ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
1 2 3 4 5 6 7 8 9 10 11 12
ページ3に含まれる内容の要旨
1 2
ページ4に含まれる内容の要旨
3 4
ページ5に含まれる内容の要旨
5 6
ページ6に含まれる内容の要旨
7 8
ページ7に含まれる内容の要旨
9 10
ページ8に含まれる内容の要旨
11 12
ページ9に含まれる内容の要旨
EnglisH 13 14 HQ914,HQ912
ページ10に含まれる内容の要旨
EnglisH - The shaver complies with the internationally approved EnglisH IEC safety regulations and can be safely cleaned under the tap (Fig. 1). introduction - Be careful with hot water. Always check if the water is Congratulations on your purchase and welcome to Philips! not too hot, to avoid burning your hands. To fully benefit from the support that Philips offers, register - This washable shaver is not suitable for shaving in the your product at www.philips.com/welcome. shower. - Do no
ページ11に含まれる内容の要旨
EnglisH EnglisH When the shaver is fully charged, it has a shaving time of up , The charging light goes on to indicate that the to 30 minutes. appliance is charging (Fig. 4). For optimal performance, only charge the shaver when the Note: Charge the shaver for at least 8 hours but not more battery is low. than 16 hours. Do not leave the appliance connected to the mains for 3 Remove the adapter from the wall socket and pull more than 16 hours. the appliance plug out of the shaver when the
ページ12に含まれる内容の要旨
EnglisH EnglisH 5 Clean the shaver after every use (see chapter After every use: shaving unit and hair chamber ‘Cleaning’). 1 Switch off the shaver, remove the adapter from the 6 Put the protection cap on the shaver to prevent wall socket and pull the appliance plug out of the damage to the shaving heads (Fig. 8). shaver. Note: Make sure that the lug of the protection cap covers the 2 Rinse the outside of the shaving unit under a hot tap release button. for some time (Fig. 9). 3 Pr
ページ13に含まれる内容の要旨
EnglisH EnglisH 1 Switch off the shaver, remove the adapter from the 9 Put the retaining frame back into the shaving unit and wall socket and pull the appliance plug out of the turn the orange wheel clockwise. shaver. 10 Put the shaving unit back onto the shaver. 2 Press the release button and pull the shaving unit off storage the shaver (Fig. 10). - Put the protection cap on the shaver after use to 3 Turn the orange wheel anticlockwise (1) and remove prevent damage to the shaving
ページ14に含まれる内容の要旨
EnglisH EnglisH 4 Remove the battery compartment (1) and remove Environment the battery (2) (Fig. 22). - Do not throw away the appliance with the normal Do not connect the shaver to the mains again after you household waste at the end of its life, but hand it in at have removed the battery. an official collection point for recycling. By doing this, you help to preserve the environment (Fig. 19). guarantee & service - The built-in rechargeable battery contains substances If you need servi
ページ15に含まれる内容の要旨
EnglisH EnglisH Problem Possible cause Solution Problem Possible cause Solution The shaver The shaving Clean the shaving heads The shaver The battery is Recharge the shaver (see does not heads are thoroughly before you does not empty. chapter ‘Charging’). shave as dirty. continue shaving (see go on well as it chapter ‘Cleaning’). when I used to. press the on/off Long Clean the cutters and button. hairs obstruct guards properly with the shaving the brush supplied (see My skin is Your skin
ページ16に含まれる内容の要旨
EnglisH EnglisH Problem Possible cause Solution The This is normal. No action required. appliance becomes warm during charging. 27 28
ページ17に含まれる内容の要旨
29 30
ページ18に含まれる内容の要旨
31 32
ページ19に含まれる内容の要旨
33 34
ページ20に含まれる内容の要旨
13 14 15 16 17 18 19 20 21 22 35
