ページ1に含まれる内容の要旨
WS-6003U
Atomic Clock
Instruction Manual
ページ2に含まれる内容の要旨
TABLE OF CONTENTS Topic Page Inventory of Contents/ Additional Equipment 3 About WWVB 3 Quick Set-Up Guide 3 Detailed Set-Up Guide Battery Installation 4 Program Mode Function Buttons 5 Time Zone Setting 6 DST (Daylight Saving Time) Setting 6 Language Selection 7 Time Setting 7 Calendar Setting 7-8 12/24-Hour Setting 8 Selecting °F or °C 8 Features & Operations Displaying the Seconds 9 Mounting 9-10 Maintenance & Care 10 Troubleshooting 11 Specifications 12 Warranty Inform
ページ3に含まれる内容の要旨
INVENTORY OF CONTENTS 1) WS-6003U 2) Instruction manual and warranty card. ADDITIONAL EQUIPMENT (not included) 1) Two fresh 1.5V AA batteries. 2) Three wall-hanging screws. 3) Appropriate screwdriver for screws. ABOUT WWVB (Radio Controlled Time) The NIST (National Institute of Standards and Technology—Time and Frequency Division) WWVB radio station is located in Ft. Collins, Colorado, and transmits the exact time signal continuously throughout the United States at 60 kHz. T
ページ4に含まれる内容の要旨
1) Remove the battery cover, located on the backside of the unit and directly above the function buttons. 2) Observe the correct polarity, and install 2 AA batteries. 3) Replace the battery cover. Note: After the batteries have been installed all the LCD’s (Liquid Crystal Display) will briefly light up. Then the indoor temperature, the date as “1/ 1” and the weekday as “MON” will be displayed. Also, the time will appear as “-:--” for approximately 1 minute. Then the WWVB search is a
ページ5に含まれる内容の要旨
program each function separately, or you can follow the instructions entirely to program the Atomic Clock. Complete programming is usually done for the initial set-up, and will require you to skip step 1 of programming sections III through VIII. Wait approximately 15 seconds for the Atomic Clock to automatically return to normal operation. I) FUNCTION BUTTONS There are 2 function buttons located on the backside of the Atomic Clock. The function buttons are labeled: SET and +. II)
ページ6に含まれる内容の要旨
3) Press and release the “SET” button to confirm the DST setting, and to advance to select the language for the weekday. IV) LANGUAGE SELECTION FOR THE WEEKDAY 1) Hold down the “SET” button for 2 seconds (the selected time zone will flash), press the “SET” button 2 more times, until the default language “US” flashes in the time LCD. 2) Press and release the “+” button to toggle through and to select the desired language. There are 3 languages to select from: US English F French
ページ7に含まれる内容の要旨
4) The default month “1” will flash. Press and release the “+” button to select the appropriate month. 5) Press and release the “SET” button to confirm the month, and to set the date. 6) The default date “1” will flash. Press and release the “+” button to select the appropriate date. 7) Press and release the “SET” button to confirm the date, and to set the weekday. 8) The default weekday “MON” (depends on selected language) will flash. Press and release the “+” button to select the a
ページ8に含まれる内容の要旨
3) Press and release the “+” button a third time and the display will return to the normal display. II) INDOOR TEMPERATURE The Indoor Temperature appears on the right side of the Date LCD. The temperature is checked every 10 seconds, and updated whenever there is a change. MOUNTING Hanging Holes Function Buttons SET Foldout Table Stands There are two possible ways to mount the atomic clock: • use of the foldout table stands, or • wall mounting.
ページ9に含まれる内容の要旨
3) Place the Atomic Clock onto the screws, using the hanging holes on the backside. Gently pull the Atomic Clock down to lock the screws into place. MAINTENANCE & CARE • Extreme temperatures, vibrations, and shock should be avoided to prevent damage to the units. • Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents—they may mark and damage the displays and casings. • Do not submerge in water. • Immediately remove all low powered batteries t
ページ10に含まれる内容の要旨
SPECIFICATIONS Temperature: Measuring range: 32 °F to 122 °F with 0.2 °F resolution (0 °C to 50 °C with 0.1 °C resolution) Outside range: “OFL” will be displayed Checking intervals: Every 10 seconds Power source: Battery type: 2 x AA, IEC LR6, 1.5V (Alkaline) Battery life: Approximately 12 months Dimensions (L x W x H): 8.3 x 1.2 x 8.4 in (211.8 x 30.5 x 214.4mm) 10
ページ11に含まれる内容の要旨
WARRANTY INFORMATION La Crosse Technology provides a 1-year warranty on this Atomic Clock. Contact La Crosse Technology immediately upon discovery of any defects covered by this warranty. Before sending the Atomic Clock in for repairs, contact La Crosse Technology. The Atomic Clock will be repaired or replaced with the same or similar model. This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty batteries, or the Clocks inability to rece
