ページ1に含まれる内容の要旨
CR9961
3 Band Single Alarm
Clock Radio
Please read this manual before use
ROBERTS
Sound for Generations
ページ2に含まれる内容の要旨
Contents Contents ............................................................................ 2 Controls .......................................................................... 3-4 Switching on and setting the time .................................... 5 Listening to the radio ........................................................ 6 Setting alarm time ............................................................. 7 Checking alarm time .........................................................
ページ3に含まれる内容の要旨
3 Controls (Top) 2 4 5 6 1 1. Hour button 4. Time button 2. Minute button 5. Alarm off button 3. Sleep button 6. Snooze button 3
ページ4に含まれる内容の要旨
Controls (Left) (Right) 7 8 9 10 11 7. Function switch 10. Volume control 8. Tuning control 11. Back-up battery compartment 9. Wave Band selector 4
ページ5に含まれる内容の要旨
Switching on and setting the time Before using your clock radio you must first set the correct time. 1. Place the unit on a flat surface. Plug the mains lead into a wall socket and switch on the wall socket. 2. The clock display will flash 12:00. Ensure that the Function switch is set to the 'Off' position. 3. Press and hold down the Time button. 4. Whilst holding down the Time button press the Hour or Minute buttons to set the correct time. Release the buttons when the correct time is reached.
ページ6に含まれる内容の要旨
Listening to the Radio 1. Switch on your clock radio by sliding the Function switch to the 'On' position. The LED dial pointer will light up indicating that the radio is switched on 1 2. Slide the Waveband switch to the required waveband. 3. Tune in to the desired station by rotating the Tuning control. The station frequency is indicated in the dial scale. The Wire aerial located on the rear of your clock radio is for FM reception. The wire should be fully extended and positioned for optimum rec
ページ7に含まれる内容の要旨
Setting alarm time The alarm can be set to wake you by either the buzzer or the radio. 1. Press and hold down the ALARM/OFF button. 1 2 2. Whilst holding down the ALARM/OFF button press the Hour or Minute button to set the correct time. Release the buttons when the correct time is reached. The clock uses a 12 hour display with a PM indicator. Ensure that the correct 12 hour cycle is selected. 2 Checking alarm time 1. To check the Alarm time, press the ALARM/OFF button. The Alarm time will appear
ページ8に含まれる内容の要旨
Setting the alarm to wake to buzzer 1. Set the alarm time as previously described. Set the function switch to the 'Buzz' position. The Alarm indicator will light. 1 The buzzer alarm will sound every day at the preset time for 1 hour and 59 minutes. To turn off the alarm until the next day press the ALARM/OFF button. To turn off the alarm permanently set the Function switch to the 'Off' position. Setting the alarm to wake to radio 1. Set the alarm time as previously described. Set the function sw
ページ9に含まれる内容の要旨
Snooze control 1. The buzzer or radio alarm can be silenced for 9 minutes by pressing the Snooze button. This sequence can be repeated several times during the alarm period. 1 Sleep timer 1. The radio can be set to switch off automatically after a preset time has elapsed. 2 2. Press and release the Sleep button, 59 minutes is displayed. The radio will be on for 59 minutes then turn off automatically. 3. For a shorter sleep time hold down the Sleep button and the 3 3 Minute button, the display w
ページ10に含まれる内容の要旨
Headphones 1. A Headphone Socket (3.5mm) located on the back of the unit is provided for use with either headphones or an earpiece. Inserting a plug automatically mutes the internal loudspeaker. 1 10
ページ11に含まれる内容の要旨
Specifications Circuit Features Power Requirements Loudspeaker 8 ohms Mains AC 230 volts, 50Hz only Output power 0.8 Watts Back-up Battery IEC size 6F22/06PP (6LR61, PP3) Aerial System FM Wire Aerial Frequency Coverage FM 87.5 - 108MHz MW/LW Built-in Ferrite Bar aerial MW 525 - 1605kHz LW 150 - 285kHz The Company reserves the right to amend the specification without notice. If you need any further advice, please call our Technical Helpline on :- 11 020 8758 0338 (Mon-Fri)
ページ12に含まれる内容の要旨
General Fuse Do not allow this unit to be exposed to moisture (e.g. dripping or This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug splashing) or to temperatures exceeding 70 degrees centigrade. It is (BS1363). If another type of plug is used a 5A fuse should be fitted in recommended that the FM band be used wherever possible as better the plug, adaptor or distribution board. results in terms of quality and freedom from interference will usually be IF IN DOUBT - CONSULT A QUALIF
ページ13に含まれる内容の要旨
Notes 13
ページ14に含まれる内容の要旨
Notes 14
ページ15に含まれる内容の要旨
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers. Procedure: Any claim under thi
ページ16に含まれる内容の要旨
ROBERTS RADIO TECHNICAL SERVICES 97-99 Worton Road Isleworth Middlesex TW7 6EG Technical Helpline:- 020 8758 0338 (Mon-Fri) Issue 1