ページ1に含まれる内容の要旨
Installing Front Riggings on the At’m
Assembly, Installation and Operating Instructions
Kit Numbers: 9153644014, 9153644018
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact
Carrier/Invacare for further instructions.
Safety Summary
To ensure the safe and proper installation and use of the front riggings on the At’m, these
instructions MUST be followed:
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
ページ2に含まれる内容の要旨
4. Insert the proper (right or left) front rigging support bracket into the seat frame tube until two (2) of the four (4) mounting holes on the front rigging support bracket are aligned with the two (2) mounting holes in the seat frame tube. CAUTION Two (2) mounting screws are used to secure the front rigging support bracket to the seat frame tube for any mounting position used. 5. Install the existing mounting screw, coved washers, spacers, washers and locknut that secure front seat support
ページ3に含まれる内容の要旨
Installing/Removing the Front Rigging Assembly NOTE: For this procedure, refer to FIGURE 2. Installing 1. Turn the front rigging assembly to the side (open footrest is perpendicular to the wheelchair). 2. Insert the mounting pin on the front rigging assembly into the front rigging support bracket. 3. Rotate the front rigging assembly towards the inside of the wheelchair until it locks into place. NOTE: The footplate will be facing the inside of the wheelchair when locked in place. 4. Repeat S
ページ4に含まれる内容の要旨
Adjusting Footrest Height NOTE: For this procedure, refer to FIGURE 3. 1. Remove the front rigging assembly. Refer to Installing/Removing the Front Rigging Assembly on page 3. 2. Remove the hex screw and coved spacer. 3. Move the footrest with slide tube up or down on its mounting tube until the desired footrest height is achieved. 4. Install the hex screw and coved spacer through the front rigging upper support and the slide tube. Securely tighten. 5. Install the front rigging assembly. Refe
