ページ1に含まれる内容の要旨
FOR YOUR SAFETY
If you smell gas:
1. Open windows.
2. DO NOT try to light any appliance.
®
3. DO NOT use electrical switches.
4. DO NOT use any telephone in
your building.
5. Extinguish any open flame.
Blackheat
6. Leave the building.
7. Immediately call your local gas
supplier after leaving the building.
Vacuum Assisted
Follow the gas supplier’s
instructions.
8. If you cannot reach your gas
Linear, Double Linear,
supplier, call the Fire Department.
WARNING
U-Tube, and Mult
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
TABLE OF CONTENTS SECTION 1: Heater Safety............................................2 SECTION 11: Venting ..................................................50 1.1 Manpower Requirements ....................................2 11.1 General Venting Requirements .......................50 1.2 Safety Labels and Their Placement ....................2 11.2 Ventilation Requirements.................................50 SECTION 2: Installer Responsibility............................4 11.3 Outside Combustion A
ページ4に含まれる内容の要旨
ページ5に含まれる内容の要旨
TABLE OF FIGURES Figure 1: Side and Back Panel Label Placement............2 Figure 2: Top Panel Label Placement.............................3 Figure 3: Linear & Double Linear, Horizontal Mounts .....6 Figure 4: Linear & Double Linear, One Side Reflector....6 Figure 5: Linear & Double Linear, Two Side Reflectors..6 Figure 6: Linear & Double Linear, 45° Mount..................6 Figure 7: Linear & Double Linear, 2 Foot Deco Grille .....7 Figure 8: Linear & Double Linear, Protective Grille.........7
ページ6に含まれる内容の要旨
ページ7に含まれる内容の要旨
Product Approval
!
"#
$
%& !'
%
(
#
#
&) !
%
!# * #
#
+ * $
#, -
ページ8に含まれる内容の要旨
® BLACKHEAT INSTALLATION OPERATION AND SERVICE MANUAL SECTION 1: HEATER SAFETY Your Safety is Important to Us! components, have sharp edges. To prevent injury, the use of work gloves is recommended. The use of gloves will This symbol is used throughout the manual also prevent the transfer of body oils from the hands to to notify you of possible fire, electrical or burn the surface of the reflector. hazards. Please pay special attention when reading and following the warnings in these Befo
ページ9に含まれる内容の要旨
SECTION 1: HEATER SAFETY Figure 2: Top Panel Label Placement Top Panel Gas Connection Label Top Panel - Inside Door Description Part Number Gas Connection Label 91018126 Internal Wiring Label 91031401 Internal Wiring Label 3 of 75
ページ10に含まれる内容の要旨
® BLACKHEAT INSTALLATION OPERATION AND SERVICE MANUAL SECTION 2: INSTALLER RESPONSIBILITY 2.2 Corrosive Chemicals • To install the heater, as well as the gas and electrical CAUTION supplies, in accordance with applicable specifications and codes. Roberts-Gordon recommends the installer contact a local Building Inspector or Fire Marshal for guidance. •To use the information given in a layout drawing and in the manual together with the cited codes and regulations to perform the installation
ページ11に含まれる内容の要旨
SECTION 3: CLEARANCES TO COMBUSTIBLES • Consult local Building Inspector, Fire Insurance SECTION 3: CLEARANCES TO COMBUSTIBLES Carrier or other authorities for approval of proposed installation when there is a possibility of exposure to WARNING combustible airborne materials or vapours. • Hang heater in accordance to the minimum suspension requirements on Page 73, Section 18.6 through Section 18.8. • If the radiant tubes must pass through the building structure, be sure that adequate sleev
ページ12に含まれる内容の要旨
® BLACKHEAT INSTALLATION OPERATION AND SERVICE MANUAL 3.2 Clearance Data - Linear and Double Linear NOTE: 1. All dimensions are from the surfaces of all tubes, couplings, tees, elbows and crosses. 2. Clearances B, C and D can be reduced by 50% after 7500 mm of tubing downstream from the burner. 3. All measurements are in millimeters. FIGURE 3: LINEAR & DOUBLE LINEAR, HORIZONTAL MOUNTS A 150 150 150 150 150 150 200 200 B 890 970 970 1020 1170 1220 1280 1330 C 1570 1650 1650 1780 1930 197
ページ13に含まれる内容の要旨
SECTION 3: CLEARANCES TO COMBUSTIBLES NOTE: 1. All dimensions are from the surfaces of all tubes, couplings, tees, elbows and crosses. 2. Clearances B, C and D can be reduced by 50% after 7500 mm of tubing downstream from the burner. 3. All measurements are in millimeters. FIGURE 7: LINEAR & DOUBLE LINEAR, 2 FOOT DECO GRILLE A 150 150 150 150 150 150 200 200 B 890 970 970 1020 1170 1220 1280 1330 C 1570 1650 1650 1780 1930 1970 2010 2080 D 890 970 970 1020 1170 1220 1280 1330 FIGURE 8: L
ページ14に含まれる内容の要旨
® BLACKHEAT INSTALLATION OPERATION AND SERVICE MANUAL 3.3 Clearance Data -U Tube NOTE: 1. All dimensions are from the surfaces of all tubes, couplings, tees, elbows and crosses. 2. Clearances B, C and D can be reduced by 50% after 7500 mm of tubing downstream from the burner. 3. All measurements are in millimeters. 4. Add 60 mm clearance to uncovered U-tube. FIGURE 11: U-TUBE, HORIZONTAL MOUNT A 150 150 150 150 150 150 200 200 B 890 970 970 1020 1170 1220 1270 1380 C 1580 1730 1730 1910
ページ15に含まれる内容の要旨
SECTION 3: CLEARANCES TO COMBUSTIBLES NOTE: 1. All dimensions are from the surfaces of all tubes, couplings, tees, elbows and crosses. 2. Clearances B, C and D can be reduced by 50% after 7500 mm of tubing downstream from the burner. 3. All measurements are in millimeters. 4. Add 60 mm clearance to uncovered U-tube. FIGURE 15: U-TUBE, OPPOSITE 45° TILT A 200 200 200 250 250 275 300 300 B 1370 1530 1530 1630 1780 1830 1880 1930 C 1500 1650 1650 1860 1960 2040 2110 2160 D 560 560 560 560 5
ページ16に含まれる内容の要旨
® BLACKHEAT INSTALLATION OPERATION AND SERVICE MANUAL SECTION 4: MAJOR COMPONENT DESCRIPTIONS Burner (shown with Tube Reflector Gasket) (Aluminium or Must be installed with the Stainless Steel) flame observation window Alternate overlap as facing down. shown on overview. Minimum overlap is 160 mm. Burner Tube Fan Tube with Internal Swirler Tube Supplied in 3,000 mm lengths. Supplied in 3,000 mm lengths. Fan Heat treated aluminised tube Burner tube is always the first tube is always th
ページ17に含まれる内容の要旨
SECTION 5: GENERAL SUSPENSION DETAILS SECTION 5: GENERAL SUSPENSION DETAILS WARNING Severe Injury Hazard Secure burner to burner tube with bolts and lockwashers. Hang heater with materials with a minimum working load of 75 lbs (33 kg). Failure to follow these instructions can result in death, injury or property damage. WARNING Cut/Pinch Hazard Wear protective gear during installation, operation and service. Edges are sharp. Failure to follow these instructions can result in injury. To ensur
ページ18に含まれる内容の要旨
® BLACKHEAT INSTALLATION OPERATION AND SERVICE MANUAL Figure 18: Critical Hanger Placement & "
$%
#
! "
#
$% *%% , " +%% " &"
'" ( " )
-./ $%% 0 Description Part Number Burner Tube 03051100 Bow Shackle E0007576 Tube/Reflector Hanger 03
ページ19に含まれる内容の要旨
SECTION 6: LINEAR & DOUBLE LINEAR HEATER INSTALLATION SECTION 6: LINEAR & DOUBLE LINEAR HEATER INSTALLATION The figures in this section provide a general overview of ® component placement in a BLACKHEAT Linear and WARNING Double Linear system. The location of some components such as supports and couplings is crucial for proper installation. Assemble the heater components as shown on Page 14, Figure 19. For optional reflector configurations for linear heaters see Page 6, Figure 3 through P
ページ20に含まれる内容の要旨
® BLACKHEAT INSTALLATION OPERATION AND SERVICE MANUAL Figure 19: Linear General Assembly Overview 14 of 74 ,
1 "
,
&"'4 "
&"' &"' ,
" ,
"
23 &"' # 5
' (
)
' (,6"
0"'"
)
