ページ1に含まれる内容の要旨
A2642NS CA2642NS
A2642DNS CA2642DNS
ADJUSTABLE CART WITH OR WITHOUT CABINET
SINGLE OR DOUBLE PULL OUT SHELVES
Assembly Instructions
Parts List
Qty Part # Description
1 022-2813 Top Section for Single Shelf Models
022-3087 Top Section for Double Shelf Models
1 022-1099 Bottom Section for Open Shelf Models
022-1252 Bottom Section for Cabinet Models
1 010-5773 Notebook Pull Out Shelf (2 for Double Shelf Models)
1 030-1468 Left Outer Slide (2 for Double Shelf Models)
1 030-1470 Right Outer Sl
ページ2に含まれる内容の要旨
STEP 1 STEP 2 Turn bottom section over and push each caster into each Lay both top and bottom sections on their sides. Slide of the corner sockets. If casters do not insert easily a the top section over the bottom section as shown. rubber mallet may be used to tap the casters in place. MAKE SURE CASTERS ARE SECURELY IN PLACE. STEP 3 Attach legs together using screws (AA) and nuts (BB) as shown. NOTE: Carts have height adjustments at 4” increments. The single shelf models range from 26
ページ3に含まれる内容の要旨
This tab determines where the shelf will slide out from. Each cart bracket has additional cutouts to allow the shelf to pull out from either side of the cart. STEP 4 Install the outer slide onto the cart bracket by sliding TAB 1 into CUTOUT A and TAB 2 into CUTOUT B. NOTE: Some bend in the bracket is ok as the slides and shelf will take care of that once they are installed. IMPORTANT NOTE: Double shelf “DNS” models should have pull out shelves installed to pull out opposite from one
ページ4に含まれる内容の要旨
STEP 5 Install each inner slide into the outer slides. NOTE: Push inner slide in all the way until it snaps in. STEP 6 Extend the slides to the positioning shown. 4
ページ5に含まれる内容の要旨
CUTOUT 2 TAB 1 TAB 2 CUTOUT 1 STEP 7 Install the pull out shelf by sliding CUTOUT 1 into TAB 1 and CUTOUT 2 into TAB 2. Part # 031-7755 Rev. 01.20.11 CZ 5
