ページ1に含まれる内容の要旨
LSX Low Smoke Converter
Operator’s Manual
www.ultratecfx.com
VER. 30.10.10
ページ2に含まれる内容の要旨
Table of Contents Introduction ................................................................................ 3 Warning ...................................................................................... 3 Important Safety Instructions: ................................................... 3 Safety Precautions ..................................................................... 3 Technical Specifications ............................................................. 4 Technical Drawings .....
ページ3に含まれる内容の要旨
Introduction Congratulations on your purchase of a Ultratec Special Effects LSX MKII Low Smoke Convertor. With basic care, your LSX will provide years of trouble-free performance. The LSX is a product of many years of research and development resulting in a machine with many fine features and exceptional reliability. This manual contains detailed information on the operation of your LSX. Please take a few moments to read it over carefully before use, and keep it handy for your reference. Warn
ページ4に含まれる内容の要旨
Technical Specifications Model: LSX Low Smoke Converter Part Number: CLF 2930 - 120 volt CLF 2915 - 240 volt Length: 59in 150cm Width: 29.5in 75cm Height: 28in 71cm Net Weight: 150lbs 68kg Power Rating: 120 Volt A.C. 50/60 Hz. 12 Amps. 240 Volt A.C. 50/60 Hz. 6 Amps. Fluid: Ultratec Special Effects Water Base Fog Fluid Technical Drawings www.ultratecfx.com 4
ページ5に含まれる内容の要旨
Operating Procedure 1. During use this machine generates condensation. After use the LSX should be drained via the drain valve. CAUTION: This may cause the floor to become very slippery. This may also inhibit the performance of the LSX unit. 2. This unit requires a 15 amp circuit to run properly. The use of any extension cords or shared circuit is strongly not recommended. 3. It is essential that Ultratec Special Effects’s Genuine Molecular Fluid is used in the Fog Machine to achieve optimum
ページ6に含まれる内容の要旨
Before Requesting Service If LSX will not Power Up Check Power source and connections Green ‘LED’ is not illuminated & Red ‘LED’ is Low Pressure Switch has tripped, allow for Auto Reset illuminated Low Pressure Switch will not Auto Rest. Red ‘LED’ Low Refridgerant Charge (Contact Local Dealer) remains illuminated Fog will not remain on ground 1. Ensure the use of Ultratec Special Effects Fluid 2. Check digital temperature display reading for coil temperature 3. Check Green and Red ‘LED’ see abo
ページ7に含まれる内容の要旨
Warranty Warranty: All warranty is for one year parts and labour unless specified or manufacturer defect only. Abuse or Poor Maintenance will not be covered under warranty. Ultratec Special Effects Fluids must always be used. Use of any non Ultratec Special Effects Fluids will void all warranties. Accept no substitutions as there are no exceptions to this rule. Proof of Purchase or Proof of Sale must always accompany any warranty returns. An RA (return authorization) number must be noted on
