ページ1に含まれる内容の要旨
Outdoor Patio Heater
Model # LIP-10A-TGG-LPG-SP
Item # 60788,60368,60485, 60786
ATTACH YOUR RECEIPT HERE
Serial Number ___________ Purchase Date ______
Questions, problems, missing parts? Before returning to your
retailer, call our customer service hotline at 1-866-985-7877,
9 a.m. – 6 p.m., EST, Monday – Friday or email at
cservice@welltraveled.net.
- 1 -
ページ2に含まれる内容の要旨
PACKAGE CONTENTS PART DESCRIPTION QTY 4 pcs (packed A Reflector Panel in 2 inner ctns) B Reflector Center Cap 1 1 (packed in 1 C Head Assembly inner ctn) D Tank Housing 1 1 (attached to E Gas Hose Head Assembly) F Upper Post 1 1 (packed with G Regulator Head Assembly) H Lower Post 1 3 (packed in 1 I Post Supports inner ctn) J Base 1 2 (packed with K Wheels Head Assembly)
ページ3に含まれる内容の要旨
HARDWARE CONTENTS SAFETY INFORMATION SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install this appliance. If you have any questions regarding the product, please call customer service 1-866-985-7877, 9 a.m. – 6 p.m., EST, Monday – Friday. This manual contains important information about the assembly, operation and maintenance of this patio heater. General safety informatio
ページ4に含まれる内容の要旨
SAFETY INFORMATION - 4 -
ページ5に含まれる内容の要旨
SAFETY INFORMATION ASSEMBLY PREPARATION Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents list and hardware contents as listed on pages 2 and 3 of this manual. If any part is missing or damaged, do not attempt to assemble this product. Contact customer service for replacement parts. ESTIMATED ASSEMBLY TIME: 60 minutes Tools Required for
ページ6に含まれる内容の要旨
ASSEMBLY 1 1. Attach Wheels (K) to Base (J). Align holes in Wheel bracket with corresponding holes in Base, and insert 3 M6x16 (BB) bolts through holes and finger tighten. Repeat with second wheel. Tighten with wrench once both wheels have been attached. Hardware Used: 6 x BB, Bolt M6x16 2. Attach the Post Supports (I) to the Base (J). Align the holes in the 2 bottom of each Post Support with the hole on the Base. Insert 1 M8x16 (AA) bolt through the hol
ページ7に含まれる内容の要旨
ASSEMBLY 4. Attach Upper Post (F) to Lower Post (H) by screwing the two pieces of the post 4 together. 5 5. Place Tank Housing (D) onto Base (J). Slide Tank Housing (D) over the assembled Upper/Lower Post and down over the Post Supports. Rest Tank Housing on Base. 6 6. Attach Head Assembly (C) to Upper Post (F). Note: There is a small piece of protective foam located in the neck of the Head Assembly that MUST b
ページ8に含まれる内容の要旨
ASSEMBLY 7. Assemble Reflector Panels (A) with Reflector Center Cap (B).Reflector 7 Panels (A) come packaged in two brown boxes with two panels in each box. Hardware for assembly is already affixed to each panel. Place two panels side by side and remove the two cap nuts and washers that are affixed to one panel. Insert the affixed bolts into the open holes on the adjacent panel. Place the washer over the bolt and screw on cap nut. Repeat these steps until all four panels ar
ページ9に含まれる内容の要旨
ASSEMBLY A minimum supply pressure of .5 psi is required for the purpose of input adjustment of propane gas. Storage of an appliance indoors is permissible only if the cylinder is disconnected and removed from the appliance. A cylinder must be stored outdoors in a well-ventilated area out of the reach of children. A disconnected cylinder must have dust caps tightly installed and must not be stored in a building, garage, or any other enclosed area. The minimum permissible gas supply pr
ページ10に含まれる内容の要旨
OPERATING INSTRUCTIONS 3. If leak is detected at regulator/cylinder valve connection, disconnect, reconnect, and perform another leak check. If you continue to see bubbles after several attempts, cylinder valve is defective. Call our customer service hotline at 1-866-985-7877, 9 a.m. – 6 p.m., EST, Monday – Friday IF NO BUBBLES APPEAR AT ANY CONNECTION, THE CONNECTIONS ARE SECURE. Note: Whenever gas connections are loosened or removed, you must perform a complete leak check.
ページ11に含まれる内容の要旨
OPERATING INSTRUCTIONS When Heater is ON: Emitter screen will become bright red due to intense heat. The color is more visible at night. Burner will display tongues of blue and yellow flame. These flames should not be yellow or produce thick black smoke, indicating an obstruction of airflow through the burners. The flame should be blue with straight yellow tops. If excessive yellow flame is detected, turn off heater and consult “Troubleshooting” on page 13. Re-Lightin
ページ12に含まれる内容の要旨
OPERATING INSTRUCTIONS After Operation: 1. Gas control knob is in OFF position. 2. Gas tank valve is OFF. 3. Disconnect gas line. CARE AND MAINTENANCE To enjoy years of outstanding performance from your heater, make sure you perform the following maintenance activities on a regular basis: Keep exterior surfaces clean. 1. Use soapy water for cleaning. Never use flammable or corrosive cleaning agents. 2. While cleaning yo
ページ13に含まれる内容の要旨
TROUBLESHOOTING If you have any questions regarding this product, please call our customer service hotline at 1-888-985-7877, 9a.m. – 6 p.m. (EST), Monday – Friday, or email us at cservice@welltraveled.net. PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Gas valve may be off Turn gas valve ON Fuel tank may be empty Refill LPG tank Orifice blocked Clean or replace orifice Purge air from lines. Open gas Air in supply system lines and depress control knob for 2-3 mins.
ページ14に含まれる内容の要旨
Distributed By: Web: www.wtliving.com Well Traveled Living th Email: cservice@welltraveled.net 716 S 8 Street Amelia Island, FL 32034 Toll Free: 866-WTL-SUPP (866-985-7877) 1 YEAR LIMITED WARRANTY – Customers in the Continental US All components are warranted for a period of 1 year after date of purchase by the original owner against defects in materials and workmanship under normal use. This warranty does NOT cover normal wear and weathering, assembly and/or
