ページ1に含まれる内容の要旨
R
INSTALLATION
AND
OPERATING
INSTRUCTIONS
Models: XTRM-2, XTRM-3
RADIANT CONVEYOR TOASTER
INTENDED FOR OTHER THAN HOUSEHOLD USE
RETAIN THIS MANUAL FOR FUTURE REFERENCE
UNIT MUST BE KEPT CLEAR OF COMBUSTIBLES AT ALL TIMES
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
! !
WARNING: Improper installation, adjustment, alteration, service or maintenance can
cause propert
ページ2に含まれる内容の要旨
IMPORTANT FOR FUTURE REFERENCE Please complete this information and retain this manual for the life of the equipment. For Warranty Service and/or Parts, this information is required. Model Number Serial Number Date Purchased Notes: SAFETY PRECAUTIONS Before installing and operating this equipment be sure everyone involved in its operation are fully trained and are aware of all precautions. Accidents and problems can resu
ページ3に含まれる内容の要旨
TABLE OF CONTENTS SECTION ITEM PAGE 1 Important Safety Instructions 3 2 General Information 4 3 Installation Instructions 5 4 Operation Instructions 5 5 Cleaning Instructions 6 6 Specifications 6 7 Wiring Diagram 7 8 Parts Lists with Exploded Views 8 XTRM-2 8 XTRM-3 10 9 Warranty 12 1. IMPORTANT SAFETY INSTRUCTIONS IMPORTANT: Read the following important safety instructions to avoid personal injury or ! death, and to avoid damage to the equipment or property. ! WARNING: APW Wyott toasters a
ページ4に含まれる内容の要旨
WARNING: This product has no “user” serviceable parts. To avoid damage to the unit or injury to personnel, use only Authorized APW Wyott Service Agents and genuine APW Wyott Parts when ! ! service is required.. WARNING: Genuine APW Wyott Replacement Parts are specified to operate safely in the environments in which they are used. Some aftermarket or generic replacement parts do not have the characteristics that will allow them to operate safely in APW Wyott equipment. It is essential
ページ5に含まれる内容の要旨
3. INSTALLATION INSTRUCTIONS I. Check Contents: Refer to Figure 1, account for the following parts: Figure 1 A A. Remove foam pad and slide reflector tray in with wire feeder in upright position as shown. B. Ensure tray is properly engaged in tray slides. To do this simply hold the front of the tray higher than the rear as the back of the tray must slide under the slide on either side, You will know if done correctly because tray will be secure. No rocking or teeter
ページ6に含まれる内容の要旨
a) Product moistness - moister product requires slower speeds b) Sugar content in product - product with more sugar requires slower speeds c) Product Temperature - cooler product requires slower speeds 4. For best results, use day old bread stored room temperature. 5. CLEANING INSTRUCTIONS 1. Daily Cleaning A. With toaster off and cool, turn toaster on and set conveyor speed to four. B. Using a plastic abrasive pad, wipe the conveyor belt in a back and forth motion (side-to side) moti
ページ7に含まれる内容の要旨
Isometric View XTRM-3 19.420 (493mm) 20.782 (527.86mm) 2.647 19.254 (67mm) (489mm) 50° 4.493 (114mm) 13.967 2.820 (72mm) (355mm) 6.654 14.967 (380mm) (169mm) 16.323 (415mm) 7. WIRING DIAGRAM Rear Fan BLACK Rheostat BLUE BLACK 8 BLUE 8 Top Element 8 Top 12 Top EGO 10 EGO L2 8 12 10 12 H2 Control Fan H1 L1 Pilot P2 P1 9 16 13 13 4 4 Bottom EGO Top Bottom Element L2 EGO H2 14 14 H1 L1 Pilot P2 P1 14 5 9 Motor 5 9 16 L1 1 2 3 16 2 4 Top BLACK 3 4 Switch 15 6 6 1 L2 10 10 7 7 3 1 3 11 11 Ter
ページ8に含まれる内容の要旨
8 8. PARTS LISTS & EXPLODED VIEWS XTRM-2 EXPLODED VIEW 13 56 38 35 1 48 37 59 34 60 7 11 19 17 5 39 53 20 16 47 58 40 41 62 6 36 63 61 21 3 32 15 57 9 8 31 55 29 52 10 28 30 12 50 49 42 33 64 46 51 27 4 14 23 44 26 24 43 2 22 25
ページ9に含まれる内容の要旨
ITEM PART NUMBER DESCRIPTION (XTRM-2 PARTS LIST) QUANTITY 1 93000040 XTRM 2, RIVIET ASSEMBLY 1 XTRM-2&3 CONTROL PANEL EXTRUSION 1 2 93000158 3 93000159 EXTRUSION, XTRM 2&3 1 4 93000116 XTRM-2&3, PANEL, LEFT OUTER 1 5 93000115 XTRM-2&3, PANEL, RIGHT SIDE 1 6 93000225 END CAP, F/L & B/R 2 COVER, TOP, XTRM 2 1 7 93030181 8 38130 ASSY, CLIP BEARING 2 9 38125 BEARING FLANGED POLYMER 2 10 38122 W'ASSY IDLER SHAFT 1 11 83248 BEARING, SHAFT 2 DRIVE SHAFT ASSY AT-10 SE
ページ10に含まれる内容の要旨
10 XTRM-3 EXPLODED VIEW 35 7 57 13 39 36 54 11 38 17 5 19 48 1 20 40 16 41 6 42 27 3 58 37 59 63 15 21 33 9 30 8 29 56 32 53 31 51 50 43 52 60 34 64 28 14 47 2 25 1 22 44 4 23 26 24
ページ11に含まれる内容の要旨
ITEM PART NUMBER DESCRIPTION (XTRM-3 PARTS LIST) QUANTITY XTRM 3, RIVIET ASSEMBLY 1 1 93200040 2 93000158 XTRM-2&3 CONTROL PANEL EXTRUSION 1 3 93000159 EXTRUSION, XTRM 2&3 1 4 XTRM-2&3, PANEL, LEFT OUTER 1 93000116 5 93000115 XTRM-2&3, PANEL, RIGHT SIDE 1 END CAP, F/L & B/R 2 6 93000225 7 93230047 COVER, TOP, XTRM 3 1 8 38130 ASSY, CLIP BEARING 2 9 BEARING FLANGED POLYMER 2 38125 10* 93200070 SHAFT, IDLER XTRM 1 BEARING, SHAFT 2 11 83248 12* 83976 ASSEMBLY, DR
ページ12に含まれる内容の要旨
9. APW WYOTT EQUIPMENT LIMITED WARRANTY APW Wyott Foodservice Equipment Company warrants it's equipment against defects in materials and workmanship, subject to the following conditions: This warranty applies to the original owner only and is not assignable. Should any product fail to function in its intended manner under normal use within the limits defined in this warranty, at the option of APW Wyott such product will be repaired or replaced by APW Wyott or its Authorized Service Agency. AP
