ページ1に含まれる内容の要旨
CR9952
Alarm Clock Radio
Please read this manual before use
ROBERTS
Sound for Generations
ページ2に含まれる内容の要旨
Contents Contents ............................................................................ 1 Controls .......................................................................... 2-4 Batteries ............................................................................ 5 Switching on and setting the time .................................... 6 Listening to the radio ........................................................ 7 Setting the alarm time ................................................
ページ3に含まれる内容の要旨
Controls Front Back 5 6 4 3 7 2 8 1 1. Clock Display 6. Battery Cover 2. Minute hand 7. Light Mode button 3. Hour hand 8. Mains Supply Socket 4. Alarm hand 5. Second hand 2
ページ4に含まれる内容の要旨
Controls Top 13 12 14 11 15 10 9 9. Tuning scale 13. Speaker 10. Radio On/Off button 14. Alarm/Off button 11. Sleep button 15. Light/Off button 12. Snooze button 3
ページ5に含まれる内容の要旨
Controls Left hand side Right hand side 16 18 19 17 20 16. Time Set control 18. Tuning control 17. Alarm Set control 19. FM/MW switch 20. Volume control If you need any further advice, please call our Technical Helpline on :- 4 020 8758 0338 (Mon-Fri)
ページ6に含まれる内容の要旨
Batteries 1. Press the On/Off button to switch the radio off before replacing batteries. 1 2. Open the battery cover located on the rear of your clock radio by pressing the catch down and pulling the battery cover towards you. 3. Insert 4 x AA batteries into the compartment. Make sure the (+) and (-) ends of the batteries are positioned as shown inside the compartment. 4. Close the battery cover. 2 5. Press the On/Off button to switch the radio on after batteries have been replaced. 6. If the ra
ページ7に含まれる内容の要旨
Switching on and setting the time Before using your alarm clock radio you must first set the correct time. 1. Check that the batteries have been installed correctly. 2. Place the unit on a flat surface. 3. Press in and turn the Time Set control.Rotating the control will move the clock hands, continue until the correct time is reached. 3 If you need any further advice, please call our Technical Helpline on :- 6 020 8758 0338 (Mon-Fri)
ページ8に含まれる内容の要旨
Listening to the Radio 1. Switch on the clock radio by pressing the On/Off button 1 2. Slide the FM/MW switch to the required waveband. 2 3. Tune in to the desired station by rotating the Tuning control. The station frequency is indicated in the Tuning scale. The Wire aerial located on the rear of your clock radio is for FM reception. The wire should be fully extended and positioned for optimum reception. 3 For MW reception there is a built in ferrite aerial. Rotate your clock radio to the posit
ページ9に含まれる内容の要旨
Setting the alarm time The alarm can be set to wake you by a buzzer. 1. Press the Alarm/Off button. 1 2. Press in and turn the Alarm Set dial. Rotating the dial will move the alarm hand, continue until the correct time is reached. The buzzer will sound at the preset time. After a few seconds the buzzer will sound more urgently and a few seconds later will change its tone again. 2 3. The clock display will turn to a Red backlight whilst the alarm sounds. 4. To turn off the alarm and the Red backl
ページ10に含まれる内容の要旨
Snooze control 1. The buzzer alarm can be silenced for 5 minutes by pressing the Snooze button. This sequence can be repeated during the 90 minute alarm period. 1 Sleep function 1. The radio can be set to switch off automatically after a preset time has elapsed. 2 2. Press the Sleep/Off button. The radio will stay on for 59 minutes, then turn off automatically. 3. If the Backlight is illuminated at the time of pressing the Sleep/Off button, the Backlight will change from green to blue. On compl
ページ11に含まれる内容の要旨
Backlight The Backlight illuminates the clock display, making it easy to view in a dark environment. 1 1. Press and hold the Light/Off button on the top of the clock to turn on the Green backlight. The light will go off once the button is released. If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 10
ページ12に含まれる内容の要旨
Using the AC adaptor Your clock radio is supplied with a Mains Adaptor. 1. Place your clock radio on a flat surface. 2. Insert the adaptor plug into the DC socket located on the rear of your clock radio. 3. Plug the adaptor into a standard 13 amp mains socket outlet. Whenever the adaptor is used, the batteries are automatically disconnected. The AC adaptor should be disconnected from the mains supply and the radio when not in use. The AC adaptor for use with the CR9952 should provide 4.5 volts
ページ13に含まれる内容の要旨
Notes If you need any further advice, please call our Technical Helpline on :- 12 020 8758 0338 (Mon-Fri)
ページ14に含まれる内容の要旨
Specifications Circuit Features Power Requirements Loudspeaker 8 ohms Mains AC230 volts, 50Hz~ only Adaptor Output DC4.5 volts, 300mA Output power 0.8 Watts Battery 4 x LR6 (AA Size) alkaline Aerial System FM Wire Aerial Frequency Coverage FM 87.5 - 108MHz MW Built-in Ferrite Aerial MW 525 - 1605kHz The Company reserves the right to amend the specification without notice. General Do not allow this unit to be exposed to moisture (e.g. dripping or splashing) or to temperatures exceeding 70 degrees
ページ15に含まれる内容の要旨
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers. Procedure: Any claim under thi
ページ16に含まれる内容の要旨
ROBERTS RADIO TECHNICAL SERVICES 97-99 Worton Road Isleworth Middlesex TW7 6EG Technical Helpline:- 020 8758 0338 (Mon-Fri) Issue 1
