ページ1に含まれる内容の要旨
The Princess Insert
By
Blaze King
Model
PI 1010A
Insert
Solid Fuel Heater
Residential
Approved
READ THIS MANUAL PRIOR TO INSTALLATION OR OPERATION OF THIS APPLIANCE.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Not intended for mobile home installation.
LISTED BY:
In Canada In USA
Valley Comfort Systems
ページ2に含まれる内容の要旨
Approval Label PRINCESS INSERT S/N - LISTED SOLID FUEL BURNING FIREPLACE INSERT MODEL: PI/1010A Tested to: Report No. 142-S-05-2 UL 1482 / ULC S628 CERTIFIED IN BOTH UNITED STATES AND CANADA EPA Cert. No. 586 PREVENT HOUSE FIRES- Install and use only in accordance with Blaze King’s installation and operation instructions. Install and use in a code complying fireplace only. Stainless steel flue liner is required in Canada B and recommended in the Unit
ページ3に含まれる内容の要旨
To Our Valued Customers Dear Customer: Thank you for purchasing the Princess wood burning insert (hereafter referred to as "stove"). This owner's manual explains the steps required to safely assemble, install, operate, and maintain your new stove. Be a responsible stove owner; PLEASE CAREFULLY READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE YOUR NEW STOVE. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY, OR EVEN DEATH. Obtain permits from
ページ4に含まれる内容の要旨
Safety Notice IF THIS BLAZE KING STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THE INSTALLATION INSTRUCTIONS. CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION REQUIREMENTS IN YOUR AREA. THIS INSERT IS SUITABLE FOR INSTALLATION IN EITHER: - A FACTORY BUILT FIREPLACE LISTED TO UL 127 OR ULC S620. - A CODE-APPROVED MASONRY CHIMNEY WITH A FLUE LINER. MANDATORY in CANADA, Recommended in USA
ページ5に含まれる内容の要旨
Table Of Contents KEEP THIS MANUAL FOR FUTURE REFERENCE. Section _____________________________________________________________________________________ Page APPROVAL LABEL ....................................................................................................................................................... 2 VALUED CUSTOMER ................................................................................................................................................... 3 SAFE
ページ6に含まれる内容の要旨
Table Of Contents Assembly - General ...............................................................................................................................................18 - 20 Installation into Factory Built Fireplaces ........................................................................................................................ 20 Installation - Chimney .......................................................................................................................
ページ7に含まれる内容の要旨
Warranty BLAZE KING LIMITED WOODSTOVE WARRANTY - Princess Insert Blaze King's warranty policy only applies to units sold in the USA or CANADA WHAT THE WARRANTY COVERS: This warranty contains different terms which cover different parts of the stove. BLAZE KING warrants the STEEL COMPONENTS of this BLAZE KING stove, which is delivered with this warranty, against defects in material or workmanship to you, the original retail purchaser (hereafter referred to as purchaser), for a period of up t
ページ8に含まれる内容の要旨
Definitions BUILDING CODES AND PERMITS Most areas require a permit from the city or county Building Inspector, Fire Marshal or Authority Having Jurisdic- tion. Check local building codes before beginning installation. After the installation is completed, it should be checked by your local Fire Marshal or Building Inspector. BYPASS All catalytic wood burning stoves have a bypass device for allowing the smoke from the fire to temporarily by- pass, or go around, the catalyst. In Blaze King m
ページ9に含まれる内容の要旨
Definitions COMBUSTION AIR INTAKE Located on the front right of the stove. Combustion air is drawn into this opening, through the thermostat and into the firebox. In tight contemporary homes, using outside combustion air may be desirable. CREOSOTE - FORMATION AND NEED FOR REMOVAL When wood is burned slowly, it produces tar and other organic vapors which combine with expelled moisture to form creosote. The creosote vapors condense in the relatively cool chimney flue of a slow-burning fir
ページ10に含まれる内容の要旨
Definitions CAUTION DO NOT USE GASOLINE, GASOLINE-TYPE LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER FLUID OR SIMILAR LIQUIDS TO START OR -'FRESHEN UP" A FIRE IN THIS APPLIANCE. KEEP THESE FLAMMABLE LIQUIDS WELL AWAY FROM THIS APPLI- ANCE WHILE IT IS IN USE. FLUE The general term for a passage through which flue gases (smoke) pass from the combustion chamber to the outside air. FUEL THIS STOVE IS FOR USE WITH SOLID WOOD FUEL ONLY. Do not burn trash, paper, pine branches or artificial fire
ページ11に含まれる内容の要旨
Safety SAFETY NOTICE IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. FOR YOUR SAFETY, FOL- LOW THE INSTALLATION DIRECTIONS. CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RE- STRICTIONS AND INSTALLATION REQUIREMENTS IN YOUR AREA. PLEASE READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE YOUR NEW STOVE. FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY OR DEATH. CAUTIONS: NEVER vent the stove to other rooms of the building. Stove must be vente
ページ12に含まれる内容の要旨
Safety CHILDREN Do not allow children to play near the stove or with the controls. Severe burns may be inflicted by touching the door or door glass, the front, sides or top of the stove. Train children to stay away from the stove and never leave children unattended in the room when the stove is in operation. CHIMNEYS See "Definitions,” page 8. The use of makeshift chimney installation is not allowed'. Before connecting any wood-burning unit to an existing chimney, inspect the chimney to
ページ13に含まれる内容の要旨
Safety FUEL THIS WOODSTOVE IS FOR USE WITH SOLID WOOD FUEL ONLY. NEVER USE GASOLINE, GASOLINE- TYPE LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER FLUID OR SIMILAR LIQUIDS TO START OR 'FRESHEN UP' A FIRE IN THIS HEATER. KEEP ALL SUCH LIQUIDS WELL AWAY FROM THE HEATER WHILE IT IS IN USE. Do not burn materials soaked in flammable liquids, trash, garbage, plastics, gift wrappings, coal, charcoal, naph- tha, engine oil, chemical cleaners, chemical fire starters, treated or painted wood, saltwater d
ページ14に含まれる内容の要旨
Specifications Specification PI1010A Minimum heat output 6,200 Btu/hr Maximum heat output 38,500 Btu/hr Overall efficiency, weighted average Method, 81 1/2% Wood capacity (approximate) White oak
ページ15に含まれる内容の要旨
Preparation And Assembly WARNING IMPROPER ASSEMBLY AND/OR INSTALLATION OF YOUR BLAZE KING WOODSTOVE OR FAILURE TO OPERATE IT ACCORDING TO THE GUIDELINES DETAILED IN THESE INSTRUCTIONS, WILL VOID THE STOVE WARRANTY, CAN CAUSE A HOUSE OR CHIMNEY FIRE, AND MAY ENDANGER YOUR FAMILY. FOR YOUR SAFETY, FOLLOW THE ASSEMBLY AND INSTALLATION INSTRUCTIONS CAREFULLY. CON- TACT LOCAL BUILDING, FIRE OFFICIALS OR THE AUTHORITY HAVING JURISDICTION ABOUT RE- STRICTIONS AND INSTALLATION INSPECTION IN YOUR AR
ページ16に含まれる内容の要旨
Preparation And Assembly FLOOR PROTECTION A non-combustible floor protection is required for all installations extending 16" (in USA) or 18" (in Canada) in front of the door and extending 8" to either side of the door opening. In addition to the above requirement that portion of the insert which extends out in front of the fireplace hearth must have a minimum of 1" vertical distance to any combustible material Minimum Clearances To Combustibles (Measured from Insert/Stove Sides and Top)
ページ17に含まれる内容の要旨
Preparation And Assembly Princess PI1010A INSERT STOVE INSTALLATION PROCEDURE AFTER YOU READ AND FULLY UNDERSTAND THE MATERIAL IN THIS MANUAL, YOU ARE READY TO PROCEED WITH THE INSTALLATION OF YOUR STOVE. Before beginning the installation, thoroughly clean and inspect the fireplace and chimney you are using. Professional assistance is recommended, your local certified installer should be contacted to provide installation and inspection services. TOOLS NEEDED FOR INSTALLATION If yo
ページ18に含まれる内容の要旨
Assembly - General Assembly Instructions for Princess PI1010A Insert There will be local building and fire codes which could affect this installation. Be sure you check with your local building inspector, fire inspector or other local authorities having jurisdiction in your area before you begin instal- lation. This insert is certified only for installation into a masonry fireplace or factory built fireplace listed to UL 127 or ULC S620 which have been carefully inspected and are in good c
ページ19に含まれる内容の要旨
Assembly - General 3) Exact placement of the insert is determined by the overall shape of your fireplace opening and surround etc. First determine whether you will need leveling bolts installed or other devices to ensure a proper level instal- lation of the unit. This is determined by your fireplace construction. Sometimes the hearth is raised from the bottom of the fireplace and sometimes it is lower. Use only non-combustible material to fill any space under the insert (such as firebric
ページ20に含まれる内容の要旨
Assembly - General 8) Slide the completed unit into its final location. 9) Place the Convection deck on the top of the firebox and fasten to the shroud top using the 2 screws provided (see Fig. 7). Figure 7 10) Drop the catalytic thermometer in place on the top of the stove. The temperature probe inserts through the hole into the stove. 11) Connect the fan to a nearby AC plug outlet. NEVER run the AC fan cord under the fireplac
