ページ1に含まれる内容の要旨
INSTRUCTIONS
®
FOR INDOOR USE ONLY.
ADULT SUPERVISION RECOMMENDED!
TM
TO GET THE MOST OUT OF
YOUR ZERO GRAVITY MICRO™
WALL RACER PLEASE READ THESE
INSTRUCTIONS FIRST!
NOTE:
USE ON SMOOTH, CLEAN
Controller/Charger
SURFACES ONLY!
Check to make sure contents are
complete:
Zero Gravity Micro™
• 1 Zero Gravity Micro™ Wall Racer
Wall Racer
• 1 Controller/Charger
• 1 Instruction Sheet
CHARGING YOUR ZERO GRAVITY MICRO™ WALL RACER
INSTALL BATTERIES
CLOSE OPEN
1. Switch 2. Switch 3. Take
Battery
car to co
ページ2に含まれる内容の要旨
WHILE DRIVING YOUR ZERO GRAVITY MICRO™ WALL RACER, MAKE SURE TO FOLLOW THESE RULES Stand at least 4’ from the wall. Do not drive to or off the edge of the wall. Only drive on smooth, clean, dry surfaces. Make sure walls are clear of obstacles, including hanging pictures, light switches, etc... The Zero Gravity Do not drive on uneven, Micro™ Wall Racer has porous, or broken surfaces, as vehicle working headlights. will not adhere and can fall off. IMPORTANT: When the headlights begin to blink, th
ページ3に含まれる内容の要旨
DRIVING ON WALLS OR UPSIDE DOWN To drive on walls upside down you must put the vehicle in the WALL mode. NOTE: Avoid driving overhead when other people are around. Do not stand underneath when driving overhead. DRIVING ON THE GROUND The fabric air skirts can be adjusted outward at a 45° angle to ensure a proper wall suction. To drive on the ground you must put the vehicle in the IMPORTANT: The Zero Gravity Micro™ should only be GROUND mode. driven on a smooth, clean, flat surface. Dirt or debris
ページ4に含まれる内容の要旨
SPINS By pushing the joystick on the controller/charger, you can make your Wall Racer spin around on the spot. RIGHT SPIN LEFT SPIN Push the RIGHT joystick to the right to Push the RIGHT joystick to the left make make the vehicle spin clockwise. the vehicle spin counter-clockwise. TROUBLESHOOTING PROBLEM SOLUTION Vehicle will not run. 1. Power switch is off. Turn on. 2. Controller battery is installed with incorrect polarity. Check the (+) and (-) markings to make sure the battery is properly al
