ページ1に含まれる内容の要旨
SAVE THESE INSTRUCTIONS
3. Remove the back canes. Refer to REMOVING/IN-
NOTE: Check all parts for shipping damage. In case of
STALLING THE BACK CANES in PROCEDURE 5
damage, DO NOT use. Contact Carrier/Invacare for fur-
of the Service Manual, part number 1085787.
ther instructions.
4. Remove the allen screw, spacer and locknut that
ページ2に含まれる内容の要旨
2. Align the mounting holes of the contracture footplate DETAIL “A” assembly with two (2) desired mounting positions of the crossmember assembly. Seat Frame 3. Secure the contracture assembly to the crossmember Seat Frame assembly with two (2) mounting screws, washers and (Rear) locknuts provided. Securely tighten. 4. If necessary, repeat STEPS 1-6 for the other con- tracture assembly. Washers Bearing Housing Lock Nuts Lower Seat Frame Mounting Holes Shoulder Screw Insert Tube Contracture Assemb
ページ3に含まれる内容の要旨
CONTRACTURE ASSEMBLY ANGLE ADJUSTMENT (FIGURE 4) Angle Adjustment Bracket NOTE: Refer to the GENERAL WARNINGS and INSTAL- LATION WARNINGS in the SAFETY SUMMARY of this instruction sheet. Pop Rivet 1. Remove the mounting screw and locknut used to lock Button Contracture the angle adjustment of the contracture assembly. Support Quick Release Pin 2. Lift the contracture support UP/DOWN to achieve the desired angle. FIGURE 5 - USING THE OPTIONAL QUICK 3. Align the mounting hole in the contracture s
ページ4に含まれる内容の要旨
4. Secure the footplate bracket to the contracture sup- CONTRACTURE FOOTPLATE port with the mounting screw, two (2) coved washers, DEPTH ADJUSTMENT (FIGURE 7) washer and locknut. Securely tighten. NOTE: Refer to the GENERAL WARNINGS and INSTAL- 5. If necessary repeat STEPS 1-4 on remaining con- LATION WARNINGS in the SAFETY SUMMARY of this tracture footplate. instruction sheet. Contracture Support NOTE: Observe the angle of the contracture footplate for Mounting reinstallation. Holes 1. Remove t
