ページ1に含まれる内容の要旨
MODEL T10048
COLLET/TOOLING CART
FOR NT40
INSTRUCTIONS
Introduction
t he Model t 10048 is a specialized cart to keep
your nt 40 collets and tooling organized, pro-
tected, and close at hand. t he top and middle
shelves hold a total of 48 collets with additional
space for storing tooling on the lower and two end
shelves. Collet holders are non-marring and can
be marked for quick identification—ideal for Cn C
machines. t he heavy-duty rubber casters provide
easy movement of the cart and ca
ページ2に含まれる内容の要旨
Inventory u se the following chart and Figures 3–5 to iden- tify and inventory the items included with your shipment. REF PART # DESCRIPTION QTY 1 PT10048001 TOP SHELF 1 2 PT10048002 MIDDLE SHELF 1 3 PT10048003 COLLET HOLDER 48 4 PT10048004 BOTTOM SHELF 1 5 PT10048005 SIDE PANEL 2 6 PT10048006 SIDE SHELF 2 7 PT10048007 SIDE SHELF SUPPORT 4 8 PT10048008 FIXED CASTER 5" 2 Figure 5. Model t10048 inventory (3). 9 PT10048009 SWIVEL/LOCK CASTER 5" 2 10 PT10048010 HANDLE 1 11 PB02M HEX BOL
ページ3に含まれる内容の要旨
3. slide the middle shelf onto the mounting 5. Attach the side shelf supports to the side flanges of the side panels and secure it in shelves with 8 hex bolts and lock nuts, as place with 12 hex bolts and lock nuts, as shown in Figure 9. Fully tighten these fasten- shown in Figure 7. ers. Note: There are two possible mounting Note: Take special note of the orientation of positions for the middle shelf, as shown in the shelf and supports to one another. Figure 6. side panel Middle shelf side
ページ4に含まれる内容の要旨
7. square up the sides of the cart with the top 9. With assistance, tip the cart upright, then and middle shelves, then fully tighten all fas- check for stability and use. if necessary, teners. loosen fasteners, readjust the panels and shelves, then re-tighten the fasteners. 8. With assistance, turn the cart upside down and install the casters with 16 hex bolts and lock nuts, as shown in Figure 11. Note: To better move the cart, we recom- mend installing the swivel casters on the same sid
