ページ1に含まれる内容の要旨
Product features may vary from the picture above.
Cycle
Owner’s Manual with Assembly Instructions
Please read this manual and save it with your original sales receipt.
For Model 74518
Tools needed for assembly: Phillips Screwdriver, Hammer, Slotted Screwdriver, and Safety Scissors.
® ®
Use only with a Power Wheels Type H 6 Volt Battery, a Power Wheels 25 Amp Fuse
®
and a Power Wheels Type H 6 Volt Charger (all included).
ページ2に含まれる内容の要旨
Parts A Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 B Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 C Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ3に含まれる内容の要旨
Warnings B WARNING • Children can be harmed by small parts, sharp edges and sharp points in the vehicle’s unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the battery, or help in assembly of the vehicle. • Keep small parts and plastic bags out of children’s reach. Dispose of plastic bags properly. • Adult supervision is required. Children do not have the judgement necessary to avoid many accident
ページ4に含まれる内容の要旨
Parts C • If you experience a problem with this product, or are missing a part, please call us at 1-800-348-0751, rather than return this product to the store. • Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that no parts are discarded. • Metal parts have been coated with a lubricant to protect them during shipment. Wipe all metal parts with a paper towel to remove any excess lubricant. Dashboard Small Parts Bag 6 Volt Charger Head
ページ5に含まれる内容の要旨
L Parts 1 #8 x 1 /2" Screw – 4 Cap Nut – 3* Radio Knob – 2 Handlebar Plug – 2 7 8 #8 x / " Screw Wheel Bushing – 2 3 #8 x /4" Screw – 4 Gas Cap 25 Amp Fuse – 2* 1 #12 x 1 /4" Screw *For your convenience, an extra 25 amp fuse Key Assembly and cap nut have been included. All Screws Shown Actual Size Left Handlebar Right Handlebar Handle Front Axle Vehicle Body Front Wheel Fairing Seat 6 Volt Battery Not Shown: Label Sheets 5
ページ6に含まれる内容の要旨
Parts Diagram D 16 15 15 14 16 14 13 12 17 18 22 19 11 2 3 4 1 10 4 5 6 7 9 5 7 8 10. Headlight Lens - 2 19. 6 Volt Battery 1. Vehicle Body 11. Fairing 20. 25 Amp Fuse 2. Fender 12. Right Handlebar 21. Gas Cap 3. Inner Shock Half - 2 13. Left Handlebar 22. Dashboard 4. Outer Shock Half - 2 14. Handlebar Plug - 2 23. Key Assembly 5. Cap Nut - 2 15. Handgrip - 2 24. Radio Knob - 2 6. Front Axle 16. Handgrip Streamer - 2 25. Microphone 7. Hubcap - 2 17. Seat 26. 6 Volt Charger 8. Wheel Bushing - 2
ページ7に含まれる内容の要旨
Battery Charging E WARNING CAUTION • The battery must be handled by adults Use the charger indoors only. only. The battery is heavy and contains Important Notes: sulfuric acid (electrolyte). Dropping the battery could result in serious injury. • Your new battery must be charged for at least 18 hours before you use it in your vehicle for the • Never allow children to charge the battery. first time. Battery charging must be done by adults • We recommend that you start charging your battery only. A
ページ8に含まれる内容の要旨
Battery Charging 25 Amp Fuse 1 3 GOOD FUSE "BLOWN" FUSE • If you are charging the battery for the first time, insert a • Plug the charger into a standard wall outlet. 25 amp fuse into the battery. Note: If power flow to the wall outlet is controlled by a Note: The top of the fuse will not be flush with the top of switch, make sure the switch is “ON”. the battery when properly installed. • Before first-time use, charge the battery for at least 18 • If you are recharging your battery, make sure th
ページ9に含まれる内容の要旨
L Assembly F Do not omit any steps. Please set aside at least 30 minutes for assembly. Handgrip 3 1 Swivel Left Handlebar Bracket Handgrip Streamer • Using the tip of a slotted screwdriver, press the metal Vehicle Body retainer on a handgrip streamer into the hole in a handgrip, as shown. • Stand the vehicle body on its rear wheels. • Repeat this procedure to attach the other handgrip • Slide the left handlebar through the holes in the left side streamer to the other handgrip. of the swivel bra
ページ10に含まれる内容の要旨
Assembly 1 4 #8 x 1 /2" Screw – 2 5 7 6 Shown Actual Size Dashboard Dashboard Swivel Bracket • Apply labels to the dashboard as shown. • Make sure the areas where the labels will be applied are clean and dry. • For best adhesion, avoid repositioning a label once it has been applied to the vehicle. Radio Knobs 6 • Position the vehicle body upright. Key • Fit the dashboard onto the top of the swivel bracket. Assembly • Align the screw holes in the dashboard and swivel bracket. 1 • Insert two #8 x
ページ11に含まれる内容の要旨
Assembly Handlebars 11 9 ! ! ! ! ! ! ! ! Runner Fender Fairing Outer • Fit the fender onto the ends of the handlebars. (Make Shock sure the end of the fender marked FRONT is facing Halves toward the front of the vehicle.) • Slide the fender up the handlebars to the fairing. Front Axle Peg 10 Cap Nut Inner Shock Halves • Remove the rubber bands from the shock sets and dispose of the rubber bands. • Using safety scissors, cut the four shock set halves from the runner. Carefully trim excess plastic
ページ12に含まれる内容の要旨
Assembly Hubcap 15 12 Front Wheel Inner Shock Half Outer Fender • Fit and hold the hubcaps to each side of the front wheel. Shock Half • Make sure the posts on the inside of the hubcaps fit into the indentations on the front wheel, so that the hubcaps lay flat against the wheel. • Fit and hold an inner shock half to the inside of a handlebar. • Fit and hold an outer shock half to the outside of the same handlebar. 16 • Make sure the top ends of the shock halves fit under the fender. 13 Front Whe
ページ13に含まれる内容の要旨
Assembly Cap Nut Front Axle 18 20 Handlebar Headlight Lens L “L” • Align the “L” on the left headlight lens with the “L” in the left headlight on the fairing. • Insert the tabs on the headlight lens into the slots in the fairing. • Press firmly to snap the headlight lens into the fairing. • Repeat this procedure to assemble the right headlight • Slide the front axle through the handlebar. lens (marked “R”) to the fairing. Note: If the front axle will not slide through the handlebar, the handleba
ページ14に含まれる内容の要旨
Assembly This vehicle features a removable handle so parents can “guide” young drivers. Follow assembly steps 23 and 24 to assemble the handle to your vehicle. 24 Important! To prevent damage to the motors and gears, do not use the handle to push the vehicle if your child is not pressing the foot pedal. Screw Handle 23 Storage Compartment 1 #12 x 1 /4" Screw Shown Actual Size 1 • Insert a #12 x 1 /4" screw through the back of the vehicle and into the handle. • Tighten the screw with a Phillips s
ページ15に含まれる内容の要旨
Label Decoration G Proper label application will help to keep the labels looking their best! • Wash your hands before applying the labels. • Make sure the areas where the labels will be applied are clean and dry. Wipe your vehicle with a clean, soft, dry cloth to remove any dust or oils. • For best results, avoid applying a label more than once. • Apply the labels as shown in the illustrations. • After applying a label, rub the label firmly with a dry cloth to make sure the label is adhered to y
ページ16に含まれる内容の要旨
Battery Installation H ® ® Important Note: Use only a Power Wheels Type H 6 volt battery with a Power Wheels 25 amp fuse installed. Use of any other battery or fuse will damage your vehicle. Be sure to insert the battery correctly and always follow Power Wheels’ instructions for use and care. Make sure that you charge the battery for at least 18 hours before operating your vehicle for the first time. After first time use, charge the battery for at least 18 hours after each use. Never charge the
ページ17に含まれる内容の要旨
Battery Installation Battery Care and Disposal I Lock Fastener Care 5 If a battery leak develops, avoid contact with the leaking Lock acid and place the damaged battery in a plastic bag. See Fastener information below for proper disposal. Opening If acid comes in contact with skin or eyes, flush with cool water for at least 15 minutes and call a physician. If acid is internally ingested, give water, milk of magnesia or egg whites immediately. Never give emetics or induce vomiting. Call a physi
ページ18に含まれる内容の要旨
Rules for Safe Driving J • While driving across a steep slope, the vehicle may tilt and tip over. The wheels could lose traction, WARNING causing the vehicle to slip. • While driving up a steep incline, the motor may • Adult supervision is required. Children stop and the vehicle could roll backwards at an do not have the judgement necessary to unsafe speed. avoid many accidents. Be sure that children operating this vehicle can do so safely and that they are supervised at all times. • Never u
ページ19に含まれる内容の要旨
Caring How to Operate For Your Vehicle Your Vehicle K L • Check all screws, retainers and protective coverings regularly and tighten as required. Check plastic parts on a regular basis for cracks or broken pieces. • During snowy or rainy weather, the vehicle should be stored inside or under a protective cover. Remember to charge the battery at least once per month while your vehicle is not in regular use. • Avoid operating the vehicle in wet or snowy conditions, and do not spray the vehicle wi
ページ20に含まれる内容の要旨
Problems and Solutions Guide M IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions ® Guide below. If you still experience a problem, please contact Power Wheels Consumer Affairs, toll-free at 1-800-348-0751 between 8 AM and 6 PM (EST) Monday through Friday. Or, ® contact your local Power Wheels authorized service center. For the location nearest you, please refer to the Authorized Service Center list beginning on page 24. Problem Possible Cause Soluti
