ページ1に含まれる内容の要旨
User’s Manual
3009VNM-M 36” Free Standing Electric Range -
User’s Manual
ページ2に含まれる内容の要旨
Congratulations on the purchase of your A A A AE E E EG G G G appliance. We are sure it will provide many years of great cooking experience. You may find that it has different features and characteristics to your last appliance. It is essential you read this operation manual thoroughly to fully understand all of the various functions and operations. Experiment with your cooking and take advantage of the features your new appliance offers. This manual should be retained for fu
ページ3に含まれる内容の要旨
A - Installation instructions check and warnings IMPORTANT: Please ensure that the cavity, venting and wiring is as specified in the relevant section J of this manual. A licensed electrician with relevant qualifications must perform electrical work when installing or servicing the appliance. The supply cable and fuse rating must be suitable for the appliance. You must never repair or replace any part of the appliance unless specifically recommended in the operation manual.
ページ4に含まれる内容の要旨
RECOMMENDED VENTILATION HEIGHT - for ceramic cooktop model min. 24” above range - for gas cooktop model min. 30” above range When ranges are installed in close proximity to vinyl finish cabinets, those materials should be able to withstand temperature up to 75°C centigrade. Alternatively, heat insulating barriers should be installed to avoid any deterioration to the finish. The equipment must not be installed near inflammable materials, such as curtains, cloths e
ページ5に含まれる内容の要旨
REGULATING THE MINIMUM OUTPUT OF THE HOB BURNERS Normal/valve taps: Ignite the burners and turn the knob to the maximum position. Remove the knob and insert a small flat-head screwdriver into the rod or through the holes on the side of the control panel, in accordance with the type (fig. 8 A/B). Loosen the by-pass screw by two turns in an anti-clockwise direction and rotate the rod to the minimum position. Adjust the previously loosened screws until the flame is lowered but stable, e
ページ6に含まれる内容の要旨
DO NOT LIFT COOKER BY THE FRONT DOOR AS THIS WILL DAMAGE THE OVEN The operations indicated below must be followed by qualified personnel, in conformity with the regulations in force. The supplier refuses all responsibility for damages to person or property, resulting from the failure to comply with such provisions. The appliance is designed to be used near heat resistant pieces of furniture or kitchen cabinetry only. ELECTRICAL CONNECTIONS (FIG.7) Before carrying out electric
ページ7に含まれる内容の要旨
b) For free standing: A non-metallic flexible pipe can be used as long as it complies with current standards and the following installation instructions are observed: the pipe must be longer than 400 mm and shorter than 1500 mm; it must not exceed 50°C in any point; it is not pulled or twisted; it cannot be choked and the entire edges, sharp corners or other similar hazards. Before connecting the non-metallic flexible pipe, the brass adapter and gasket supplied with the coo
ページ8に含まれる内容の要旨
640 mm 640 mm B - Cooker Measurements ( 900x640x925 ) Measurements Please note that all dimensions provided are in millimeters (mm.) The sizes allow for only a small degree of error so all cut-outs must be precise and square If the range is placed on a base, measures have to taken to prevent the appliance slipping from the base C – Electrical requirements WARNING: All aspects of the installation must conform with the requirements of the standard Nor
ページ9に含まれる内容の要旨
WARNING: A licenced electrician must connect the armour cable and 3 wires into the electrical connection box. The white, or Neutral wire is not used, and must be capped using a marette. To avoid power borne interference, this appliance must be installed individually on a separate and distinct final sub-circuit. Note: To the electrician – please ensure sufficient supply cable is provided to allow the appliance to be removed from the cavity should any servicing be necessary. This wil
ページ10に含まれる内容の要旨
D – USING THE APPLIANCE FOR THE FIRST TIME After installation remove all notification labels (not identification or warning labels) and packaging materials. After cleaning make sure cleaned surfaces are thoroughly rinsed and wiped dry using a clean, soft cloth. Power on NOTE: oven will not operate unless the clock is set. When power is first applied the display will flash and shows 00:00. The time of day is displayed in digital 24 hours format (e.g.: 18:00 is 6:00 pm).
ページ11に含まれる内容の要旨
Wear proper apparel when using the appliance Loose fitting, hanging or highly flammable garments (such as synthetics) should never be worn while using the appliance. Use only dry pot holders Moist or damp pot holders on hot surfaces may result in burns from steam. Do not allow pot holder to touch hot heating elements. Do not use a towel or bulky cloth when handling hot cooking utensils in the appliance. Oven compartments must never be used for storage Items, particularly flammable
ページ12に含まれる内容の要旨
E - Accessories Your appliance should come equipped with the following items. • 1 x pair of Retractable Slide Runners fitted to upper position and capable of being moved to any selected position as required • 1 x Deep Enameled Roasting Pan with dual height reversible Grill Rack insert – ready for sliding into side rack positions or fitting onto Retractable Slide Runners • 2 x Wire Oven Shelves that can be fitted into Retractable Slide Runners or for sliding into side rack positi
ページ13に含まれる内容の要旨
F - Electronic Programmer Operation The 24 hour clock allows the setting of automatic cooking options up to 24 hours in advance. 1 - Minus Time Button 2 Mode (Countdown Timer with Alarm, Cooking duration, Finish Cooking) 3 + Plus Time Button Setting the time on the 24 hour clock IMPORTANT – NOTE FOR NEW INSTALLATION AND FIRST OPERATION 1- The clock will require setting when you first turn on the power (or following a power failure). 2- At power on, the relay contact is
ページ14に含まれる内容の要旨
Adjusting the tone of the electronic timer alarm. THE TONE There are 3 different tones from which you can select. To change the tone you press the “+” and “-“ simultaneously, then press the Mode button, ONCE ton will be displayed. Pressing the “-“ button while ton is in the display, will change the tone to the desired setting, then press the mode button once. The electronic timer will store in its memory the last tone activated Manual cooking Once the time of day is set the POT sy
ページ15に含まれる内容の要旨
If further cooking is required, either leave on manual or repeat the above setting sequence. Note: If you have not turned the function and thermostat setting off, your oven will now continue to operate manually. The AUTO symbol will disappear and the POT symbol will reappear. Fully automatic – (Start Later – Stop Later) Your oven may be programmed to start, cook for the desired time and turn off automatically. This function is particularly useful in the preparation of the evening meal
ページ16に含まれる内容の要旨
G - Gas Cooktop Control Panel 4 1 1 2 3 1= semirapid burner 2= rapid burner 3=auxiliary burner 4= wok burner Technical Characteristic table NOMINAL NORMAL INJECTOR TAP BY PASS BURNERS HEAT INPUT GAS PRESSURE DIAMETER DIAMETER MAX. mbar 1/100 mm 1/100mm N° DESCRIPTION MJ/h(bTU/H) PROPANE 28 72 35 1 SEMI-RAPID
ページ17に含まれる内容の要旨
H - Gas Cooktop Functions B - Cooking Instructions Automatic start-up with valves Turn the corresponding knob anticlockwise up to the maximum position and press the knob. Once the burner has been started up, keep the knob pressed for about 6 seconds. Using the burners In order to obtain the maximum yield without wasting gas, it is important that the diameter of the pot is suitable for the burner potential (see the following table and fig.1). This is to avoid the flame extremiti
ページ18に含まれる内容の要旨
I - Ceramic Cooktop Control Panel Switch controlling the left, Switch controlling Switch controlling Switch controlling the central, Switch controlling back hot plate. the right, front the left, front hot plate. the right, back Turning the knob clockwise hot plate. Turning the knob clockwise hot plate. activates the full hot plate. activates the full hot plate. To operate Single (inner zone) and separate Dual (inner + outer zone) follow this procedure: a/ Inner
ページ19に含まれる内容の要旨
L - Ceramic Cooktop Functions WARNING --If the surface is cracked, switch off the appliance to avoid the possibility of electric shock, for hob surface of glass-ceramic or similar material which protect live parts -- During the use the appliances becomes hot. Care should be taken to avoid touching heating elements of cooktops and inside the oven. Accessible parts may become hot during use. Young children should be kept away. All operations relative to installation and el
ページ20に含まれる内容の要旨
M - Oven Functions & Control Panel Control Panel: Warming Drawer : This switch is controlling the warming element in the drawer (200 watt) The warming drawer element heats continuously until it reaches 75 Degrees C and this temperature will be maintained throughout the warming process as required. -- During the use the appliances becomes hot. Care should be taken to avoid touching heating elements of cooktops and inside the oven. Accessible parts may beco
