lockout / tagout procedures THERMOSTAT TROUBLESHOOTING SYMPTOM – BURNER WILL NOT COME ON 1. Check for loose or excessively greasy/dirty connections at thermostat terminals

ページ8に含まれる内容の要旨

Disconnect the electrical power and follow lockout/tagout procedures THERMOSTAT REMOVAL 1. Remove the control panel 2. Remove the knob 3. Label and disconnect the wires 4. Remove the thermostat retaining nut on the knob shaft. 5. Reverse procedure to install while being careful to install the thermostat in the same orientation. TEMPERATURE PROBE The temperature probe is an embedded K type thermocouple assembly. 498432-A Disconnect the electrical power and follow lo

ページ9に含まれる内容の要旨

ADJUSTMENTS CALIBRATION 1. Each temperature controller controls a 12” zone of the griddle. Using a Surface Probe temperature measurement device, observe the temperatures at the center points of the cooking zones. These points are located by starting 6” from the side splash (left or right) and every 12” across the width of the griddle, with all points located 12” back from the front edge of the griddle plate. NOTE: Use of infrared thermometers is not recommended. These devices ar

ページ10に含まれる内容の要旨

# 3 TERMINAL TEMPERATURE # 1 TERMINAL CONTROLLER # 2 TERMINAL POWER SWITCH INDICATOR LIGHT POWER ON/OFF SWITCH The Power Switch controls the power supply to all other electronic components. Disconnect the electrical power and follow lockout / tagout procedures POWER SWITCH TROUBLESHOOTING SYMPTOM – NO POWER BEING SUPPLIED TO THE UNIT 1. Check for loose or excessively greasy/dirty connections at terminals.

ページ11に含まれる内容の要旨

INDICATOR LIGHT The indicator light illuminates fully to indicate that the corresponding thermostat and burner have turned on and gas is flowing through the corresponding solenoid valve. The indicator light will illuminate at a lower intensity when the pilot safety circuit is being made (pilot lit) but the corresponding burner solenoid valve and thermostat are not on. The indicator light will exhibit no illumination if the pilot safety circuit is not made (pilot not lit). INDICATOR LIGH

ページ12に含まれる内容の要旨

Disconnect the electrical power and follow lockout / tagout procedures SAFETY IGNITION MODULE TROUBLESHOOTING SYMPTOM – NO SPARK BETWEEN PILOT HEAD AND ELECTRODE 1. Check for loose or greasy/dirty connections at all terminals (including electrode wire) 2. Check for 120 voltage from pin 4 wire to ground. a. If no voltage check on/off switch and wiring for shorts or breaks 3. Check electrode wire for damage and continuity – if damaged or no continuity change spark/pilot assembly a.

ページ13に含まれる内容の要旨

INPUT GAS LINE IN BACK CENTER RETAINING SCREW Retaining screw OUTPUT GAS LINES DOUBLE SOLENOID VALVE Disconnect the electrical power and follow lockout / tagout procedures SOLENOID VALVE TROUBLESHOOTING SYMPTOM – NO GAS FLOW TO BURNER 1. Check terminals for loose or greasy/dirty connections 2. Check gas pressure – check for orifice obstructions. 3. With thermostat, indicator light and power switch on – check for 120 voltage between the two

ページ14に含まれる内容の要旨

PILOT The RRG Series Griddles utilize a solenoid valve with a brass pilot valve to control gas flow to pilot burners. One to three pilot flames can be fed by one valve – BRASS PILOT one leg of which may be branched. VALVE PILOT TROUBLESHOOTING SYMPTOM – PILOT WILL NOT LIGHT 1. Check pilot adjustment at solenoid valve 2. Check that power switch is on 3. Check that pilot solenoid valve is working 4. Check that safety ignition module and power switch are working 5. Check gas

ページ15に含まれる内容の要旨

HELPFUL HINT – If the unit is attached to a flexible gas line, you can extend the bullet feet out to their fullest extension to raise the griddle and allow yourself more clearance while reaching under the unit. Remember to relevel the unit if you chose to do this. BURNER The RRG Series Griddle utilizes U-shaped burners with a single center inlet for every 12 inches of griddle width. Each burner is rated for 27,500 BTU/hr. Disconnect the electrical power and follow lock

ページ16に含まれる内容の要旨

2. Reach through the back of the unit. Squeeze the burner retaining clip and slide off burner retaining pin. 3. Lift the burner up so the retaining pin clears the corresponding hole in the chassis, then pull the burner out through the back of the unit. 4. Replace by inserting the burner through the rear of the unit and engaging the burner venturi onto the burner orifice at the front of the unit. 5. Seat the retaining pin in the hole in the chassis and attach the retaining clip. 6. Remov

ページ17に含まれる内容の要旨

GAS REGULATOR The RRG series units must have an exterior machine gas regulator installed. The units are shipped with a regulator that has a vent limiter. These regulators must be VENT LIMITER installed as close as possible to the unit in a ADJUSTMENT horizontal, upright position for optimal COVER performance. They are adjusted by removing the adjustment cover – then by turning the adjustment screw clockwise to increase and counter clockwise to decrease. The regul

ページ18に含まれる内容の要旨

12. Turn power switch and gas supply back on. All gas joints disturbed during servicing must be checked for leaks. Check with a soap and water solution. Do not use an open flame. PRESSURE TAP AT #1 BURNER SEQUENCE OF OPERATION Operation is the same for all size griddles. The neutral wire from the power source is directly connected to each thermostat and each safety ignition module. 1. The power on/off switch is set to

ページ19に含まれる内容の要旨

WIRING DIAGRAMS WIRING DIAGRAM – 24-INCH GRIDDLE - 19 -

ページ20に含まれる内容の要旨

WIRING DIAGRAM – 36-INCH GRIDDLE - 20 -


類似の説明書
# 取扱説明書 カテゴリ ダウンロード
1 Vulcan-Hart AGM48 取扱説明書 オーブンプレート 1
2 Vulcan-Hart AGM60 取扱説明書 オーブンプレート 0
3 Vulcan-Hart AGM72 取扱説明書 オーブンプレート 0
4 Vulcan-Hart E48L 取扱説明書 オーブンプレート 0
5 Vulcan-Hart E36L 取扱説明書 オーブンプレート 1
6 Vulcan-Hart E24L 取扱説明書 オーブンプレート 4
7 Vulcan-Hart E60L 取扱説明書 オーブンプレート 0
8 Vulcan-Hart MGG24 取扱説明書 オーブンプレート 15
9 Vulcan-Hart ML-135309-924RX 取扱説明書 オーブンプレート 0
10 Vulcan-Hart ML-135310-936RX 取扱説明書 オーブンプレート 3
11 Vulcan-Hart ML-135311-948RX 取扱説明書 オーブンプレート 0
12 Vulcan-Hart ML-135312-960RX 取扱説明書 オーブンプレート 0
13 Vulcan-Hart ML-135313-972RX 取扱説明書 オーブンプレート 0
14 Vulcan-Hart ML-135339-00024 取扱説明書 オーブンプレート 0
15 Vulcan-Hart ML-135341-00048 取扱説明書 オーブンプレート 0
16 Anetsberger Brothers A24X48GC 取扱説明書 オーブンプレート 1
17 APW Wyott 1848 取扱説明書 オーブンプレート 1
18 APW Wyott EGD-1824 取扱説明書 オーブンプレート 2
19 APW Wyott GGM-36H 取扱説明書 オーブンプレート 3
20 APW Wyott 2472 取扱説明書 オーブンプレート 1