ページ1に含まれる内容の要旨
User's manual
WM6002A
Computerized Full-auto
Washing Machine
TWO DRIVE
TWO 50% CONSUMPTION SAVER
CONTENTS
Before using
Names of the parts.............the 2nd cover
Safety precautions .............................................1
Installation and adjustment .........................3
Install the water inlet hose............5
Using process
Preparation before washing ...............7
Put in the laundries .............................8
Put in the detergent ............................9
Use the o
ページ2に含まれる内容の要旨
Before Using Before Using Names of the parts Top lid component water inlet valve rear faceplate Inner cover component front control board water absorption round cover Detergent box cushion Control pannel power cord Outer tub cover Lint filter fixing cabinet handle Balance ring Inner tub Lint filter drain hose hang- Filter cover ing hole Pulsator drain hose Attachment block (3 pieces) Cabinet standby screws Liquid whitener inlet and nut for earth- Fixed leg (3 pieces) ing wire Adj
ページ3に含まれる内容の要旨
Before Using Before Using Safety precautions In normal usage of the washing machine, the power Please plug the plug on special 220-240V AC receptacle. plug shall be ready to be pulled or plugged with hand. Be sure to use three phase power receptacle.Ensure Be sure to pull the plug off and close the water faucet the earthing prong of the power receptacle is earth- when occurring power failure,delivering the machine, ed reliably.Use leakage protector if possible. setting the machine idle or
ページ4に含まれる内容の要旨
Before Using Before Using Safety precautions Do not put hand into the rotating tub.It is dangerous Do not decompose, repair or alter the machine by even if the rotation speed is slow. Take special care of yourself. the children. Keep children away from the washing machine to avoid them climbing on. Do not put any hot or heavy items (such as the Do not wash laundry with volatile materials kettle with hot water) on the washing machine. (such as thinner, petrol etc.). Benzene Keep
ページ5に含まれる内容の要旨
Before Using Before Using Installation and adjustment Please install and adjust the machine according to the requirement of the mannual. It is very important to your security and correct operating the machine. Install the inner cover and lint filter 1.Open the top lid of the washing machine. Outer tube cover 2.Put the inner cover component on the outer tub cover, aiming the inner cover shaft to the installation hole of the corresponding Inner cover shaft outer tub cover shaft g
ページ6に含まれる内容の要旨
Before Using Before Using How to change the direction of the drain hose 1. Dismount the back cover of the washing machine. 3. Dismount the protecting cover of the drain 2. Put down the drain hose. Take off the drain hose outlet at the other side ( method the same as frame. As indicated in Figure 1, put the drain hose the drain hose bushing). Install the drain hose into the cabinet. Then put one hand into the cabinet bushing as per indicatedin Figure 4. to nip the claw
ページ7に含まれる内容の要旨
Before Using Before Using Install the water inlet hose Confirm the water faucet water faucet, suitable water faucet, not suitable The exit end face of the faucet It is required that the front end shall be longer than 10mm. The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage. Connection between the water inlet hose jointer and the water faucet Use the new wat
ページ8に含まれる内容の要旨
Before Using Before Using Connection between the water inlet hose and the washer 1.Do not take off the water absorption cushion. Please check if the nut of the water cushion is dropped or damaged before each usage. If it happens inlet hose please contact our after-sale department immediately. 2 Put the nut of the water inlet hose on the valve jointer. 3 Fasten the nut. Swing it gently to confirm if it's suitable. water absorption jointer of the cushion. water inlet valve Connection betwe
ページ9に含まれる内容の要旨
Using process Using process 1 Preparation before washing Preparation before washing 1.Connect the water inlet hose. 2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3.Put down the drain hose. Pay attention to followings before washing the laundries Confirm if there's Clear the pocket. Fasten the buttons The quantity of the When the pulsator is special re
ページ10に含まれる内容の要旨
Using process Using process 2 Put in the laundries The capacity of washing of the machine refer to the largest weight of the standard laundries under dry condition that can be washed in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. The largest capacity of this machine is 6.0kg. The thickness ,size , type of the cloth will influence the actual washing capacity. It is suitable to put in reasonable amount of laundries and
ページ11に含まれる内容の要旨
Using process Using process 3 Put in the detergent Put the washing powder and softener into the detergent box directly as indicated in the left figure. Access for detergent and washing powder After that, please close the detergent box.Refer to the following list for the usage of the detergent : standard dosage of the detergent and the water quantity. Access for softerner How to use the washing powder Directly dissolved in the machine (not applicable for fuzzy program and reserve wash) Det
ページ12に含まれる内容の要旨
Minutes Minutes Times Water-saving Using process Using process 4 Use the operation buttons Description of the function of buttons Digital tube Mode and meaning of the indicators During sensing, it displays During operation of programs, it displays the remained time (minute) or remained times of Flashing: indicate the running program the corresponding procedure On: indicate the program about to run, or indicate the selected mode SOAK WASH RINSE SPIN “���� ” button “RINSE” button Push the soak
ページ13に含まれる内容の要旨
Start/Pause button “ ” selection button “ ” button “ ” button “CHILD LOCK” function Push and hold the water level button and spin button, then push down the power on/off button. The digitron displays CL . You can continue setting desired washing procedures. After setting, push down the start/pause button. The child lock function is activated. All of the buttons are locked and cannot make selection. Release the child lock function: push down the water level and spin button “�� �� ��
ページ14に含まれる内容の要旨
Minutes Minutes Minutes Minutes Water-saving Times Times Water-saving Minutes Using process Using process Steps of using the operation buttons and description of the steps POWER START ON/OFF PAUSE Minutes PROGRAM RESERVE + WATER CHILD LOCK LEVEL Push the "POWER ON/OFF " button to switch on the power. POWER ON/OFF Push the "PROGRAM " button to select suitable automatic program. 2 PROGRAM After switching on the power, the machine will set standard program automatically. To select other automatic
ページ15に含まれる内容の要旨
Using process Using process After switching on the power, the washing machine will set to common program including"wash, rinse, spin "automatically. To select other procedures, push the "SOAK", " WASH", " RINSE" or "SPIN" button to select the time of soak, wash and spin, and the times of rinse. After switching on the power, if you push one of the button among "WASH", "RINSE"and"SPIN", the digitron of the former proce- dures will turn off automatically. The former procedures will no
ページ16に含まれる内容の要旨
Time remianed (minutes) Using process Using process * Total time: including the normal water inlet time and drain time. The total washing time may be influenced by the water inlet pressure and water level. * Spin time: From the moment the intermittent spinning starts to the moment it stops running (the time displayed on spin digitron is from intermittent spinning to the moment before inertia spinning; the time displayed on the time remain digitron is the total remaining time) *
ページ17に含まれる内容の要旨
Using process Using process Disposal after washing After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Clean the detergent box and set it on the control panel seat. The lint filter must be used during washing. 1.The method of dismantle : Push it up aslant and gently. It must be cleaned in time after each using 2.The method of install
ページ18に含まれる内容の要旨
Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Phenomenan The reason How to settle Close the top lid. The top lid
ページ19に含まれる内容の要旨
Packing list Name Quantity Storage position Inside the document bag One User's manual Inside the document bag One Lint filter Components of the One Inside the accessory bag water inlet hose Between the upper cushion of the Bottom plate One washing machine package and the upper seal of the package carton Eight Tapping screws ST4x16-A Inside the accessory bag Inner cover component Inside the accessory bag One Computerized Automatic One washing machine
ページ20に含まれる内容の要旨
Specification Model WM6002A Rated voltage frequency 220-240V~ 50Hz Rated washing / spinning capacity 6.0kg (weight of standard dry cloth) 1/16L 2/20L 3/24L 4/28L 5/32L Water level/Water quantity (about) 6/38L 7/42L 8/45L 9/47L 10/50L About 75L(High water level; Standard program) Max water consumption Injection pressure
