ページ1に含まれる内容の要旨
Please read this manual and save it with your original sales receipt.
Tools needed for assembly: Phillips Screwdriver, Hammer,
Slotted Screwdriver, and Safety Scissors (tools not included).
®
Use only with a Power Wheels Type H 6 Volt Battery and
®
a Power Wheels Type H 6 Volt Charger (both included).
Product features may vary from the picture above.
Jeep and the Jeep grille design are registered trademarks of DaimlerChrysler Corporation and are used under license.
©DaimlerChrysler Corporatio
ページ2に含まれる内容の要旨
T TA ABLE OF CONTENTS BLE OF CONTENTS A A Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 B Warnings and Cautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 C Parts . . . . . . . . . . .
ページ3に含まれる内容の要旨
W WARNINGS AND CAUTIONS ARNINGS AND CAUTIONS B B ELECTRICAL HAZARD WARNING � Battery can fall out and injure a child if vehicle tips over. Always use battery retainer. � PREVENT FIRE - Never modify the electrical system. Alterations could cause a fire resulting in serious injury and could also ruin the electrical system. - Use of the wrong type battery or charger could cause a fire or explosion resulting in serious injury. ® ® - Use of P ower Wheels components in products other than Powe
ページ4に含まれる内容の要旨
P PARTS ARTS C C � If you experience a problem with this product, or are missing a part, please call us at 1-800-348-0751, rather than return this product to the store. � Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that no parts are discarded. � Metal parts have been coated with a lubricant to protect them during shipment. Wipe all metal parts with a paper towel to remove any excess lubricant. Battery Retainer Grille (E
ページ5に含まれる内容の要旨
P PARTS ARTS C C Fasteners Shown Actual Size #8 x 1" Screw - 12 6 Volt Charger 6 Volt Battery #8 x 18 x 1" Screw - 2 Shifter Microphone 1 #6 x / " Screw - 11 2 Key Assembly Steering Wheel Cap 1 #6 x 1 / 2" Screw - 2 Sport Bar Cover Set Traction Band - 4 Cap Nut – 2 Radio Dial Cap Assembly For your convenience, an extra cap nut has been included. Note: Tighten and loosen all screws with a Phillips screwdriver. Do not over-tighten the screws. Parts Not Shown: Label Sheet - 2 J0713pr-0920 5 5 6-V
ページ6に含まれる内容の要旨
P PARTS PICTURE ARTS PICTURE D D Note: Some of the parts shown are assembled to both sides of the vehicle. 32 29 15 16 9 28 30 18 32 5 24 4 19 23 26 29 29 10 31 25 22 5 20 31 14 32 21 1 32 13 3 27 32 17 6 7 8 2 11 11 12 28 1 1 Vehicle Body 8 Headlight Lens - 2 15 Windshield 22 Instrument Panel 29 #6 x / " Screw - 11 2 1 2 Steering Column 9 Steering Wheel Cap 16 Windshield Frame 23 Steering Wheel - Bottom Half 30 #6 x 1 / " Screw - 2 2 3 Grille 10 Spark Plug Wires 17 Dash 24 Steering Wheel - T
ページ7に含まれる内容の要旨
BATTERY CHARGING E ELECTRICAL HAZARD ELECTRICAL HAZARD WARNING CAUTION Use the charger in dry locations only. � Battery can fall out and injure a child if vehicle tips over. Always use battery retainer. About Thermal Fuses � PREVENT FIRE ® Your Power Wheels 6 volt battery is equipped with a built-in thermal - Ne ver modify the electrical system. fuse. The thermal fuse is a self-resetting safety device which automati- Alterations could cause a fire resulting cally “trips” and shuts down operat
ページ8に含まれる内容の要旨
BATTERY CHARGING E Charger Connector 1 Battery Connector � Squeeze the connector tabs on the charger connector and plug it into 2 the battery connector. IMPORTANT! If you are recharging your battery, you will first need to � Plug the charger into a standard wall outlet. lift the hood and remove the battery retainer (pretend engine cover). Note: If power flow to the wall outlet is controlled by a switch, make Disconnect the battery connector from the motor harness connector. sure the switch i
ページ9に含まれる内容の要旨
ASSEMBLY F Steering WARNING Column Children can be harmed by small parts, sharp edges and sharp points in the vehicle's unassembled state, or by electrical Guide items. Care should be taken in unpacking Steering and assembly of the vehicle. Children should Linkage not handle parts, including the battery, or INSET help in assembly of the vehicle. Steering Square Column Opening Vehicle Body Guide Dash 3 BOTTOM VIEW � Position the vehicle body on its side. � Fit the straight end of the s
ページ10に含まれる内容の要旨
ASSEMBLY F Steering Wheel Cap Slot Tab Steering Wheel Tab Radio Dial Activity Panel Label 12 Gear Label 13 7 � Using safety scissors, separate the activity panel and the instrument panel. Dispose of the plastic connector. 5 � Apply labels 12 and 13 to the radio dial. � From the back of the activity panel: fit one end of the radio dial onto a � Fit the steering wheel cap into the center of the steering wheel with tab on the activity panel; position the center gear in the slot; and then the
ページ11に含まれる内容の要旨
ASSEMBLY F Hole Key Microphone Slot Assembly Instrument Panel Plastic 9 Tip � Insert and “snap” the key assembly into the hole in the instrument panel. 11 Instrument Panel � Bend the plastic tip at the end of the microphone cord to form a “T”. � Insert the plastic tip into the small hole in the left side of the vehicle body. Pull gently on the cord to make sure it is secure. Steering Wheel Tab Tab � Fit the tab on the back of the microphone into the slot in the dash. Activity Panel Tab Tab No
ページ12に含まれる内容の要旨
ASSEMBLY F Windshield Windshield Frame Windshield 15 13 � Rotate the top of the windshield toward the front of the vehicle body. � Fit the windshield into the windshield frame. � Insert four #8 x 1" screws into the holes in the hinge on the windshield 1 � Insert five #6 x /2" screws into the holes in the windshield and tighten. and tighten. Windshield Hood Grille Dash 14 Slots � Fit the tabs on the back of the windshield into the slots in the top of the dash. 16 � Lift the hood. � Fit the tab
ページ13に含まれる内容の要旨
ASSEMBLY F Grille Screw Tips Sport Bar Cover (RON) Sport Bar Headlight Lens 19 Tab 17 � Align the tips of the screws with the holes in the other sport bar cover marked RON. Fit the two sport bar covers together. � Fit the tab on one side of a headlight lens into the notch in the grille. � Tighten the screws. � Push firmly to snap the tab on the other side of the headlight lens into the grille. � Repeat this procedure to assemble the other headlight lens to the grille. Sport Bar Sport Bar Hol
ページ14に含まれる内容の要旨
ASSEMBLY F Traction Band Ridge Tether Wheel Cap Assembly 21 � Face the back of the vehicle. � With the cap tether pointing down, insert and “snap” the cap assembly into the square opening in the rear of the vehicle. 24 BOTTOM VIEW Taillight Lens � Turn the vehicle on its side. Taillight Housing � Fit a traction band around a wheel. � Slide a slotted screwdriver under the traction band to push the traction band onto the ridge in the center of the wheel. Hint: If the traction band is difficult
ページ15に含まれる内容の要旨
DECORATION G Proper label application will help to keep the labels looking their best! Keep the following guidelines in mind when applying labels: � Wash your hands before applying the labels. � Before applying the labels, wipe the surface of the vehicle with a 7 clean, dry cloth to remove any dust or oils. JEEP® and the Jeep ® grille design are registered trademarks of DaimlerChr ysler Corporation. JEEP ® WRANGLER® and its trade dress are used under license from DaimlerChr ysler. ©DaimlerChr
ページ16に含まれる内容の要旨
BATTERY INSTALLATION AND BATTERY RETAINER H (ENGINE COVER) ASSEMBLY ® IMPORTANT! Use only a Power Wheels Type H 6 Volt battery. Use of any other battery will damage your vehicle. Make sure that you charge the battery for at least 18 hours using the enclosed ® Power Wheels Type H 6 Volt charger before operating your vehi- cle for the first time. Charge the battery for at least 14 hours after each use of the vehicle. Never charge the battery longer than 30 hours. Failure to follow these instr
ページ17に含まれる内容の要旨
BATTERY CARE AND DISPOSAL I Disposal Care ® If a battery leak develops, avoid contact with the leaking acid and � Your Power Wheels battery is a non-spillable sealed lead-acid battery. place the damaged battery in a plastic bag. See information below for It must be recycled or disposed of in an environmentally sound manner. proper disposal. � Do not dispose of a lead-acid battery in a fire. The battery may explode If acid comes in contact with skin or eyes, flush with cool water for or leak. a
ページ18に含まれる内容の要旨
SAFE DRIVING RULES J RIDING HAZARD WARNING Prevent Injuries and Deaths � Direct Adult Supervision Required � Never Ride at Night Use vehicle on generally level ground ONLY! � Keep Children Within Safe Riding Areas These areas must be: 10. Never put anything near any moving parts. Rotating parts such as - away from swimming pools and other motors, gear boxes and wheels can snag fingers, hair, etc., causing bodies of water to prevent drownings serious injury. Do not allow op
ページ19に含まれる内容の要旨
VEHICLE OPERATION VEHICLE CARE K L � Check all screws, retainers and protective coverings regularly and IMPORTANT! Use this vehicle ONLY outdoors. Most interior tighten as required. Check plastic parts on a regular basis for cracks ® flooring can be damaged by riding this vehicle indoors. Fisher-Price or broken pieces. will not be responsible for damage if this vehicle is used indoors. � During snowy or rainy weather, the vehicle should be stored inside or under a protective cover. Remember
ページ20に含まれる内容の要旨
BUMPER-TO-BUMPER LIMITED WARRANTY M ® *One year limited warranty from the date of purchase on the Power Wheels vehicle. Six month limited warranty on 6 volt battery. ® ® For the original purchaser, this one year limited warranty covers the Power Wheels ride-on vehicle (purchased from Power Wheels ) against ® defects in materials and workmanship. The six month limited warranty applies only to the 6 volt battery included by Power Wheels with the original purchase of the vehicle. ® This warranty
