ページ1に含まれる内容の要旨
JLBIWD 1400
Built-in 1400 spin washer-dryer
Instruction manual
'($$
-$/
#$.
#$$
0$.
%$$ "
0$.
&$$
($.
($.
!
-$. -$.
,
0$.
-$.
($. ($.
-$. ($.
($. ($.
)*+"'($$
,
ページ2に含まれる内容の要旨
Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety. You MUST read them carefull
ページ3に含まれる内容の要旨
Contents Select the desired programme/temperature 20 Important Safety Information 2 Select the spin speed or the “Rinse hold” option 20 Your New Washer-Dryer 4 Select the desired options 20 Description of the Appliance 5 Select the “Delay start” 20 Detergent dispenser drawer 5 Start the programme 20 Child safety feature 5 How to change an option or a programme during its cycle 20 For the Installer How to interrupt a programme 21 How to open the door during Installation Instructions 6 the cycle
ページ4に含まれる内容の要旨
Your New Washer-Dryer Your new washer-dryer, which is fitted with the Jet System, meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. Even small loads are washed “economically” because the amount of water used is regulated automatically according to the load and type of fabric. ● The programme progress display shows the programme steps selected, the programme phase which is running and the end of the programme. ● The programme selec
ページ5に含まれる内容の要旨
Description of the Appliance 1 Detergent dispenser drawer 2 Control panel 3 Door opening handle '($$
#$$ -$/
#$. 0$. %$$ " 0$. &$$ ($. ($. ! -$.
-$. , -$. 0$. ($. ($. 4 Filter -$. ($. ($. ($. )*+"'(
ページ6に含まれる内容の要旨
Installation Instructions It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. Technical Specifications DIMENSIONS Height 82
ページ7に含まれる内容の要旨
Unpacking Set the machine upright and remove the two remaining All transit bolts and packing must be removed bolts from the back. before using the appliance. Pull out the three plastic spacers from the holes into which the bolts were fitted. You are advised to keep all the packaging for re-use in Plug the open holes with the plugs supplied with the case the machine is to be transported again. instruction booklet. Using a spanner unscrew and remove the rear right bolt. Lay the machine gently on i
ページ8に含まれる内容の要旨
Building-in This appliance has been designed to be built into the kitchen furniture. The recess should have the dimensions shown in picture A.
a) Door The dimensions of the door should be: - width 595-598 mm - thickness 16-22 mm The height (C-Fig. C) depends on the height of the adjacent furniture's base. When installing the appliance into the kitchen furniture ensure, if possible, the hoses are placed in either of the
two
ページ9に含まれる内容の要旨
c) Mounting the door Recommendations regarding Fix the hinges (1) to the machine by means of the the construction and fitting of M5x15 screws (3-Fig. B). The hinges can be adjusted to a base when the installation compensate for possible uneven thickness of the door. To align the door perfectly it is necessary to loosen the requires an integrated screw (3-Fig. B), adjust the door and tighten the screw appliance to be raised again. Where the appliance has been raised by mounting onto a wooden base
ページ10に含まれる内容の要旨
Position the base into the recess with its front edge as Water inlet far forward as the adjoining plinth line will allow. Connect the hose to a tap with a 3/4” thread. The reason for placing the base in this position Always use the hose supplied with the appliance to is to allow a small strip of beading to be fitted in connect to the water supply. front of the appliance feet. Do not use previously used hoses for water connection. Fix the base firmly to the floor using four appropriate countersu
ページ11に含まれる内容の要旨
If your drain hose looks like this (see below) you do Water drainage not require the “U” piece”. Just push the hose firmly This appliance is designed to be permanently plumbed into the standpipe. into your home's drainage system using one of the following methods. 1. Into a drainage standpipe. Firstly form a hook in the end of the drain hose using the “U” piece” supplied. 2. Onto a sink outlet spigot. ,)" %! If the outlet spigot has not been used before, remove any blan
ページ12に含まれる内容の要旨
Levelling In the interest of the environment Level the washing machine by raising or lowering the Washing machines and dishwashers should be feet. The feet may be tight to adjust as they incorporate connected to the FOUL drainage system, the water will a self locking nut, but the machine MUST be level and then be taken to a sewage works for treatment before stable (check diagonally). being discharged safely into a river. &'() -./ ,&-%(, *+, *-0(, '+ -.1 2+-.( 0- '+ () )+-.'+,() An
ページ13に含まれる内容の要旨
The rating plate is located at the top of the rim of the Upon completion there must be no cut, or stray open door. strands of wire present and the cord clamp must be secure over the outer sheath. WARNING: A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely. Should the appliance power supply ' 9 0 cable neeed to be replaced, this
ページ14に含まれる内容の要旨
The Control Panel '($$
-$/
#$. #$$ 0$. %$$ " 0$. &$$ ($. ($. ! -$.
-$. , 0$. -$. ($. ($. -$. ($. ($. ($. )*+"'($$ To empty out water there are 2 possibilities: 1 Dete
ページ15に含まれる内容の要旨
If you have already pressed the “Start/Pause” button, “Quick”: select this option for laundry that is only and you wish to cancel the delay time, proceed as slightly soiled in order to obtain a good wash result in follows: a short time. This option is not available with the Wool set the machine to PAUSE by pressing the programmes, the Energy saving programmes “Start/Pause” button; “Economy” and “30 Minute wash”. press the “Delay start” button until the symbol “0 0’ ’ ” The washing time
ページ16に含まれる内容の要旨
(If, at the end of a washing cycle, the programme After starting the programme, the remaining time is selector dial has not been turned to “Off” position , updated every minute. when you press the “On/Off” button to switch the Important! machine on for the next washing, the display will show If you select a drying time longer then 55’ minutes, a blinking zero.) after 3 seconds, the display will show it in hours and minutes (see the example below). Example: ! ! Du
ページ17に含まれる内容の要旨
An incorrect option selection has been made: Important! this is indicated by the message Err when a function If you turn the programme selector dial to another incompatible with the current programme is selected. programme when the machine is working, all the lights of the programme progress display will flash for about 2 seconds but the machine will not perform the new selected programme. 12 Programme selector dial The programme selector dial is divided into the following sections: Cottons,
ページ18に含まれる内容の要旨
Programme information Important! Easy iron 40° The spin speed will automatically assume the setting for With this programme at 40°C it is possible to wash cotton items. If required, reduce the speed to the synthetic garments which must be ironed. The laundry desired level by depressing the "Spin" button. is gently washed and spun to prevent the fabrics from creasing. Max. load 1 kg. Softeners Final spin speed 900 r.p.m. Hand washed garments can be be starched or softened Soak 30° with this pro
ページ19に含まれる内容の要旨
Operating Sequence Before the first wash, we recommend that you run a cotton 4. Switch the machine on cycle at 90°C, without any laundry in the machine, to To switch the machine on, press the ON/OFF button: remove any manufacturing residue from the drum and tub. the mains-on light comes on. To switch the appliance Pour 1/2 a measure of detergent into the dispenser drawer off, depress the same button. and start the machine. WASHING 5 KG OF WHITE COTTON AT 90°C Suppose you have 5 kg of laundry to
ページ20に含まれる内容の要旨
The selected delay time value (up to 23 hours) will 6. Select the spin speed or the appear on the display for 3 seconds, then the duration “Rinse hold” option of the programme will appear again. Press the “Spin” button repeatedly in order to select the desired spin speed or the “Rinse hold” option. If you select the “Rinse hold” option, the machine will stop at the end of the programme with the water still in the tub. The relevant light will light up. '($$ #$$ %$$ &$$ Duri
