ページ1に含まれる内容の要旨
.~erious Steel
912101 ’WEIGHT CARRIAGE OPTION
ASSEMBLY INSTRUCTIONS
Revision,: 02/24/97
1
Part # 6678401
ページ2に含まれる内容の要旨
IIMPORTANT NOTES] There is a risk assumed by individuals who use this type of equipment. To minimize risk, please follow these rules: 1. Consult your physician before beginning any exercise program. 2. Inspect equipment daily. Tighten all loose connections and replace worn parts immediately. Failure to do so may result in serious injury. 3. Do not allow minors or children to play on or around this equipment. 4. Exercise with care to avoid injury. 5. If unsure of proper use of equipment, call you
ページ3に含まれる内容の要旨
PARTS LIST KEY PART # DESCRIPTION QTY DESCRIPTION QTY KEY PART # 2 1/2" WASHER 1 6 3102502 6675202 CARRIAGE 1 LOCKNUT 2 7 3102804 1/2" LOW HEI CHROME PLATE HOLDER 1 2 6675501 4 3/8" LOCK NUT 4 8 3102802 6675303 PLATE, 1/4 X 3 X 12" 3 1/4" SPACER 8 9 6122704 1/2 X 2.-3/4" BOLT 2 4 3102935 2 4 3108002 3/4" WEIGHT STACK CUSHION 10 5 3102953 3/8. X 4-.1/2" BOLT STEP 1: A. Securely attach the CHROME PLATE HOLDER (2) CARRIAGE (1) using two 1/2 X 2-3/4" BOLTS (4), 1/2" WASHERS (6), and two 1/2" LOW H
ページ4に含まれる内容の要旨
TOWER BRACE ,TOP BOOM FIGURE 3 STEP 3: Route threaded end of CABLE (part # 6671601) around pulleys in TOP BOOM and IPULLEY BLOCK ASSEMBLY. Route CABLE (part # 6671601) down through hole in TOWER and TOWER BRACE shown in FIGURE 3. FIGURE 4 STEP 4: Thread end of CABLE (part # 6671601) into CARRIAGE (1) and securely tighten jam nut as shown in FIGURE 4. 1/2 1/2 2
ページ5に含まれる内容の要旨
FIGURE 5 STEP 5: A. Remove the BOLT & WASHERS below the PULLEY in upright. See FIGURE 5, Insert the threaded end of CABLE (part #6671001) under the PULLEY in UPRIGHT and around the B. bottom PULLEY of the PULLEY BLOCK. See FIGURE 5. Fasten end of CABLE (part #6671001) into threaded housing on the base of BENCH FRAME. C. D. Tighten jam nut securely. . E. Securely fasten previously removed BOLT & WASHER. (NOTE: The CABLE (part #6671001) should be routed over the bolt and washer. 5
ページ6に含まれる内容の要旨
," SNAP HOOK "~ LAT BAR RING FIGURE 6 STEP 6: Attach CHROME LAT BAR & DOUBLE D CHROME HANDLE to ball ends of cables using 5/16" SNAP HOOKS. See FIGURE 6. THIS CONCLUDES THE ASSEMBLY OF THE 912101
