ページ1に含まれる内容の要旨
ESPAÑOL
ENGLISH FRANÇAIS
t
Instruction Manual
Manual de Instrucciones
Manuel d’Instructions
1900
ForOccasionalUseOnly
WARNING:
Read and follow all Safety Rules and Operating Instructions before
using this product. Failure to do so can result in serious injury.
ADVERTENCIA:
Lea el manual de instrucciones y siga todas las advertencias e en-
strucciones de seguridad. El nohacerlo puede resultar enlesiones
graves.
AVERTISSEMENT:
Lire le manuel d’instructions et bien respecter tous les avertisse-
men
ページ2に含まれる内容の要旨
IDENTIFICATION OFSYMBOLS Read and understand the WARNING! This chain instruction manual before saw can be dangerous! Care- using the chain saw. lessorimproperusecancause serious or even fatal injury. Alwayswearappropriate earprotection, eyeprotectionandheadprotection. Always use two hands when operating the chain saw. WARNING! Contacting the guide bartipwith anyobject should be avoided; tip contact may cause the guide bar to movesuddenlyupwardandbackward,whichmaycausese- rious injury. XX_ Measur
ページ3に含まれる内容の要旨
S Carefullyplanyoursawingoperation inad- marked container for all fuel purposes. vance. Donotstartcuttinguntilyouhavea Wipe up all fuel spills before starting saw. clearworkarea,securefooting, and, ifyou S Moveat least 10feet (3meters) fromfuel- are felling trees, a planned retreat path. ing site before starting engine. S Turn the engine off and let saw cool in a OPERATEYOURSAWSAFELY non-combustible area, not on dry leaves, S Donotoperateachainsawwithonehand. straw,paper,etc. Slowly remove fuel
ページ4に含まれる内容の要旨
Avoid Obstructions Elbow locked Clear The Working Area REDUCETHECHANCEOF KICKBACK S Recognize that kickback can happen. Thumb on underside of handlebar With a basic understanding of kickback, you can reduce the element of surprise which contributes to accidents. S Keepagood,firmgriponthesawwithboth S Neverletthemovingchaincontactanyob- hands when the engine is running and ject at the tip of the guide bar. don’tletgo. Afirmgripwillhelpyoureduce S Keep the working area free from obstruc- kickback
ページ5に含まれる内容の要旨
Reduced Kickback Symmetrical Guide Bar canbecausedbyallowing contactofthebar tip in the danger zone with any hard object. Kickbackcanalsobecausedbypinchingthe sawchainalongthetopoftheguidebar. This action may push the guide bar rapidly back toward the operator. Either of these events Small Radius Tip may cause you to lose control of the saw which could result in serious injury or even Symmetrical Guide Bar death. DONOTRELYUPONANYOFTHE DEVICES BUILT INTO YOUR SAW. YOU SHOULDUSETHESAWPROPERLYAND C
ページ6に含まれる内容の要旨
Thechainissharpandcancutyouevenwhen NOTE: If this saw is to be used for com- it is not moving! mercial logging, a chain brake is required S Loosen and remove the chain brake nuts and shall not be removed or otherwise dis- and the chain brake from the saw. abled tocomplywithFederal OSHARegula- S Remove the plastic shipping spacer (if tions for Commercial Logging. present). SAFETYNOTICE: Exposure tovibrations Location of shipping spacer through prolonged use of gasoline powered hand tools could ca
ページ7に含まれる内容の要旨
Depth Gauge Cutters Chain Adjustment Chain Brake Nuts Tool (Bar Tool) Drive Links Adjusting thetension: Chain tension is very important. Chain stretches during use. This is especially true during the first few times you use your saw. Always check chain tension each time you use and refuel your saw. You can adjust the chain tension byloosen- ing the chain brake nuts and turning the ad- Place chain onto the sprocket justing screw 1/4 of aturn while lifting upon S Place chain overand behind clutch,
ページ8に含まれる内容の要旨
OPERATION KNOWYOURCHAINSAW READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR CHAINSAW. Compare the illustrations with yourunit tofamiliarize yourself with the location of the various controls and adjustments. Save this manual for future reference. Front Handle Front Hand Guard Chain Adjustment Tool Starter Rope (Bar Tool) ON/STOP Switch Muffler Chain Primer Bulb Starter Bar Oil Fill Cap Housing Fuel Mix Fill Cap Cylinder Cover Fast Idle Lock Throttle Chain Lockout Direction Adj
ページ9に含まれる内容の要旨
FUELING & LUBRICATION STARTING WARNING: Removefuelcapslow- WARNING: The chain must not ly when refueling. move when the engine runs at idle speed. If the chain moves at idle speed refer toCAR- FUELINGENGINE BURETOR ADJUSTMENT within this Thisengineiscertifiedtooperateonunleaded manual. Avoidcontact withthemuffler.Ahot gasoline. Before operation, gasoline must be muffler can cause serious burns. mixed with a good quality 2-cycle air-cooled To stop the engine move the ON/STOP engineoil. Werecommen
ページ10に含まれる内容の要旨
S Pushthe chokeknob incompletely (tothe Disengaged OFFposition); pullthestarterropeuntilthe engine starts. Engaged CHOKE (SIDE VIEW) Braking function control CAUTION: The chain brake must be Choke knob OFF FULL checked several times daily. The engine mustberunningwhenperforming thisproce- S Allowtheenginetorunforapproximately 5 dure. Thisistheonlyinstancewhenthesaw seconds. Then, squeeze and release should beplaced onthe ground with the en- throttle trigger to allow engine to return to gine runn
ページ11に含まれる内容の要旨
S Releasethethrottle triggerassoonas FELLINGLARGETREES the cut is completed, allowing the en- (6 inches in diameter or larger) gine to idle. If you run the saw at full The notch method isused tofell large trees. throttle without a cutting load, unnec- Anotchiscutonthesideofthetreeinthede- essary wear can occur to the chain, sired direction of fall. After a felling cut is bar, and engine. made on the opposite side of tree, the tree S To avoid losing control when cut is will tend to fall into the
ページ12に含まれる内容の要旨
S DO NOT cut down a partially fallen tree sure. Hold saw firmly and maintain control. withyoursaw. Beextremely cautious with The saw will tend to push back toward you. partially fallen trees that may be poorly supported. When a tree doesn’t fall com- WARNING: Neverturn sawupside pletely,setthesawasideandpulldownthe down to undercut. The saw cannot be con- tree with a cable winch, block and tackle, trolled in this position. or tractor. Always make your first cut on the compres- sionsideofthelog.
ページ13に含まれる内容の要旨
Using asupport stand PRUNING nd 2 Cut WARNING: Limit pruning to limbs shoulder height or below. Do not cut if branches arehigher thanyourshoulder.Get a professional to do the job. S Make your first cut 1/3 of the way through the bottom of the limb. st 1 Cut S Next make a 2nd cut all the way through the limb. Then cut a third overcut leaving a 1 to 2 inch collar st from the truck of the tree. 1 Cut nd 2 Cut Second cut Third cut LIMBING ANDPRUNING Collar WARNING: Be alert for and guard First cut a
ページ14に含まれる内容の要旨
harmful emissions. Alwayscleanafterevery CARBURETORADJUSTMENTS 5 hours of operation. Your carburetor is equipped with limiter caps. Carburetor adjustment is a compli- S Clean the cover and the area around it to cated task. We recommend that you take keep dirt and sawdust from falling into the carburetor chamber when the cover isre- your unit to an Authorized Service Dealer. moved. Damagewilloccurifyouturntheneedlesbe- yond the limiter stops. S Remove the parts as illustrated below. S Wash the fi
ページ15に含まれる内容の要旨
S Replace with Champion RCJ--7Y spark Storeunitwithallguardsinplace.Positionso plug and tighten securely with a 3/4 inch that any sharp object cannot accidentally socket wrench. Spark plug gap should be cause injury topassersby.Storethe unit out 0.025 inches. of reach of children. S Reinstall the spark plug boot. S Before storing, drain all fuel from the unit. S Reinstall the cylinder coverand 3screws. Start engine and allow torununtil it stops. Tighten securely. S Clean the unit before storing.
ページ16に含まれる内容の要旨
waywhichinourjudgement affectsitscondi- tion or operation. This warranty does not NEED ASSISTANCE? cover tune--up, spark plugs, filters, starter ropes, starter springs, chain sharpening, NEEDASSISTANCE? bars,chains,andotherpartswhichwearand Call 1---800---554---6723. require replacement with reasonable use NEED SERVICE PART? during the warranty period. This warranty Contact your dealer or place of purchase. does not cover predelivery set--up, installa- tion of guide bar and chain, and normal ad-
ページ17に含まれる内容の要旨
WEED EATER authorized repair center as WEED EATER servicing center. CONSE- soon as a problem exists. Warranty repairs QUENTIAL DAMAGES: POULAN/WEED shouldbecompletedinareasonableamount EATER may be liable for damages to other of time, not to exceed 30 days. If you have engine components caused bythe failure of any questions regarding your warranty awarranted part still under warranty.WHAT rights and responsibilities, you should con- IS NOT COVERED: All failures caused by tact your nearest author
