ページ1に含まれる内容の要旨
T6209
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Tools required for assembly: Phillips Screwdriver,
Hammer and Scrap Block of Wood (not included).
Age: 2-5 years
Weight limit: 55 lbs (25 kg).
www.fi sher-price.com
ページ2に含まれる内容の要旨
Consumer Information WARNING TO AVOID SERIOUS INJURY: #8 x 2¼" Screw - 1 • Adult supervision is required. .354" • Never use near cars and other motor vehicles, near streets, steps, sloped #8 x¾" Screw - 6 .354" Cap Nut - 2* driveways, hills, roadways, alleys, swimming pools or other bodies of water. ALL SHOWN ACTUAL SIZE • Always wear shoes. *We’ve included one extra .354" cap nut for your convenience. • Never allow more than one rider. Parts • Please save all packaging material until assembly
ページ3に含まれる内容の要旨
Assembly CAUTION This product contains small parts in its unassembled state. Adult assembly is required. Straight Axle Assembly PUSH Seat 3 Bottom View • Turn the frame upside down. • Insert the straight axle assembly through the holes in the rear of the frame. Frame 1 Wheel • Fit the seat onto the frame. Push fi rmly near the back end (Flat Side First) of the seat to "snap" it into place. Bushing (Grooved Side Down) Straight Axle Bushing (Smooth Side First) Rear Wheel Hub Wheel (Pointed En
ページ4に含まれる内容の要旨
Assembly Pedal Axle Tab Pedal Hub Pedal Hub 7 • Fit two pedal hubs onto the pedal axle tabs. Make sure the tabs fi t into the slot in each pedal hub. • While holding the pedal hubs on the pedal axle, insert the pedal axle into the hole in the center of the front wheel. • Press the pedal hubs into the center of the front wheel until they are fl ush with the surface of the front wheel. 5 • Repeat this procedure on the other side with the other two pedal hubs. • Fit the cap nut on the end of th
ページ5に含まれる内容の要旨
Assembly Label Decoration Fork Post 5 5 Back Fork Cover 9 3 • Insert the fork post up through the hole in the neck of the frame. Make sure the fork is positioned so that the fork covers face the rear wheels. Fork Post Handlebar Front Handlebar Back ¾" Screw ¾" Screw 2¼" Screw Front • Wash your hands before applying the labels. • Make sure the areas where the labels will be applied are clean and dry. Wipe your vehicle with a clean, soft, dry cloth to remove any dust or oils. • For best result
ページ6に含まれる内容の要旨
Label Decoration Consumer Information • Periodically, check the plastic parts and if broken or 6 cracked, dispose of them properly. • Periodically, check all fasteners regularly to be sure they 2 are tight. If the fasteners are not tight, tighten them as necessary. 4 • To clean, use a mild soap and water solution and a clean cloth. Rinse clean with water to remove soap residue. IMPORTANT! It is a good practice to start training children very young regarding the importance of helmet use. Whe
