ページ1に含まれる内容の要旨
Clock Radio AJ3121
Register your product and get support at
www.philips.com/welcome
User manual
ページ2に含まれる内容の要旨
1 36 4 1 5 2 4 7 ! @ 8 0 9 #
ページ3に含まれる内容の要旨
English Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. CONTROLS (see fig. 1 ) 1 SET TIME /ALARM SET - sets the clock / alarm time 2 HR / MIN - adjusts the hours / minutes for clock / alarm / sleep time 3 REPEAT ALARM / SLEEP OFF - switches off the active alarm for a 9 minutes period - switches off the radio sleep function 4 ALARM RESET - stops the active alarm for 24 hours 5 SLEEP
ページ4に含まれる内容の要旨
INSTALLATION POWER SUPPLY 1 Check if the power supply, as shown on the type plate located on the bot- tom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the power cord to the wall outlet. 3 To disconnect the set from the power supply completely, remove the plug from the wall outlet. CLOCK MEMORY BACKUP The clock memory backup allows your alarm and clock time settings to be stored for up to a day when there is a power interrup
ページ5に含まれる内容の要旨
RADIO You can use this set solely as a radio! 1 Adjust RADIO / ALARM to RADIO ON to switch on the radio. 2 Select your waveband by adjusting the FM/MW switch. 3 Adjust TUNING to tune to your desired station. 4 Turn the VOLUME control to adjust the volume level. 5 Adjust RADIO / ALARM to OFF to switch off the radio. • When sleep function is activated, to switch off the radio, you also need to press SLEEP OFF button. To improve reception: FM: Extend and position the pigtail fully to obtain optimal
ページ6に含まれる内容の要旨
SELECTING THE ALARM MODE To use the alarm, you must set the alarm time first. You can choose from two dif- ferent alarm modes to wake you up: by radio or buzzer. 1 Select your choice of alarm mode by adjusting RADIO / ALARM to RADIO or BUZZER. ™ The alarm indicator (AL) will light up. Helpful Hint: • If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you. • The buzzer is set at a fixed volume and cannot be adjusted. SWITCHING OFF THE ALARM There are
ページ7に含まれる内容の要旨
REPEAT ALARM This repeats your alarm call at 9-minute intervals. 1 During the alarm call, press REPEAT ALARM. 2 Repeat if desired for up to 59 minutes. ™ The alarm indicator (AL) will remain on. SLEEP This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. This allows you to lie back, lis- ten and fall asleep. The maximum sleep time is 1 hour and 59 minutes. Setting SLEEP 1 Set RADIO / ALARM to OFF position. 2 Set the
ページ8に含まれる内容の要旨
SAFETY INFORMATION • Install the unit near the AC outlet and where the AC power cord plug can be easily reached. • Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnet device shall remain readily operable. • Place the set on a hard and flat surface so that the system does not tilt. • If you do not intend to use the set for a long time, withdraw the power plug from the wall outlet. In addition to this, it is advisable to remove the battery from the clock ra
ページ9に含まれる内容の要旨
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Do not open the set as there is a risk of electric shock. Problem – Possible Cause • Remedy No sound/power – Volume not adjusted • Adjust the volume Occasional crackling sound du
ページ10に含まれる内容の要旨
ページ11に含まれる内容の要旨
ページ12に含まれる内容の要旨
English Meet Philips at the Internet http://www.philips.com W AJ3121 Printed in China AJ3121_79_UM_V3.0
