ページ1に含まれる内容の要旨
OWNER’S MANUAL
Read and understand this entire manual BEFORE riding!
For assistance contact Razor. DO NOT RETURN TO STORE.
NOTE: Manual illustrations are for demonstration purposes only. Illustrations
may not refl ect exact appearance of actual product. Specifi cations subject to
change without notice.
Please have your product and 19 digit product I.D. code ready before
contacting Razor for warranty assistance and/or replacement parts.
Product I.D. Code: _____________ - ____________ - _________
ページ2に含まれる内容の要旨
CONTENTS Safety Warnings ............................................................ 1 Troubleshooting Guide ................................................ 8-9 Before You Begin ........................................................... 2 EcoSmart Metro Scooter Parts.................................... 11 Assembly and Set-Up ................................................. 3-4 Safety Reminders ........................................................ 12 Repair and Maintenance ..............
ページ3に含まれる内容の要旨
BEFORE YOU BEGIN Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during WARNING: shipping. Because the EcoSmart Metro electric scooter was 95 percent assembled and packed at the factory, there DO NOT USE NON-RAZOR should not be any problems, even if the box has a few scars or dents. PRODUCTS WITH YOUR ECOSMART METRO
ページ4に含まれる内容の要旨
ASSEMBLY AND SET-UP q Attaching the Front Wheel A B B A 3 Insert the tab on the safety 1 Remove the packing material 2 Remove axle nuts (A) from the from the front fork. axle bolt and insert the wheel into washer (B) into the hole on the front fork and tighten axle nuts the front fork. Safety washers should face outside of the fork. using two 15mm open wrenches. q Attaching the Handlebar WARNING: Failure to properly tighten the collar bolts may allow the handlebars to dislodge wh
ページ5に含まれる内容の要旨
3 ASSEMBLY AND SET-UP q Attaching the Basket 1 2 WARNING: 2 1 Do not exceed weight limit of 11lbs (5kg) on luggage rack. WARNING: The carrier should not be used to carry people or pets. 1 Slide the basket hooks (1) under 2 Align the hole in the basket (2) 3 Insert the washer and bolt into the bar located on the luggage rack. with the hole on the luggage rack (1). the hole in the basket and through the bracket on the luggage rack. Using a 5mm Allen wrench, tighten the bolt
ページ6に含まれる内容の要旨
REPAIR AND MAINTENANCE q Charging the Battery WARNING: Always Your electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery prior to use. disconnect your EcoSmart Metro electric scooter from the charger • Initial charge time: 12 hours extended period of time, the battery may reach a before cleaning. stage at which it will no longer hold a charge. • Recharge time: up to 12 hours, even if the light turns green. Recommended maximu
ページ7に含まれる内容の要旨
REPAIR AND MAINTENANCE qChecking Spoke Tension Spoke WARNING: Flange Regularly check the spoke Hub tension and retighten the Flange Spoke spokes whenever loose. If you have any doubt, ask an Spoke experienced motorcycle or Flange bicycle mechanic to inspect Rim your spokes to determine if Nipple Nipple the spokes need tightening or adjusting. 1 Verify spoke tension by grasping and shaking each spoke. Spoke should not be loose from hub. Look for any play between spoke flanges whe
ページ8に含まれる内容の要旨
SB 1918 (CALIFORNIA) DECLARA TION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC RIDE-ON PRODUCT. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT. 7
ページ9に含まれる内容の要旨
TROUBLESHOOTING GUIDE Problem Possible Cause Solution Scooter does not run Undercharged battery Charge the battery. A new battery should have been charged for at least 12 hours before using the scooter for the first time and up to 12 hours after each subsequent use. Check all connectors. Make sure the charger connector is tightly plugged into the charging port and that the charger is plugged into the wall. Make sure power flow to the wall outlet is on. Charger is not working You may check to see
ページ10に含まれる内容の要旨
TROUBLESHOOTING GUIDE Problem Possible Cause Solution Sometimes the scooter Loose wires or connectors Check all wires around the motor and all connectors to make sure they are doesn’t run, but other times tight. it does Motor or electrical switch damage Contact your local Razor authorized service center for diagnosis and repair. Charger gets warm during Normal response to charger use No action required. This is normal for some chargers and is no cause for use concern. If your charger does not
ページ11に含まれる内容の要旨
ECOSMART METRO PARTS Keep your EcoSmart Metro electric scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part avail- ability. (Specifications subject to change without notice.) 1. Handle grip 9. Front fork 16. On/Off switch 24. Motor (36v 500w) 2. Throttle 10. Nut 17. Charger port 25. Clamp 3. Handlebar 11. Socket head cap screws 18. Kick stand 26. Seatpost 4. Brake lever (left) 12. Front wheel complete 19. Control module 27. Luggage
ページ12に含まれる内容の要旨
SAFETY REMINDERS PRE-RIDE CHECKLIST Loose Parts Tire Inflation Check and secure all fasteners before every ride. Make sure Periodically inspect the tires for excess wear and regularly check q q steering stem clamp bolts are locked properly in place. There the tire pressure and re-inflate as necessary. If you get a flat tire, should not be any unusual rattles or sounds from loose parts the inner tube can be patched or a new tube can be purchased or broken components. If you are not sure, ask an
