ページ1に含まれる内容の要旨
MODEL H8110
9 DRAWER EURO STYLE
WORKBENCH-BIRCH
INSTRUCTIONS
Assembly
r efer to the last page of these instructions to
inventory your shipment for ease of assembly.
To assemble the workbench:
1. position the right side leg (C) on the floor
so the Up arrow is pointing upward and the
Front arrow points to the front, as shown in
figure 12.
2. place the two lower cross braces (e) on the
figure 11. model h8110 Birch Workbench.
floor so the slots face each other, as shown
in figure 12.
Specifi
ページ2に含まれる内容の要旨
5. place a flat washer (e2) on each barrel bolt (e3), and insert the bolts through the right- C side leg (figure 12). 6. Using a 5mm hex wrench, thread the bolts D E3 F into the barrel nuts (e4) (figure 12), but do E2 not fully tighten at this time. D 7. insert the lower panel (F) into the slots of the two lower cross braces (e), and into the groove of the side leg (figure 13). C figure 15. Upper cross panel installation. E 10. insert the upper panel (F) into the slot of the two upper cro
ページ3に含まれる内容の要旨
14. insert the bolts through the left-side leg, 19. insert the guide rods and leadscrew through tighten with a 5mm hex wrench, and all other the holes in the wood block (g) (figure 19). barrel bolts at this time. thread the leadscrew into the vise support until the wood block is slightly snug against 15. align the pre-drilled holes in the underside the table and flush with the table top. of the work bench table top (a) with the pre- drilled holes in the legs. Lead Screw Guide Rod Vise Supp
ページ4に含まれる内容の要旨
parts parts Breakdown and Inventory J C a d F g d B h e e F s F sL Bp f astener Kit e1 e4 e7 sB e8 e5 sC sr e2 ss sd e9 e6 e3 REf pART DESCRIpTION QTY e10 a ph 8110018 Ben Ch top 1 B ph 8110019 LeFt side L eg 1 ph 8110020 right side L eg 1 C f astener Kit part Numbers QTY d ph 8110021 top C ross B ra Ce 2 e1 ph 8110001 hand Le s Cre W 18 e ph 8110022 Bottom C ross B ra Ce 2 e2 pW01m FLat W asher 8 mm 12 F ph 8110023 Cross pane L 1 e3 ph 8110003 Barre L Bo Lt 3.5" 8 ph 8110024 Front V ise 1 g e4
