ページ1に含まれる内容の要旨
COLLECTION
OWNER'S MANUAL
pedicure
by
spas
ページ2に含まれる内容の要旨
Owner’s Manual Standard Whirlpool Jet SANIJET® Pipeless (Optional) PETRA 700 PETRA 700-S* PETRA 500 PETRA 500-S PETRA 450 PETRA 450-S PETRA 350R** or V*** PETRA 350R** or V***-S PETRA 300 PETRA 300-S S*=SANIJET® Pipeless R**=Roller Massage V***=Vibration Massage Table of Contents Introduction & Safety Standards 3 Important Considerations 4 Identifying Parts & Description (For Petra 700 & 500) 5 Massage System (For Petra 450, 350R, 350V & 300) 6 Chair Asse
ページ3に含まれる内容の要旨
Introduction Thank you for purchasing the PETRA Whirlpool Pedicure Spa. This finest Whirlpool Pedicure Spa has been developed by J&A USA, Inc. to operate dependably for many years when used properly. Please take time to read this entire manual thoroughly before installation and use. PLEASE READ AND FOLLOW INSTRUCTIONS CAREFULLY! Important Precautions J&A USA requires that you contact your local, qualified electrician and plumber to install your PETRA Whirlpool Pedicure Spa. It can
ページ4に含まれる内容の要旨
Important Considerations Please read the following instructions thoroughly Inspection Please take time to inspect each pedicure spa shipment thoroughly for damages immediately upon delivery. If damages are found, it is very important to notify the freight driver and indicate extent of the damages on the bill of lading. If you fail to do so, J&A USA will not be responsible for the damages and may not be able to make appropriate claims to the freight carrier. Any damage claims must be fil
ページ5に含まれる内容の要旨
PETRA 700& 500 IDENTIFYING PARTS 20 19 A 1 STOP FORWARD BACKWARD B KNEAD TAP 15 UP DOWN AUTO 2 CONTINUE/REPEAT THIGHMASSAGE UP 3 MASSAGEWHEELS DOWN J&A 4 5 16 6 7 8 17 9 10 11 18 12 13 14 Standard Whirlpool Jet SANIJET-Pipeless PARTS 1- PILLOW COVER 11- SANIJET PUMP IMPELLER 2- BACK REST 12- OVERFLOW WASTE KNOB 3- ARM REST 13- POP-UP DRAIN STOPPER 4- MATCHING ARM TRAY (OPTIONAL) 14- LIGHT COVER 5- SEAT CUSHION 15- BACK PANEL 6- SHOWER SPRAYER 16- ARM REST LEVER 7- ADJUSTABLE FOOT CUSHION 17- BAS
ページ6に含まれる内容の要旨
PETRA 450, 350R, 350V& 300 MASSAGE SYSTEM PETRA 450 PETRA 300 Pacific spa & JA J&A USA Inc. VIBRATION VIBRATION TRANSFORMER TRANSFORMER MODEL:GRA 1215 MODEL: GRA 1215 INPUT: AC 120V, 60Hz INPUT: AC 120V, 60Hz OUTPUT: DC 12V, 1.5A OUTPUT: DC 12V, 1.5A PETRA 350V PETRA 350R TIMER ROLLER HEC BACK VIB WAIST SEAT SPD SEL AUTO Pacific ByJ&AUSA Spa ROLLER MASSAGE & VIBRATION VIBRATION TRANSFORMER TRANSFORMER MODEL: AD-57241200 MODEL: MKD-57121500 INPUT: 120V, AC 60Hz INPUT: 120V, AC 60Hz OUTPUT: 24V, D
ページ7に含まれる内容の要旨
PETRA 700& 500 SERIES CHAIR ASSEMBLY PETRA 700 IMPORTANT ASSEMBLY INSTALLATION STOP KNEAD TAP AUTO A PRIOR TO USE CONTINUE/REPEAT FORWARD BACKWARD 8 B THIGHMASSAGE UP UP DOWN MASSAGEWHEELS DOWN J&A BEFORE ASSEMBLY AFTER ASSEMBLY HOT 8 COLD 4 1 3 2 5 7 6 1) LIGHT BOX POWER CORD CHAIR ASSEMBLY FOR PETRA 700& 500 SERIES 2) SLIDER/ RECLINER POWER CORD 3) SANIJET CONTROL BOX POWER CORD 4) CHAIR MASSAGE POWER CORD 1) REMOVE HITCH PIN AND CLEVIS PIN FROM RECLINING PISTON 5) HITCH PIN CLIP 2) LIFT THE C
ページ8に含まれる内容の要旨
PETRA Chair Assembly for 450, 350R, 350V, 300 Rear View PETRA 300 PETRA 350R& 350V PETRA 450 CHANNEL FRAME HOT HOT HOT COLD COLD COLD 1) REMOVE THE LOCK NUT FROM THE BOLTS 2) ALIGN FOUR BOLTS WITH FOUR HOLES ON THE CHANNEL FRAME 3) TIGHTEN EACH LOCK NUTS TO SECURE THE CHAIR TO THE BASE Bolt Channel Frame Washer Lock Nut 8
ページ9に含まれる内容の要旨
PETRA COLLECTION SPECIFICATIONS PETRA 700& 500 55 25 18 19 18 2.5 8 3/4 43 6 3/4 27 28 24 57 41 HOT& COLD 0.5 inches Fittings included WALL PETRA 450, 350R, 350V& 300 48 24 17 18 17 1.5 8 3/4 43 6 3/4 27 28 24 57 44 HOT& COLD 0.5 inches Fittings included Petra Collection Specifications Capacity All Petra Series 5 gallons Power Source SaniJet 115v, 60Hz Whirlpool Pump 0.5HP, 115VAC, 5.5 Amp, 60Hz (GFCI protected) Plumbing Source Hot& Cold Water Hot& Cold Water 0.5 inches (Fitting Included) Drain
ページ10に含まれる内容の要旨
Plumbing Connections All plumbing connections should be made by a qualified, licensed plumber in accordance with local plumbing and building codes. Hot and Cold Water Supply Lines Connect 1/2” ID supply tubes to a fresh water source. Shut-off valves should be utilized. Electrical Connections The Foot spa must be plugged into a GFCI protected outlet, installed by a licensed electrician. Testing the Foot spa Clean the tub and fill with water to the wave-mark (water level) on the wall o
ページ11に含まれる内容の要旨
FOR SANIJET® -PIPELESS SYSTEM USERS ONLY Maintenance Keep the screen of the jet inlet free of debris, any blockage of the screen reduces the whirlpool action and may cause damage to the jet motor. Cleaning Pipeless Jet System Remove the jet assembly from its casing: Rotate the jet assembly counterclockwise and pull outward. Remove the impeller cap: rotate the impeller cap clockwise (OFF) and life outward. Remove impeller. Clean the components. After each jet is disassembled, the jet
ページ12に含まれる内容の要旨
Caution To reduce the potential risk of fire, electrical shock, or injury to persons: 1) All electrical wiring (both installation & repair) must be done by a licensed electrician and in accordance with local and state ordinances. 2) No modifications, additions or deletions should be made to the pump, without factory approval. 3) Before stating motor, fill up the tub with water to level recommended by whirlpool manufacturer. Never run pump dry! 4) Do not relocate pump without prior approv
ページ13に含まれる内容の要旨
FOR STANDARD WHIRLPOOL SYSTEM USERS ONLY Maintenance Keep the screen of the suction inlet free of debris, any blockage of the screen reduces the whirlpool action and may cause damage to the whirlpool pump motor. Cleaning/ Flushing the inner whirlpool system Fill up with warm water up to proper level. Apply 3 tsp of low foaming dish washing detergent, 1 tsp of the regular bleach into the tub. Start the whirlpool for 5 min and let it still for 5 min and run again for two minutes. Drain
ページ14に含まれる内容の要旨
CAUTION To reduce the potential risk of fire, electrical shock, or injury to persons: 1) All electrical wiring (both installation & repair) must be done by a licensed electrician and in accordance with local and state ordinances. 2) No modifications, additions or deletions should be made to the pump, without factory approval. 3) Before starting motor, fill tub with water to level recommended by whirlpool manufacturer. Never run pump dry! 4) Motors have a built-in automatic reset over load prot
ページ15に含まれる内容の要旨
(Optional) Discharge Pump Installation POWER CORD ON/OFF DISCHARGE SWITCH MUST BE PLACED HIGHER THAN WATER LEVEL CONVERTER BOX Outlet WATER LEVEL AIR TUBING Check Valve must be installed to prevent back flow Tub B A AIR VENT HOSE ATTACHMENT PIPE Main Drain Pipe L-TRAP DISCHARGE PUMP - Outlet from drain pump must be placed on top of the main drain pipe To prevent the possible air lock,B has to higher thanA - Do not use flexible pipe for drain FAQ 1) Pump hums but does not drain the water out - Ai
ページ16に含まれる内容の要旨
Lubrication 1) Turn off the main power 1) Open the screws (phillip+) or Open the zippers from the front of the chair 2) Apply lubrication onto circled area Caution Do not apply lubrication on dc-belt BACK VIEW FRONT VIEW REMOVE SCREWS (PHILLIP) TO OPEN THE PANEL UPPER SENSOR DC-PULLEY GEAR PULLEY DC-BELT IMPORTANT!!! DC-MOTOR LUBRICATE ON CIRCLED AREA GEAR BOX MACHINERY OIL RECOMMENDED OIL RESERVOIR LOWER SENSOR MAIN SHAFT MAIN ON/OPF POWER SWITCH FUSE TRANSFORMER AC MOTOR PCB BOARD MAIN SHAFT Z
ページ17に含まれる内容の要旨
J&A USA, INC. LIMITED WARRANTY STATEMENT J&A Product: EPISODE, PETRA, TOEPIA, CLEO, PACIFIC SPA J&A Accessories: Epi-Stool, Tri-Stool, __________ Duration of limited warranty: 1 year from date of purchase Coverage on limited warranty: Parts & Labor EXTENT OF LIMITED WARRANTY J&A USA warrants that the J&A product and/or accessories specified above will be free from defects in materials and workmanship for the duration specified above. Which duration begins on the date of purchase by the
ページ18に含まれる内容の要旨
MULTI-COLOR LED SPA LIGHT (Instruction for LED Bulb replacement) WARNING: Rick of electric shock!!!, Drain spa and disconnect power before attempting to open lens. Multicolor LED spa lights allows the replacement of the lamp from the front. It comes complete with a plastic insert tool for tightening, or un-tightening. NOTE: To change a bulb after installation, follow the instruction engraved on the lamp replacement too. Insert the two tabs of the insert tool into the two notches
ページ19に含まれる内容の要旨
QMTX.E242637 Plumbing Accessories See General Information for Plumbing Accessories J & A USA INC E242637 200 RODEO DR EDGEWOOD, NY 11717 USA Whirlpool pedicure spas, Models PS300, PS650LX, Episode, Episode-S Type, Toepia EM, Cleo, Petra. Last Updated on 2004-10-19 This page and all contents are Copyright © 2005 by Underwriters Laboratories Inc.® The appearance of a company's name or product in this database does not in itself assure that products so identified have been manufac
