ページ1に含まれる内容の要旨
H8910
Instructions
Please keep this instruction sheet
for future reference, as it contains
important information.
Adult assembly is required.
No tools needed for assembly.
www.fisher-price.com
ページ2に含まれる内容の要旨
Assembly IMPORTANT! Please make sure your child does not follow you using this toy while you are operating a real lawn mower. Your child should play in a separate area away from the area where you mow. Use only bubble solution in this toy. Make sure your child understands that bubble solution is not for drinking and that it should be kept away from the eyes. While filling or cleaning this toy, try to avoid spilling bubble solution on the floor. It may create slippery floor condit
ページ3に含まれる内容の要旨
Bubblin’ Fun P R E S S 1 1 1 3 Remove and discard the cap and seal Press down on the bottle for about from the bubble solution bottle. 15 seconds to fill the mower. Carefully fit the bottle to the bottom of the filler cap attached to the front of the mower. Twist the bottle to attach. 1 2 Insert the bottle, cap side down, into the opening near the front of the mower. Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. ©2005 Mattel, Inc. All Rights Reserved.
ページ4に含まれる内容の要旨
Bubblin’ Fun If your mower still does not make bubbles: - Check to be sure there is enough bubble solution in the mower. - Make sure all four wheels contact the ground when pushing the mower. - Empty bubble solution from the mower. Wash the bubble chamber and filler opening. Refill with fresh bubble solution (see page 5). Note: We do not recommend the use of silicones or oily lubricants on this toy. As with any bubble producing toy, when even a very small amount of silicone or oi
ページ5に含まれる内容の要旨
Let’s Clean Up 1 1 1 3 Lift to remove the bubble solution Tip the mower forward to empty all bottle from the mower. Twist to the water. remove the filler cap. Set the bottle Cap End Up For Storage 1 4 1 2 Replace the filler cap on the bubble solution bottle and place the bottle in the filler opening cap end up. Thoroughly rinse the bubble chamber on the side of the mower and filler Hint: Please keep the bubble opening near the front of the mower solution bottle with your toy an
ページ6に含まれる内容の要旨
Problems and Solutions Problem Cause Solution No bubbles Not enough bubble solution in Press down on bubble solution bubble chamber bottle for 15 seconds to refill. Bubble chamber is clogged Follow instructions in “Let’s and dirty Clean Up” section to clean bubble chamber thoroughly. You have not walked far enough The bubble mower needs to be to produce bubbles pushed a minimum of 15-20 walking steps before bubbles begin to flow. You are walking too quickly Walk at a slow, steady pace. T
