ページ1に含まれる内容の要旨
20 Ft. 8-1/2” x 20 Ft. 6”
two car canopy
92942
Set up and operating inStructionS
Visit our website at: http://www.harborfreight.com
read this material before using this product.
Failure to do so can result in serious injury.
SaVe thiS manual.
© ®
Copyright 2005 by Harbor Freight Tools . All rights reserved. No portion of this manual or any
artwork contained herein may be reproduced in any shape or form without the express written
consent of Harbor Freight Tools. Diagrams within this
ページ2に含まれる内容の要旨
notice is used to SaVe thiS manual address practices not related to personal injury. Keep this manual for the safety warnings and precautions, assembly, caution, without operating, inspection, maintenance and the safety alert cleaning procedures. Write the product’s symbol, is used to address serial number in the back of the manual practices not related to near the assembly diagram (or month personal injury. and year of purchase if product has no number). Keep this manual and th
ページ3に含まれる内容の要旨
c. do not overreach. Keep proper 8. The warnings, precautions, and footing and balance at all times. instructions discussed in this This enables better control of the instruction manual cannot cover all assembly tools in unexpected possible conditions and situations that situations. may occur. It must be understood by the operator that common sense d. dress properly. do not wear and caution are factors which cannot loose clothing or jewelry. Keep be built into this product, but mus
ページ4に含まれる内容の要旨
6, 7), 3-Way End Pieces (part #8), aSSemBly diagramS and and 4-Way Center Pieces (part #9) inStructionS together as shown in Figure A, below. read the entire important 2. The eight Turnbuckles (part #11) SaFety inFormation are used to strengthen the frame section at the beginning of this assembly. Attach the Turnbuckles to manual including all text under the frame assembly and tighten, using subheadings therein before set a pair of pliers. See Figure B, next up or use of this prod
ページ5に含まれる内容の要旨
framing Tubes as shown in Figures C Piece. When complete, do the same and D, bottom. to the other side. See Figure C, below. 5. Once the corners are fastened, attach the remaining Tarp Ties through the 7. Insert a Nylon Base (part #12, not rest of the metal eyelets and onto the shown) onto the bottom of each framing Tubes. Vertical Tube. 6. Lift one side of the roof and insert 8. Secure the Nylon Bases to the three Vertical Tubes (part #1) into the ground, using the T-Stakes (part #13,
ページ6に含まれる内容の要旨
cleaning and maintenance uSer-maintenance inStructionS 1. BeFore each uSe, inspect the general condition of the Procedures not specifically Canopy. Check for loose hardware, explained in this manual must misalignment or binding of moving be performed only by a qualified parts, tears in the tarp, and any other technician. condition that may affect its safe operation. DO NOT USE DAMAGED t o preVent EQUIPMENT. SeriouS injury From accidental 2. Keep Canopy free of oil, grease, oper
