ページ1に含まれる内容の要旨
TEAM PRODUCTS INTERNATIONAL INC. Limited Warranty
WhAT IS COvERED : Any defect in materials and workmanship.
FOR hOW LONg : 2 years from date of purchase.
WhAT WE WILL DO : If your product is defective and returned within 30 days
after the date it was purchased, we will replace it at no charge to you. If
returned after 30 days but within 2 years of the date of purchase we will
repair it or, at our option, replace it at no charge to you.
If we repair your product, we may use new or recondition
ページ2に含まれる内容の要旨
Models: PMD8137 PMD8142 Owner’s Manual PMD8143
ページ3に含まれる内容の要旨
Models: PMD8137 PMD8142 Owner’s Manual PMD8143 Welcome 15. Remove adjustment keys and wrenches. Form a habit to make sure thatt the adjustment keys and wrenches are removed from the tools before This COLEMAN® product has been carefully engineered and manufactured to turning them ON. give you dependable operation. Please read this manual thoroughly before operating your new COLEMAN® product, as it contains the information you 16. Stay alert. To avoid injury pay attention to the work you are
ページ4に含まれる内容の要旨
Models: PMD8137 PMD8142 Owner’s Manual PMD8143 Controls and Components: Recommended size of Extension Cord for Battery Charger Battery and AC Charger Length of Cord (Feet) 25 50 100 150 1. Battery with Release Buttons On Each Side (PMD8137 comes with 2 batteries) 2. 1 Hour “Quick Charge” Charging Stand with LED Charging Indicators AWG Size of Cord* 18 18 16 14 Drill: 3. 3/8” Jacobs K
ページ5に含まれる内容の要旨
Models: PMD8137 PMD8142 Owner’s Manual PMD8143 Twist the 24 setting torque control ring to the desired setting. Lower settings are The battery should be recharged when the drill does not operate up to its better for light work such as driving screws into soft materials. Higher settings normal performance level. Do not continue to operate the drill in this depleted are recommended for drilling into harder surfaces. capacity. Recharge the battery immediately. When properly adjusted, the cl
ページ6に含まれる内容の要旨
Models: PMD8137 PMD8142 Owner’s Manual PMD8143 Maintenance Clean the drill regularly. Before cleaning, remove the battery pack and any accessories (bits etc.). To clean, use ONLY a mild soap and damp cloth on the housing. Never immerse drill in any kind of fluid. Do not use any solvents or harsh abrasives on the drill housing as this may cause damage to the unit. Always keep the ventilation openings clear. NOTE: All bearings in these tools are lubricated with a sufficient amount of high
