ページ1に含まれる内容の要旨
P Please read this manual and save it lease read this manual and save it
with your original sales receipt. with your original sales receipt.
T Tool needed for assembly: ool needed for assembly:
Phillips screwdriver (not included). Phillips screwdriver (not included).
® ®
U Use only with a Power Wheels se only with a Power Wheels 12 V 12 Volt olt
Lead-Acid Rechargeable Batter Lead-Acid Rechargeable Battery y and and
® ®
a a Power Wheels Power Wheels 12 V 12 Volt Charger with olt Charger wit
ページ2に含まれる内容の要旨
A T TABLE OF CONTENTS ABLE OF CONTENTS A Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 B Warnings and Cautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 C Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ3に含まれる内容の要旨
WARNINGS AND CAUTIONS B ELECTRICAL HAZARD WARNING � Battery can fall out and injure a child if vehicle tips over. Always use battery retainer. � PREVENT FIRE - Never modify the electrical system. Alterations could cause a fire resulting in serious injury and could also ruin the electrical system. - Use of the wrong type battery or charger could cause a fire or explosion resulting in serious injury. ® ® - Use of Power Wheels components in products other than Power Wheels vehicles could
ページ4に含まれる内容の要旨
C PARTS • If you experience a problem with this product, or are missing a part, please call us at 1-800-348-0751, rather than return this product to the store. • Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that no parts are discarded. • Metal parts have been coated with a lubricant to protect them during shipment. Wipe all metal parts with a paper towel to remove any excess lubricant. Windshield Vehicle Hood 2 Grab Bars
ページ5に含まれる内容の要旨
A TABLE OF CONTENTS PARTS C 3 #10 x /4" Screw - 10 #8 x 1" Screw - 2 12 Volt Battery #10-32 x 1" Screw – 2 3 #8 x /4" Screw - 1 5 /32 x 1 ½" Pin - 1 For your convenience, we included extra fasteners! 12 Volt Battery Charger Note: Tighten and loosen all screws with a Phillips screwdriver. Do not over-tighten the screws. Part Not Shown: Label Sheet Fasteners Shown Actual Size 5 N1476pr-0920 N1476pr-0920 5
ページ6に含まれる内容の要旨
D A TABLE OF CONTENTS PARTS PICTURE 8 6 9 6 7 10 13 11 4 4 5 14 12 15 3 3 16 1 2 17 1 Vehicle 7 Seat 13 Windshield Parts Not Shown 2 Steering Column Cap 8 Steering Wheel Cap 14 Dash #10 x ¾" Screw - 10 #8 x ¾" Screw - 1 5 3 Hood Latch - 2 9 /32 x 1 ½" Pin - 1 15 Hood #8 x 1" Screw - 2 Label Sheet 4 Grab Bar - 2 10 Steering Wheel 16 12 Volt Battery #10-32 x 1" Screw - 2 5 Long Seat Belt Strap 11 Steering Column 17 12 Volt Battery Charger 6 Short Seat Belt Strap - 2 12 Key Assembly 6 6 N14
ページ7に含まれる内容の要旨
BATTERY CHARGING E ELECTRICAL HAZARD WARNING CAUTION � Battery can fall out and injure a child if Use the charger in dry locations only. vehicle tips over. Always use battery retainer. About Thermal Fuses � PREVENT FIRE ® Your Power Wheels 12 volt battery is equipped with a built-in - Never modify the electrical system. thermal fuse. The thermal fuse is a self-resetting safety device Alterations could cause a fire resulting which automatically “trips” and shuts down operation of the in s
ページ8に含まれる内容の要旨
E BATTERY CHARGING F ASSEMBLY WARNING Children can be harmed by small parts, sharp edges and sharp points in the vehicle's unassembled state, or by electrical items. Care should be taken in unpacking B and assembly of the vehicle. Children should 12V Battery not handle parts, including the battery, or help in assembly of the vehicle. A Dash Charger Vehicle Connector A • Plug the charger connector into the battery . B • Plug the charger into a standard wall outlet . Motor Harness Notes
ページ9に含まれる内容の要旨
ASSEMBLY F Steering Dash Wheel Key Assembly Steering Steering C Column olumn 3 INSIDE VIEW 5 • Insert and “snap” the key assembly into the opening in the dash, as shown. • Turn the vehicle upright. • Position the steering wheel so that the large opening and the S Steering teering tab on the steering wheel stem are both up. C Column olumn • Fit the steering wheel onto the steering column. S Steering teering Column Column P Pin in E End of nd of S Steering teering 6 C Column olumn 5 • Insert
ページ10に含まれる内容の要旨
F ASSEMBLY S Steering teering W Wheel Cap heel Cap Hood Latch Slot Hood Latch Hood Latch 7 • Fit the steering wheel cap into the center of the steering wheel. FRONT VIEW 9 • Insert two #8 x 1" screws and tighten. • Insert a hood latch into one of the slots near the hood on the front of the vehicle. • Twist the base of the hood latch ¼ turn to secure it to the vehicle. • Repeat this procedure to attach the other hood latch to the vehicle. Steering Column Cap Hood T Ta ab bs s S Slots lots 10
ページ11に含まれる内容の要旨
ASSEMBLY F S Seat eat W Wipers ipers W Windshield indshield S Seat Back eat Back Ta Tab bs s Ta Tab bs s B C B L Large T arge Ta ab b Large T Large Ta ab b Large Slots Large Slots A 11 • Position the windshield so that the molded detail on the TOP VIEW 13 wipers faces the front of the vehicle. Hint: The windshield will only fit one way. If it does not seem to • With the seat at an angle, insert the two tabs on the front edge of fit, turn it around and try again. A the seat into the slots in
ページ12に含まれる内容の要旨
F ASSEMBLY G Grab Bars rab Bars # #10 x ¾" Screws 10 x ¾" Screws 15 • Fit a grab bar onto each side of the vehicle, as shown. BOTTOM VIEW 17 • Turn the vehicle on its side. • Insert four #10 x ¾" screws in the holes (in front of and behind each rear wheel) in the underside of each rear wheel well, through the vehicle and into the ends of the grab bars. Tighten the screws. 16 • Insert a #10-32 x 1" screw through the hole in each grab bar and into the seat. Tighten the screw. 12 N1476pr-0920
ページ13に含まれる内容の要旨
A TABLE OF CONTENTS DECORATION G Proper label application will help to keep the labels looking their best! When applying labels, keep the following guidelines in mind: • Wash your hands before applying the labels. • Before applying the labels, wipe the surface of the vehicle with a clean, dry cloth to remove any dust or oils. • Place the labels exactly as shown in the illustrations. • For best results, avoid repositioning a label once it has been applied to the vehicle. • After applying a labe
ページ14に含まれる内容の要旨
G DECORATION 5 20 4 4 19 6 16 9 21 14 1 3 22 13 14 BACK VIEW 14 N1476pr-0920
ページ15に含まれる内容の要旨
BATTERY INSTALLATION H ® IMPORTANT! Use only a Power Wheels 12 volt lead-acid rechargeable battery. Use of any other battery will damage your vehicle. Make sure that you charge the battery for at least 18 ® hours using the enclosed Power Wheels 12 volt charger before operating your vehicle for the first time. Charge the battery for at least 14 hours after each use of the vehicle. Never charge the battery longer than 30 hours. Failure to follow these instructions may damage your battery a
ページ16に含まれる内容の要旨
I BATTERY CARE AND DISPOSAL Care Disposal If a battery leak develops, avoid contact with the leaking acid ® • Your Power Wheels battery is a non-spillable, sealed and place the damaged battery in a plastic bag. See information lead-acid battery. It must be recycled or disposed of in an below for proper disposal. environmentally sound manner. If acid comes in contact with skin or eyes, flush with cool • Do not dispose of a lead-acid battery in a fire. The battery may water for at least 15 m
ページ17に含まれる内容の要旨
SAFE DRIVING RULES J Teach Safety Rules to Children RIDING HAZARD While children can quickly develop the skill necessary to drive this vehicle, it is important to remember that their judgment skills are WARNING still very immature. Unsupervised driving by children can lead to serious injury. Before children use this vehicle, an adult should carefully evaluate the driving area as well as the children’s skill � Prevent Injuries and Deaths level and ability to drive this vehicle safely. Child
ページ18に含まれる内容の要旨
K VEHICLE OPERATION Stop IMPORTANT! Use this vehicle ONLY outdoors. Most interior floor-ing can be damaged by riding this vehicle indoors. ® Fisher-Price will not be responsible for damage to the floor if the vehicle is used indoors. Beginner Use - Low Speed Drive As assembled, your vehicle is ready to roll in low speed 1 (2 /2 mph, maximum). It has been pre-set so it will only operate • Your vehicle has a patented, electronic braking system that in low speed. After your child has mastered
ページ19に含まれる内容の要旨
K VEHICLE OPERATION VEHICLE CARE L • Check all screws, cap nuts and their protective coverings Advanced Use - High Speed Drive regularly and tighten as required. Check plastic parts on a regular basis for cracks or broken pieces. • During snowy or rainy weather, the vehicle should be stored inside or under a protective cover. Remember to charge the battery at least once per month while your vehicle is not in regular use. • Avoid operating the vehicle in wet or snowy conditions, and do Stor
ページ20に含まれる内容の要旨
M LIMITED WARRANTY Bumper-to-Bumper* Limited Warranty ® *One year limited warranty from the date of purchase on the Power Wheels vehicle. Six month limited warranty on the 12 volt battery. ® For the original purchaser, this one year limited warranty covers the Power Wheels ride-on vehicle (purchased from ® Power Wheels ) against defects in materials and workmanship. The six month limited warranty applies only to the 12 volt battery ® included by Power Wheels with the original purchase of the ve
