ページ1に含まれる内容の要旨
™
oWNERS
MANu AL
Model No.
45-02181
26" LEAF/LAWNSWEEPER
CAUTION: Safety
Assembly
Read Rules for
Safe Operation operating
Maintenance
and Instructions
Carefully Repair Parts
the fastest way to purchase parts www.speedepart.com
PRINTED IN USA FORM NO. 40261 (4/24/07)
ページ2に含まれる内容の要旨
SAFETY RuLES Remember, any equipment can cause injury if operated improperly or if the user does not understand how to operate the equipment. Exercise caution at all times when using this equipment. CAu TIo N: VEHICLE BRAKING AND LooK FoR THIS SYMBoL T o PoINT ouT STABILITY MAY BE AFFECTED WITH THE IMPoRTANT SAFETY PRECAuTIoNS. IT ADDITIoN oF AN ACCESSoRY oR AN MEANS — ATTENTIoN! BECoME ALERT! ATTACHMENT. BE AWARE o F CHANGING YouR SAFETY IS INV oLVED. CoNDITIoNS oN SLoPES. Do not al
ページ3に含まれる内容の要旨
HARDWARE PACK (NoT SHoWN FLL SIZE) u ASSEMBLY INSTRuCTIoNS TooLS REQ uIRED FoR ASSEMBLY (1) Phillips Screwdriver (1) Adjustable Wrench (1) 7/16" Open End or Box Wrench 1. Assemble the two Handle Leg Stand Tubes to the Sweeper Housing, using two hex bolts 1/4-20 x 1-1/4" long, flat w ashers and 1/4-20 he x loc k n uts , per handle . See figure 1. Only hand tighten at this time . Ref. Description Qty. No. A Hex Bolt, 1/4-20 x 1-1/4" 4 B Flat Washers 1/4" I.D. 4 C Hex Lock
ページ4に含まれる内容の要旨
3. Now tighten the four bolts from step 1. 7. Assemble the two plastic rod caps to the rod ends of the bottom bag rod. Assemble two Palnuts to the ends 4. Assemble a bag rod clip to the inside of each lower of the top bag rod. See figure 5. handle tube using a curved head bolt secured down against the clip using a 1/4" lock nut. The open end of the clips should face towards the sweeper housing. See figure 3. FIGRE 5 u 8. Assemble the two plastic caps 3/4" x 7/8" onto the ends FIGuRE 3 of
ページ5に含まれる内容の要旨
9. Place the upper hopper bag and bag rod into the bag 11. Hook the elastic str aps on the bag flaps under the bag rod clips on the hopper handle . See figure 7. rod clips on the lo w er handle tubes as sho wn in figure 9. FIGRE 7 u FIGRE 9 u 10. Place the lower hopper bag and bag rod into the opening oPERATIoN on the s w eeper housing. See figure 8. Take care when operating your sweeper. Operating your sweeper according to these instructions will help prevent damage
ページ6に含まれる内容の要旨
WHEEL GEARS/PAWL SERVICE CAu TIo N: EYE PRoTECTIo N SHou LD BE WoRN WHILE oPERATING SWEEPER IMPo RTANT: Do not remove both wheels at the same time to avoid mixing parts. (The R.H. and L.H. ratchet gears are not interchangeable.) Make notes on the position DuMPING oF SWEEPER of washers and snap rings during disassembly. 1. Remove only one wheel from the sweeper. To dump sweeper hopper bag, simply tip the sweeper forward 2. Remove the retaining rings and washers which hold or lift off the co
ページ7に含まれる内容の要旨
BRuSH REPLACEMENT 1. Remove the hopper bag from lawnsweeper. 2. Brush replacement should be done one brush at a time. 3. Tip the sweeper forward on housing for ease of brush replacement. Do not remove hex bolt from double brush retainers through brush shaft. 4. Loosen hex bolts and hex lock nuts from single brush retainers . See figure 13. Slide br ush out of retainers , making not of over-lap bristles position. 5. Install new brush, making sure over-lap bristles are postioned the same a
ページ8に含まれる内容の要旨
REPAIR PARTS FoR 45-02181 26" LEAF/LAWNSWEEPER 8
ページ9に含まれる内容の要旨
REPAIR PARTS FoR 45-02181 26" LEAF/LAWNSWEEPER REF. PART REF. PART No. No. QTY. DESCRIPTIoN No. No. QTY. DESCRIPTIoN 1 44600 1 Housing 28 44125 4 Flat Washer, .62 x 1" 2 23784 1 Height Adjustment Plate 29 44687 2 Plastic Cap, .207 3 44286 4 Bolt, Hex 10-32 x 5/8" 30 1650-21 4 Retaining Ring, .594 4 43681 1 Bolt, Carriage 5/16-18 x 1-1/2" 31 23782 1 Brush Shaft 5 44680 1 Washer, Nylon 32 43661 4 Bolt, Hex 1/4-20 x 1" 6 1543-69 1 Washer, Nylon 21/64 33 43013 8 Lock Nut, 1/4-20 7 446
ページ10に含まれる内容の要旨
NoTES 10
ページ11に含まれる内容の要旨
NoTES 11
ページ12に含まれる内容の要旨
the fastest way to purchase parts www.speedepart.com REPAIR PARTS Agri-Fab, Inc. 303 West Raymond Sullivan, IL. 61951 217-728-8388 www.agri-fab.com This document (or manual) is protected under the U.S. Copyright Laws and the copyright laws of foreign countries, pursuant to the Universal Copyright Convention and the Berne convention. No part of this document may be reproduced or transmitted in any form or by an means, electronic or mechanical, including photocopying or recording, or by any i
