Snapper 1691827の取扱説明書

ページ1に含まれる内容の要旨

INSTALLATION
INSTRUCTIONS : ~~,
SNOWTHROWER HEADLIGHT KIT
MFG. NO. 1691827
I
Section C. Compact Snowthrower With Sofi Cab/
Section A. General
Without Cab.
This kit provides an add-on light and required
alternator for compact and large frame 1. Drill a 13/&Y hole, 5/8” from bottom and
centered (approx. 8-i/2” from either end) on the
snowthrowers with Tecumseh engines. Kit can be
crossmember as shown in figure 2.
installed on snowthrowers that are equipped with
cabs (hard or soft). See the appropr

ページ2に含まれる内容の要旨

Section D. Large Frame Snowthrower With Soft- Section E. Large Frame Snowthrower With Hard : Cab/ No Cab. Cab. 1. Drill 13/32” hole in right-hand side channel, 3” NOTE below auger drive handle and centered (approx. Hard cab should be installed first before i-3/4”), as shown in figure 4. _~~~ --.- -._~~~~.. ---~ .--- installing light kit. 1. Drill 13/32” hole in the right hand side of thecab frame, approx. 3/4” down and l-1/2” from ------l capscrew, as shown in figure 6. 2. Install light through