ページ1に含まれる内容の要旨
Personal Hair Trimmer
Operating Instructions
IN USA CONTACT:
Panasonic Consumer Electronics Company
Model No. ER327
One Panasonic Way 2F-3 Secaucus, NJ 07094
IN PUERTO RICO CONTACT:
Panasonic Sales Company
Division of Matsushita Electric of Puerto Rico, Inc.
San Gabriel Industrial Park 65th infantry Avenue KM9.5
Carolina, Puerto Rico 00630
En México:
Panasonic de México, S.A de C.V.
México D.F.
Arnores 1120, Col. del Valle, 03100
Tel: 54 88 10 00
Service • Assistance • Accessories
Dépannage • As
ページ2に含まれる内容の要旨
Caution • Do not place the trimmer in locations that are subject to high humidi- ty. • Clean the body only with a soft cloth slightly dampened with water or soapy water. Never use a corrosive cleaner such as benzine or bleach. • Never immerse the trimmer in water or apply to wet hair. Index • Keep out of reach of children. • Do not use on animals. ENGLISH Page 2 • The trimmer may become warm during operation. This is normal. ESPAÑOL Página 22 • Never tamper with the moving parts. • Do not di
ページ3に含まれる内容の要旨
Before use Parts identification Inserting the batteries Back Parts Name 1 Comb Trimmer comb Remove the battery cover. attachment Turn the trimmer over onto its back (the side without the switch) and slide the battery cover in the direc- Finishing tion of the arrow. Trimming height adjustment switch display Battery cover Hair clipper Trimming height attachment dial ON/OFF Switch Match the battery Check the direction of the poles with the direction batteries and insert. 2 displayed Two “AAA” a
ページ4に含まれる内容の要旨
Before use Adjusting the length of the Preparations before cutting Trimmer Comb attachment Drape a towel or cape 1 over the shoulders. Turn the switch to [0]. * The trimmer comb attachment will not 1 Comb the hair thorough- slide if the switch is [1]. ly to remove any tangles 2 or knots. Turn the 5 position dial until 2 it clicks, then adjust the trim- mer comb attachment to the desired length. Hair areas which can be trimmed Overall Side (around the ears) Bangs Back of the neck Sideburns
ページ5に含まれる内容の要旨
Before use Attaching and removing Attaching and removing the Trimmer Comb attachment the Hair Clipper attachment Removing Removing Turn the switch to [0], Turn the switch to [0] confirm that the dial and slide the attach- guide is set to [1] and ment to remove. then gently pull off to Hold down the dial dur- remove. ing removal. Attaching Attaching Turn the switch to [0], Turn the switch to [0] confirm that the dial and slide the attach- guide is set to [1] and ment to attach. then attach it
ページ6に含まれる内容の要旨
Cutting Cutting by adjusting the length Cutting the sides and back procedure of the Trimmer Comb attachment Having secured the trimmer comb attachment onto the body Make sure the switch is facing downwards before attempting to cut. 25mm (15/16") Trimming height 5mm (3/16") Cut from the sides and back to around the ear, the collar area and the nape of neck, adjusting Secure the trimmer the cutting height from 25mm comb attachment (15/16") to 5mm (3/16"). before cutting. The trimmer will no
ページ7に含まれる内容の要旨
Cutting procedure Trimming height Trimming height 25 to 20mm 10 to 5mm Cutting the sides to the back (15/16 to 13/16") (3/8 to 3/16") Cutting the nape of the neck 1 3 Cut from Make sure the switch is facing downwards Make sure the switch is facing downwards Slowly and carefully cut and cut by moving the trimmer upwards. and cut by moving the trimmer upwards. 25 - 20mm a little at a time. (15/16 - 13/16") Bring the trimmer Bring the trimmer gently away from gently away from the hair to finish.
ページ8に含まれる内容の要旨
Scalp Scalp 90º Cutting Overall hair cutting procedure *Cutting areas with excessive hair. Guard Having secured the hair clipper attachment Make sure the switch is facing upwards and cut by moving the trimmer downwards. Scalp Scalp Move the trimmer down- Apply the comb directly wards in the direction of to the scalp and move it the arrows when cutting slowly. around the ears. The guard section of the hair clipper attachment will prevent the blade from cutting an excessive amount of hair. * D
ページ9に含まれる内容の要旨
Cutting Fine trimming procedure Trimming the sideburns Lower the thinning plate Without any attachments Raise the thinning plate Thinning the bangs Make sure the switch is facing up- Apply the ward and move the thinning plate cutting blade down the hair as if combing. directly Little by little comb the trimmer through the hair approximately 2-3cm (13/16-1 3/16") from Cutting around the collar, the nape of the tip of the fringe while continuously checking the neck, and around the ears the res
ページ10に含まれる内容の要旨
Maintenance After use Turn the switch to [0]. Removing Attaching the blade the blade Make sure the Pop-up Trimmer is in the [Down] Insert the blade position. B Insert the hook 1 A into the slot . B A Press the blade Press the blade Press 2 Until there is a click. Apply slight pressure from the back of the trimmer against the blade. The blade should gently pop-out. *Place your other hand under the blade to prevent it from falling. 17 18
ページ11に含まれる内容の要旨
Maintenance How to clean Turn the switch to [0] and clean the blade. Ratings and Specifications Remove the hair Between the 1 2 Power source Battery shavings from blades. Remove the hair trim the blade. Type of Two “AAA” alkaline batteries mings while pressing down on the cleaning batteries (not included) lever. 110 g (3.9 oz.) Weight (Including the batteries) This product is intended for household use only. READ ALL INSTRUCTIONS BEFORE USE. Remove the hair Apply oil (to all 3 4 trimmings