ページ1に含まれる内容の要旨
827102
LAT MACHINE
ASSEMBLY
INSTRUCTIONS
1
12/20/95
ページ2に含まれる内容の要旨
827102 LAT MACHINE ASSEMBLY INSTRUCTIONS SORT AND COUNT ALL PARTS BEFORE BEGINNING A~SEMBLY HARDWARE: ITEM NAME/DESCRIPTION QTY 3/8 IN WASHER ..................................................................................................................... 3 1/2 IN WASHER ..................................................................................................................... 4 3. 3/8 IN LOCK WASHER ..................................................................................
ページ3に含まれる内容の要旨
827102 LAT MACHINE ASSEMBLY INSTRUCTIONS NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSIDE OF THE HEAD OF THE BOLT. BOLT LENGTH BOLT LENGTH RULER: 1/2 I 1/2 I 1/2 [ 1/2 I 1/2 1 1/2 1 2 3 4 5 6 Insert One (1) 2" END CAP and two (2) 2-1/2" OD END CAPS into the open ends of the BASE. 2. Apply two (2) 2-1/2" X 5-t/2" NON SKID STRIPS to the BASE as shown on drawing, 3. Insert two (2) 2" END CAPS into the open ends of the FRONT UPRIGHT, 4. Insert one (1) 3 X 2" END CAP into front end &the BOOM and slid
ページ4に含まれる内容の要旨
827102 LAT MACHINE ASSEMBLY INSTRUCTIONS Ill I I I I I Slide four (4) 1 X 8" GRIPS over the ends of the LAT BAR and the LOW ROW BAR. (NOTE: COATING INSIDE OF THE GRIP WITH RUBBING ALCOHOL WILL FACILITATE EASIER INSTALLATION. I Attach eight (8) CARRIAGE GLIDES to the WEIGHT CARRIAGE as shown in (DFTAIL B) using following steps: A. Thoroughly clean all inside surfaces where the CARRIAGE GLIDES are to be attached. Remove the paper backing fi’om the CARRIAGE GLIDES and firmly apply them to the WEI
ページ5に含まれる内容の要旨
iO-I ,,~130EtVl~fd ’73BV-I (£) AlOe
ページ6に含まれる内容の要旨
....... REVISIONS . I -~ SEE D-~TAIL A .4 WLDMT. CARRIAGE F CARRIAGE :~I’OP 1-1/4- IN SO RUBBER BUMPER SNAPHOOK LAT BAR 1 X 8 IN GRIP LOW’ ROW BAR CHAIN SER~L NUMBER CABLE ROUTING, DIAGRAM PARABO D~’, INC. RAMSEY, MINNESOTA ~ASSY IN’T, 827102 ~,,.
ページ7に含まれる内容の要旨
IN FLANGE LABEL., LAT.~R WARNING gUIDES (~,) BOTH ENDS scN WNYL SLEEVES (~) 3 X 2 IN END CAP’--~ ~ 3/8 X 2-3/4 IN BOLT (g) ~~.~~.. DETAIL A 3-1/’2 x I IN PULLEY m~(/.,,,--3/B X 2 ~N BOLT (2) FRONT UPRIGH]~ WLDMT. ROLLER PADS LOOK N~ (13) _WLDMT. LABEL, PARABODY LOG L .--. END ~P (21 ~~~~ I/2 X 3 IN BOLT ~~~
