ParaBody 824101の取扱説明書

ページ1に含まれる内容の要旨

824101
LEG CURL/EXT ATTACHMENT
PRODUCT ASSEMBLY
INSTRUCTIONS SHEETS
1 04/15/97

ページ2に含まれる内容の要旨

824101 LEG CURL/EXT ATTACHMENT ASSEMBLY PARTS LIST SORT AND COUNT ALL PARTS BEFORE BEGINNING ASSEMBLY ttARDWARE: ITEM NAME/DESCRIPTION QTY 1 1/2 X 3 IN. BOLT .............................................................................................................. 2. 1/2 IN. WASHER ................................................................................................................ 2 3. 1/2 IN. LOW HEIGHT LOCK NUT ..: ...............................................................

ページ3に含まれる内容の要旨

824101 LEG CURL/EXT ATTACHMENT ASSEMBLY INSTRUCTIONS Insert one (1) 1-3/4 IN. SQ. END CAP into the top of the LEG EXTENSION NECK as shown drawing. Slide t~vo (2) ROLLER PADS over each end of the SHAFT of the LEG EXTENSION NECK,. shown on drawing, and hold in place using two (2) 3/4 IN. STARLOCK COLLARS. 3. Insert three (3) 1-3/4 IN. SQ. END CAPS into the ends of the LEG EXTENSION as stm~ on drawing. Insert two (2) 1/2 IN. FLANGE BEARINGS into the BUSHING on the LEG EXTENSION as shown drawing.

ページ4に含まれる内容の要旨

824101 LEG CURL/EXT ATTACHMENT ASSEMBLY INSTRUCTIONS To perform DECLINES or AB CRUNCHES, loosen the THUMBSCI~EW, and pull up the LEG EXTENSION ASSEMBLY until the hole in the LEG EXTENSION NECK is expose. Insert the U- PIN through the hole in he NECK and the BUSHING on the LEG EXTENSION (AT THE SAME TIME). Allow the U-PIN to rest on top of the UPRIGHT TUBE. Re-tighten the THUMBSCREW. To adjust the SEAT PAD for the DECLINE position, rotate the U-PIN back to the SECOND PIN STOP. 10. When U-PIN is n

ページ5に含まれる内容の要旨

ページ6に含まれる内容の要旨