ページ1に含まれる内容の要旨
D1361/D1364 Series User's Guide
What's in the box? You may also find:
Accessory handset
D1361/
and charger
D1364 base
with Caller ID Not pictured:
and cordless
x Rechargeable
handset
battery (BT-1021)
x Battery cover
x AC adapter
(PS-0035)
If you purchased
You should have:
Not pictured:
model number...
x Rechargeable battery (BT-1021)
D1364 None
x Battery cover
D1364-2 1 of each
x AC adapter (PS-0035)
D1364-3 2 of each
x Telephone cord
x If any items are missing or damaged, contact our Cus
ページ2に含まれる内容の要旨
TABLE OF CONTENTS What’s in the manual? Global Setup Menu..................7 Using Your Phone ....................... 7 Getting Started ........................... 3 Basics .......................................... 7 Installing Your Phone .................. 3 Changing the Volume ..................7 Charge the Battery ......................3 Using the Phonebook, Caller ID, Connect the Telephone Cord ......3 and Redial Lists ........................ 7 Test the Connection ...................
ページ3に含まれる内容の要旨
GETTING STARTED Installing Your Phone Charge the Battery 1. Unpack the handset, battery pack, and battery cover. If you need to remove the cover, press in on the notch and slide the cover down and off. 2. Line up the battery connector with the jack inside the handset; the connector only fits one way. 3. Push the connector in until it clicks into place; tug gently on the wires to make sure the battery pack is securely connected. 4. Replace the battery cover and slide it into place. 5. Use the
ページ4に含まれる内容の要旨
GETTING TO KNOW YOUR PHONE Earpiece Status FIND Display HANDSET UP CLEAR MENU/SELECT PHONEBOOK/ CALLER ID/LEFT LEFT END TALK/ FLASH DOWN Twelve- CHARGING key dial CONTACTS pad Base REDIAL/ PAUSE MESSAGES Key What it does MUTE Microphone FINd x In standby: page the handset. Charging contacts Handset Key (icon) What it does x In standby: increase the ringer volume. x During a call: increase the volume. up ( ) x In any menu or list: move the cursor up one line. x When entering text or numbers:
ページ5に含まれる内容の要旨
Key (icon) What it does x In standby: open the menu. MENu/SELECT x In any menu or list: select the highlighted item. CALLEr Id/rIghT x In standby or during a call: open the Caller ID list. x During a call: hang up. ENd x In any menu or list: exit and go to standby. x In standby: decrease the ringer volume. x During a call: decrease the volume. dON w ( ) x In any menu or list: move the cursor down one line. MESSAgES ( ) x In standby: access your voice mail service. LED What it means x On: the b
ページ6に含まれる内容の要旨
To... Press... switch between upper and lower case letters . * rotate through the punctuation and symbols 0. Using the Menu x If you don't press any keys Press MENU/SELECT to open the menu. for about thirty seconds, the Press MENU/SELECT to choose handset exits the menu. Handset Setup the current option. Date & Time Handset Setup Press T-coil PHONEBOOK to Handset Setup UP DOWN Use and to go back a screen Ringer Tones rotate through the Handset Setup OR options. press END to exit Auto
ページ7に含まれる内容の要旨
Global Setup Menu Menu Option What it does Dial Mode Choose tone or pulse dialing (see p. 3). Program your voice mail access number so you can get Edit Voice Mail messages by pressing one button (see p. 9). VMWI Reset Reset the Visual Message Waiting Indicator (see p. 9). USING YOUR PHONE Basics To... Press... make a call, dial the number, and TALk/FLASh . answer a call TALk/FLASh . hang up ENd or put the handset in the cradle. ignore a call (mute the ringer) MuTE while the phone is ringing. mu
ページ8に含まれる内容の要旨
To... Press... add 1 at the front of CID number before dialing for a toll call. * add the area code # before dialing. store the current CID or redial entry MENu/SELECT , then select Store Into PB. to the phonebook Proceed to edit the name and number. edit the current phonebook entry MENu/SELECT , then select Edit. MENu/SELECT , then select Delete (or delete the current entry Delete Entry). To confirm, select Yes. close the list phONEBOOk/LEFT . # When it’s in standby, the handset shows how m
ページ9に含まれる内容の要旨
Finding the Handset With the phone in standby, press FINd on the base. The handset will beep for 1 minute. To cancel, press FINd again or press any handset key. Voice Message Notification If you subscribe to a voice mail service, your phone displays the voice mail icon ( ) when you have a new message. After you listen to your messages, the message icon turns off. If it doesn’t, you can reset it: With the phone in standby, open the menu and select Global Setup; select VMWI Reset, then selec
ページ10に含まれる内容の要旨
TROUBLESHOOTING Problems Possible solutions x Check the telephone cord connection. I can’t make or receive x Disconnect the base AC adapter. Wait a few minutes, calls. then reconnect it. x Make sure the base is plugged in. The handset won’t ring. x Make sure the ringer is turned on. x Charge the battery for 15-20 hours. The handset is not working. x Check the battery connection. x Let calls ring twice before answering. The handset won’t display CID information. x Make sure your CID service
ページ11に含まれる内容の要旨
x As part of our commitment to protecting our Adapter and Battery Information environment and conserving natural AC adapter resources, Uniden Part number PS-0035 voluntarily participates in ® an RBRC industry Input voltage 120V AC, 60 Hz program to collect and Output voltage 8V AC @ 300mA recycle used Ni-MH batteries within the Battery pack (with normal use) United States. Please call 1-800-8-BATTERY for information on Part number BT-1021 Ni-MH battery recycling in your area. Capacit
ページ12に含まれる内容の要旨
compliant. See installation instructions for If your home has wired alarm equipment details. connected to a phone line, be sure that installing the system does not disable your The REN is used to determine the number of devices that may be connected to a phone alarm equipment. If you have questions about what will disable alarm equipment, line. Excessive RENs on a phone line may result in devices not ringing in response contact your telephone company or a qualified installer. to an incom
ページ13に含まれる内容の要旨
x Increase the separation between the connected to a telephone interface. The equipment and receiver. termination on an interface may consist of any combination of devices subject only to x Connect the equipment into an outlet on a circuit different from that to which the the requirement that the sum of the Ringer Equivalence Numbers of all the devices receiver is connected. does not exceed 5. x Consult the dealer or an experienced radio/ TV technician for help. Radio equipment The term IC
ページ14に含まれる内容の要旨
warranty at any time while this PROCEDURE FOR OBTAINING warranty is in effect, warrantor will PERFORMANCE OF either, at its option, repair or replace WARRANTY: If, after following the the defective unit and return it to you instructions in the owner's manual without charge for parts, service, or you are certain that the Product any other cost (except shipping and is defective, pack the Product handling) incurred by warrantor or carefully (preferably in its original its representatives in
