Grizzly Stile and Rail Set C2314-C2317の取扱説明書

ページ1に含まれる内容の要旨

INSTRUCTIONS FOR
C2314-C2317 REVERSIBLE
STILE AND RAIL SET
Introduction
The Model C2314-C2317 Reversible Stile and Rail
Always disconnect power
Sets allow you to shape ¾" material into door stiles !
to the machine when set-
and then simply reverse the cutter components to
ting up or making adjust-
shape the door rails. This set comes complete with
ments. Failure to do this
a ball bearing guide and shims.
may result in serious per-
sonal injury.
1
2 ⁄2"
Cutting Rails
For safety and best re

ページ2に含まれる内容の要旨

5. Use a straightedge to align the fences with the Cutting Stiles edge of the guide bearing. 6. Align the bottom edge of the shaper cutter with To cut the stile edges: the top, or slightly below the top of the table. 1. Unplug the shaper! 7. Before turning the shaper ON, place a test rail on against the miter gauge finished face up and 2. Place the bushing into the hole in the profile cut- slide it against the fence. ter from the bottom, as shown in Figure C, and slide both onto the spind

ページ3に含まれる内容の要旨

Adjustments N O T I C E If the test pieces are not flush (Figure D) then check If you have never used this type of machine the following: or equipment before, WE STRONGLY RECOM- MEND that you read books, trade magazines, or get formal training before beginning any Improper Height Adjustment Shown projects. Regardless of the content in this instruction sheet, Grizzly Industrial will not be held liable for accidents caused by lack of training. We stress the importance of working with good