ページ1に含まれる内容の要旨
22369 Slimline RC Manual:Layout 1 10/11/09 16:02 Page 2
Installation, Operating, Maintenance
and After Sales Manual.
SLIM-LINE RC
heatingthroughinnovation.
Product Serial Number:
Please leave this manual with the end user.
Part Number: 1370064
Issue 2
01.07.2009 ISSUE 2
ページ2に含まれる内容の要旨
22369 Slimline RC Manual:Layout 1 10/11/09 16:02 Page 3 Contents 1.0 General Information 03 2.0 Heating System Design 03 3.0 Unit Selection/Sizing 03 4.0 Location 03 5.0 Preparation 04 6.0 Fixing 04 7.0 Water Connections 05 8.0 Electrical Connection 06 9.0 Commissioning Procedure 07 10.0 Technical Data 08 11.0 Operating Instructions 09 12.0 Troubleshooting 10 13.0 Maintenance 11
ページ3に含まれる内容の要旨
22369 Slimline RC Manual:Layout 1 10/11/09 16:02 Page 4 SLIM-LINE RC 03 1.0 General Information This MYSON SLIM-LINE RC fan convector is designed for wall programmed into the unit and the fan speed is automatically mounted installation with a minimum installation height of adjusted until the desired room temperature is achieved. In 150mm to the underside of the unit. manual mode any of the 3 available fan speeds can be selected without automatic room temperature control. This The SLIM-L
ページ4に含まれる内容の要旨
22369 Slimline RC Manual:Layout 1 10/11/09 16:02 Page 5 04 SLIM-LINE RC 5.0 Preparation Before proceeding with the installation, unpack the carton contents and check against the checklist below: 1. SLIM-LINE RC unit. 2. 15mm isolating valves (1 pair). 3. Instruction manual. 4. Warranty card. 5. Fixing kit (rubber mounts and cable gland). 6. Remote control handset. 6.0 Fixing Using the fixing dimensions (see fig. 1), mark the fixing hole Press adhesive washers to the wall. positions o
ページ5に含まれる内容の要旨
22369 Slimline RC Manual:Layout 1 10/11/09 16:02 Page 6 SLIM-LINE RC 05 7.0 Water Connections Connect unit to system flow and return pipes using the two Ensure system is flushed in accordance with recognised best 15mm isolating valves (see fig. 2). practice and a suitable inhibitor is added to the system as necessary. Note: To ensure effective venting of the heat exchanger the flow Open valves fully, check pipe connections for leaks and vent pipe should be connected to the bottom con
ページ6に含まれる内容の要旨
22369 Slimline RC Manual:Layout 1 10/11/09 16:02 Page 7 06 SLIM-LINE RC 8.0 Electrical Connection WARNING: This appliance must be earthed. The electrical installation must comply with local or national wiring regulations. This unit is supplied with factory fitted test leads. Remove Connect live and neutral wires to the power board terminal these and discard. connections, and the earth wire to the chassis earth terminal. A fused electrical spur with a maximum 3A fuse and a switch having
ページ7に含まれる内容の要旨
22369 Slimline RC Manual:Layout 1 10/11/09 16:02 Page 8 SLIM-LINE RC 07 9.0 Commissioning Procedure Fill and vent the system. Change switch position (see fig. 3). Open both valves fully and vent air from the heat exchanger Refit cover. by unscrewing the air bleed valve situated above the valves in Switch on electrical supply. the angled top of the chassis. Check for leaks at pipe connections. Displayed Temperature Calibration Refit the outer case and secure using the 2 fixing
ページ8に含まれる内容の要旨
22369 Slimline RC Manual:Layout 1 10/11/09 16:02 Page 9 08 SLIM-LINE RC 10.0 Technical Data Heating Performance Data Temperature Difference (°C) Power Fan Speed Consumption Heat Output (watts) Heat Output (Btu/h) (watts) 20° 30° 40° 50° 60° 20° 30° 40° 50° 60° Normal 860 1340 1820 2290 2770 2934 4572 6210 7813 9451 125 Medium 1130 1710 2280 2870 3460 3856 5835 7779 9792 11806 Boost 1470 2220 2960 3720 4460 5013 7575 10100 12693 15218 Tested in accordance with BS 4856 Part 1. Flow rate 340 l
ページ9に含まれる内容の要旨
22369 Slimline RC Manual:Layout 1 10/11/09 16:02 Page 10 SLIM-LINE RC 09 11.0 Operating Instructions In manual mode the automatic temperature control is Description overridden and any of the three fan speeds can be operated inrespective of the water temperature in the unit. This means This SLIM-LINE RC unit is fitted with a control system that that air circulation can be provided in summer for example, or provides either automatic or manual control of the unit. In that heating performanc
ページ10に含まれる内容の要旨
22369 Slimline RC Manual:Layout 1 10/11/09 16:02 Page 11 10 SLIM-LINE RC 11.0 Operating Instructions (continued...) Manual Operation Display Manual mode can be used for air circulation without heat or for Power off No Display manual control of the heating function. Switch on supply to unit for 30 seconds Use ‘+’ to scroll Selected fan speed (unit off) beyond 35°C displayed Or use ‘-’ to scroll below 15°C Supply on / unit off Switch on unit Set point flashes for approx 5 secs, then Ambient
ページ11に含まれる内容の要旨
22369 Slimline RC Manual:Layout 1 10/11/09 16:02 Page 12 SLIM-LINE RC 11 12.0 Troubleshooting (continued...) Problem Possible Causes Remedy Unit switched off Turn on Temperature set point reached Increase temperature set point Unit not switched on at fused spur Switch on at spur Fuse blown at fused spur Replace fuse Heating Mode - No Fan Unit isolating valves shut Open valves Water temperature reaching fan Check boiler - convector below 43°C Programmer ON (Heater model only) Boiler ON and se
ページ12に含まれる内容の要旨
22369 Slimline RC Manual:Layout 1 10/11/09 16:02 Page 1 MYSON Eastern Avenue, Team Valley, Gateshead, Tyne & Wear NE11 0PG, UK T: 0845 402 3434, F: 0191 491 7568, sales@myson.co.uk, www.myson.co.uk heatingthroughinnovation. After Sales Service: MYSON Service, Somerden Road, Hull, East Yorkshire HU9 5PE T: 01482 713927, F: 01482 789056, service.convectors@myson.co.uk Spare parts and technical help on all Convector products are available from MYSON Service. 01.07.2009 ISSUE 2
