ページ1に含まれる内容の要旨
Instructions for
WASHING MACHINE
installation and use
Contents
EN
Installation, 2-3-4-5
EN
Unpacking and levelling
Connecting the electricity and water supplies
English,1
Technical data
Care and maintenance, 6
Cutting off the water and electricity supplies
Cleaning the machine
Cleaning the detergent dispenser drawer
Caring for your appliance drum
Cleaning the pump
Checking the water inlet hose
Precautions and tips, 7
General safety
Load balancing system
Disposal
Opening the porthole door manual
ページ2に含まれる内容の要旨
Installation ! This instruction manual should be kept in a ! If the appliance is levelled correctly, it will EN safe place for future reference. If the washing be more stable and much less likely to cause machine is sold, given away or moved, please vibrations and noise while it is operating, ensure the manual is kept with the machine, particularly during the spin cycle. so that the new owner may benefit from the ! If it is placed on carpet or a rug, adjust the advice contained within it. fe
ページ3に含まれる内容の要旨
65 - 100 cm Connecting the drain hose • the socket is compatible with the washing EN machine’s plug. If this is not the case, replace Connect the drain the socket or the plug. hose, without bending it, to a Your appliance is now supplied with a 13 amp draining duct or a fused plug it can be plugged into a 13 amp wall drain situated socket for immediate use. Before using the between 65 and 100 appliance please read the instructions below. cm from the floor; WARNING - THIS APPLIANCE
ページ4に含まれる内容の要旨
As the colours of the wires in the lead may ! The power supply cable must only be EN not correspond with the coloured markings replaced by an authorised serviceman. identifying the terminals in your plug, proceed as follows: Warning! The company denies all liability if and Connect Green & Yellow wire to terminal when these norms are not respected. marked E or or coloured Green or Green & Yellow. Connect Brown wire to terminal marked L or coloured Red. Connect Blue wire to terminal marked N
ページ5に含まれる内容の要旨
Technical data EN Model AQ113DA 697 E width 59.5 cm Dimensions height 85 cm depth 64,5 cm Capacity from 1 to 11 kg Electrical please refer to the technical connections data plate fixed to the machine maximum pressure 1 MPa (10 bar) Water con- minimum pressure nections 0.05 MPa (0.5 bar) drum capacity 71 litres up to 1600 rotations per Spin speed minute Test wash cycles in accordan- programme ; ce with Cotton Standard 60°C. directives programme ; 1061/2010 Cotton Standard 40°C. and 1015
ページ6に含まれる内容の要旨
Care and maintenance To access the pre-chamber: Cutting off the water and EN electricity supplies • Turn off the water tap after every wash cycle. 1 This will limit wear on the hydraulic system in the machine and help to prevent leaks. • Unplug the appliance when cleaning it and 2 during all maintenance work. Cleaning the machine 1. take off the cover panel on the front of the machine by first pressing it in the centre and The outer parts and rubber components of the then pushing downwar
ページ7に含まれる内容の要旨
Precautions and tips ! The machine was designed and constructed in inside the machine, while preventing potential damage EN accordance with international safety regulations. The to the atmosphere and to public health. following information is provided for safety reasons and The crossed-out dustbin is marked on all products must therefore be read carefully. to remind the owner of their obligations regarding separated waste collection. General safety For more information relating to the corre
ページ8に含まれる内容の要旨
Description of the machine CONTROL EN PANEL PORTHOLE DOOR PORTHOLE DOOR HANDLE KICK STRIP PORTHOLE DOOR washing additives compartment: for fabric softener Always use the handle to or liquid additives. We recommend that the maximum open the porthole door (see level indicated by the grille is not exceeded, and that figure). concentrated fabric softeners are diluted. TOUCH CONTROL PANEL To adjust the settings, gently press the icon inside the sensitive (touch control) area as illustrate
ページ9に含まれる内容の要旨
START/PAUSE button Touch control panel EN with indicator light SPIN WASH button CYCLE WASH CYCLE M1 ECO PHASE M2 TEMPERATURE SELECTOR knob indicator light button icons DISPLAY CHILD LOCK button OPTION Button with ON/OFF with indicator light M3 DELAYED START buttons indicator light button LOCK indicator light lit in a fixed manner. To pause the wash cycle, press the Button with ON/OFF indicator light: press this briefly button again; the indicator light will flash in an orange co
ページ10に含まれる内容の要旨
Running a wash cycle WARNING: before you use the washing machine for the remaining until the end of the cycle. To remove the EN first time, run a wash cycle with detergent and no laundry, delayed start option, press the button until the display using the 90° cottons cycle. shows the text OFF; the symbol will disappear. 1. SWITCH THE MACHINE ON. Press the button. All Modify the cycle settings. the indicator lights will illuminate for 1 second and the • Press the button to activate the
ページ11に含まれる内容の要旨
Wash cycles and options Table of wash cycles EN Detergent and additives Max. Max. Description of the wash cycle temp. speed (°C) (rpm) Synthetics Resistant 60° 800 5 48 1,20 74 120’ Synthetics Resistant (3) 40° 800 5 48 0,70 72 100’ Whites 60° 1600 6 - - - 190’ 44 0,99 92 125’ Coloureds 40° 1600 6 Darks 30° 800 6 - - - 80’ Steam Refresh - - - - 2 - - - 20’ - - - 145’ Duvets: for down-stuffed garments. 30° 1200 3,5 Bed&Bath for bedlinen and towels. 60° 1600 11 - - -
ページ12に含まれる内容の要旨
Detergents and laundry programme “ “. At the end of the cycle, garments will be Detergent EN relaxed and fragrant. The type and quantity of detergent required depend on ! Not recommended for wool or silk garments. the type of fabric you are washing (cotton, wool, silk, etc.), ! Do not add too much perfume to the sponge in order to as well as its colour, the washing temperature, the level of avoid it dripping. soiling and the hardness of the water in the area. ! Do not add softeners or dete
ページ13に含まれる内容の要旨
Trouble shooting Your washing machine could occasionally fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), EN make sure that the problem cannot be solved easily using the following list. Problem: Possible causes / Solutions: The machine does not switch on. • The appliance is not plugged into the socket fully, or not enough to make contact. • There is no power to the socket, or the fuse has blown in the mains plug. The wash cycle does not start. • The door is no
ページ14に含まれる内容の要旨
The machine is noisy. • There will always be some motor, pump and drum noise during spin. EN The machine wont spin properly. • Out of Balance detected when attempting to go into a spin cycle - If this happens the machine will continue to try to repeat the distribution of the load required before the machine will go into higher spin speeds - This will increase the programme time accordingly. This is a safety feature to prevent damage. Out of Balance can be caused by washing a single heavy it
ページ15に含まれる内容の要旨
Assistance Guarantee EN 12 Months Parts and Labour Guarantee Your appliance has the benefit of our manufacturer’s guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you. This guarantee is subject to the following conditions:
ページ16に含まれる内容の要旨
195109038.00 11/2012 - Xerox Fabriano After Sales Service EN No one is better placed to care for your Hotpoint appliance during the course of its working life than us - the manufacturer. Essential Contact Information Hotpoint Service We are the largest service team in Europe offering you access to 400 skilled telephone advisors and 1000 fully qualified engineers on call to ensure you receive fast, reliable, local service. UK: 08448 224 224 Republic of Ireland: 0818 313 413 www.hotpointserv
