ページ1に含まれる内容の要旨
Operating Instructions 309047
Rev. A
This manual contains important
warnings and information.
READ AND KEEP FOR REFERENCE.
INSTRUCTIONS
Pressure Roller
Model 243066, Series A
20 in. (50 cm) heavy-duty extension
45 swivel adapter
9 in. (23 cm) roller frame
1/2 in. (13 mm) nap roller cover
3600 psi (24.8 MPa, 248 bar) Maximum Fluid Inlet Pressure
*
This maximum pressure is only possible if the roller frame is
*
completely plugged. The best operating pressure is the lowest
pressure that p
ページ2に含まれる内容の要旨
Warnings and Cautions Installation Assemble the pressure roller as shown in the Parts WARNING Drawing on page 3. EQUIPMENT MISUSE HAZARD Misuse can cause the equipment to rupture or Pressure Relief Procedure malfunction and result in serious injury. To help prevent injury Do not modify the extension tube or roller INSTRUCTIONS WARNING frame or use parts not designed for this equipment. Do not use 1,1,1–trichloroethane, methylene To help prevent injection injuries, chloride, other halogenate
ページ3に含まれる内容の要旨
Flushing Parts Drawing This is the procedure for flushing the pressure roller. Pressure Roller, The pump and gun you are using may have additional Model 243066, Series A flushing steps, such as cleaning filters and screens. See the pump and gun flushing instructions. NOTE: Leave the pressure roller attached to the gun diffuser for this procedure. retaining nut 6 See Pressure Relief Procedure on page 2. 1 1. Relieve the pressure. 2 2. Remove roller cover (6) and diffuser from roller 3 frame as f
ページ4に含まれる内容の要旨
Graco Warranty Graco warrants all equipment manufactured by Graco and bearing its name to be free from defects in material and workmanship on the date of sale by an authorized Graco distributor to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective. This warranty applies only when the equi
