ページ1に含まれる内容の要旨
Model No. EPTL09706.1
Serial No. USER'S MANUAL
Find the serial number in the location
shown below. Write the serial number
in the space above for reference.
Serial Number Decal
QUESTIONS?
As a manufacturer, we are com-
mitted to providing complete
customer satisfaction. If you
have questions, or if parts are
damaged or missing, PLEASE
CONTACT OUR CUSTOMER
SERVICE DEPARTMENT
DIRECTLY.
CALL TOLL-FREE:
1-866-997-6999
Mon.–Fri., 6 a.m.–6 p.m. MST
ON THE WEB:
www.iconservice.com
CAUTION
Read all
ページ2に含まれる内容の要旨
TABLE OF CONTENTS IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7 O
ページ3に含まれる内容の要旨
IMPORTANT PRECAUTIONS WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the following important precautions and information before operating the treadmill. 1. It is the responsibility of the owner to ensure 12. Failure to use a properly functioning surge that all users of this treadmill are adequately suppressor could result in damage to the con- informed of all warnings and precautions. trol system of the treadmill. If the control sys- tem is damaged, the wa
ページ4に含まれる内容の要旨
21. Do not change the incline of the treadmill by or other electric light or power circuits, or placing objects under the treadmill. where it can fall into such power lines or cir- cuits. When installing an outside antenna sys- 22. When folding or moving the treadmill, make tem, extreme care should be taken to keep sure that the frame is held securely by the pin from touching such power lines or circuits, as on the latch knob. contact with them might be fatal. 23. Inspect and properly tighten al
ページ5に含まれる内容の要旨
Power Lines Ground Standoff Clamp Insulators Service Entrance To External Antenna Mast Conductors Terminal of Treadmill Antenna Lead-in Wire Service Entrance Ground Antenna Equipment Wire Discharge Unit Ground Wire Power Service Grounding Ground Ground Electrode System (e.g. Bonding Clamps Clamps Interior Metal Water Pipe) Jumper Optional Antenna Grounding Electrode Driven 8 Feet (2.44m) Into The Earth (If Required By Local Codes). See NEC Section 810–21 (f). WARNING: Before beginning this or a
ページ6に含まれる内容の要旨
BEFORE YOU BEGIN ™ Thank you for selecting the revolutionary EPIC VIEW ing this manual, please see the front cover of this man- 550 treadmill. The VIEW 550 treadmill offers an im- ual. To help us assist you, please note the product pressive selection of features designed to make your model number and serial number before contacting us. workouts at home more enjoyable and effective. And The model number of the treadmill is EPTL09706.1. when you’re not exercising, the unique VIEW 550 The serial nu
ページ7に含まれる内容の要旨
4 1/2” Bolt (78)–4 nsion Leg N (106)–4 ASSEMBLY Washer (96)–8 Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not 3/4” Tek Screw (58)–4 dispose of the packing materials until assembly is completed. 1/2” Silver Screw (48)–1 Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a Spacer Screw (60)–2 small amount of lubricant may be transferred to the top of the walking belt or the ship
ページ8に含まれる内容の要旨
2. Identify the Left Upright (73) and the Right 2 97 Upright (74). Hold the Right Upright near the Right Base Cover (77) as shown. Insert the 49 Upright Wire Harness (75) up through the rec- tangular hole in the bottom of the Right Upright and out of the top of the Right Upright. Gently pull up on the Upright Wire Harness (75) 75 as you set the Right Upright (74) on the Base 73 (83) inside the Right Base Cover (77). Be care- ful not to pinch the Upright Wire Harness. 74 Attach the Right Upright
ページ9に含まれる内容の要旨
4. With the help of a second person, hold the con- 4 Console sole assembly near the Uprights (73, 74). Assembly Connect the Upright Wire Harness (75) to the Console Wire Harness (71). Make sure to con- nect the connectors properly (see the inset drawing). The connectors should slide to- gether easily and snap into place. If they do 73 not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAM- AGED WHEN THE POWER IS TURNED ON. 71 75 74 75 5. Conn
ページ10に含まれる内容の要旨
7. Slide the Right Upright Sleeve (96) up against 7 the console assembly. Attach the Right Upright Sleeve with two 3/4” Screws (4). Attach the Left Upright Sleeve (not shown) to the Left Upright (73) as described above. 73 4 96 4 74 8. Note the location of the 75 ohm antenna terminal 8 and the audio/video input jack on the treadmill. For the television to operate, the included Audio/ Audio/Video Wire Harness (115) and your DVD Video player or VCR must be connected to the Input audio/video input
ページ11に含まれる内容の要旨
If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the re- ceiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. 1 Remove the indicated 3/4” Screws (4) from the Pulse Receiver Cover (70) on the back of the Console Assembly (A). A 70 4 2. Next, hold the receiver so the small cylinder 2 is oriented as shown. Attach the receiver to the B Pulse Receiver Cover (70) with the two included Small Screws (B). Cylinder 70
ページ12に含まれる内容の要旨
Before the personal television can be used, you must connect an antenna, a 75 ohm CATV cable, or a VCR to the 75 ohm antenna terminal on the treadmill frame. Note: No antenna, cable, or adapter is included. HOW TO CONNECT AN ANTENNA 300 Ohm Flat Wire Indoor Antenna 1. See the drawing near the bottom of this page. Connect the 300 ohm flat wire from the antenna to a 1. Place a VHF 300 ohm to 75 ohm adapter. antenna in the Screwdriver desired loca- 2. Push the 300 ohm to 75 ohm adapter onto the 75
ページ13に含まれる内容の要旨
OPERATION AND ADJUSTMENT THE PRE-LUBRICATED WALKING BELT tric shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding Your treadmill features a walking belt coated with high- plug. Plug the power cord into a surge suppressor, performance lubricant. IMPORTANT: Never apply sil- and plug the surge suppressor into an appropriate icone spray or other substances to the walking outlet that is properly installed and grounded in belt or the walking platform. Su
ページ14に含まれる内容の要旨
CONSOLE DIAGRAM Note: If there is a sheet of clear plastic on the console, peel off the clear plastic. Key Clip FEATURES OF THE CONSOLE seven Performance programs. Each program automati- cally controls the speed and incline of the treadmill as it The treadmill console offers an impressive array of guides you through an effective workout. features designed to make your workouts more effec- tive and enjoyable. When the manual mode of the con- Whether you select the manual mode or a preset pro- so
ページ15に含まれる内容の要旨
HOW TO TURN ON THE POWER HOW TO USE THE MANUAL MODE Plug in the power cord Insert the key into the console. 1 1 (see page 13). Next, Reset locate the reset/off cir- See HOW TO TURN ON THE POWER on this Position cuit breaker on the page. treadmill frame near the power cord. Make Select the manual mode. 2 sure that the circuit breaker is in the reset position. Each time the key is inserted, the manual mode will be selected. If you have selected a program, Stand on the foot rails of the treadmi
ページ16に含まれる内容の要旨
Select a display mode and follow your Measure your heart rate if desired. 5 6 progress with the exercise information on the screen. Note: If you use the handgrip pulse sensor and the optional chest pulse sensor at the same time, As you walk or run on the treadmill, the screen can the display will not show your heart rate accu- display the following exercise information: rately. • The elapsed time. Note: When a program is se- To use the lected, the screen will show the time remaining handgrip in
ページ17に含まれる内容の要旨
position to the right. Note: The program diagram HOW TO USE A PRESET PROGRAM can only be displayed when the television is in Console mode. To select the Console mode, Insert the key into the console. press the TV button repeatedly until the word 1 “Console” appears on the screen. See HOW TO TURN ON THE POWER on page 15. When the first segment ends, the treadmill will au- tomatically adjust to the speed and incline settings for the second segment. Select a preset program. 2 The program will cont
ページ18に含まれる内容の要旨
Press the Volume buttons to adjust the volume. HOW TO OPERATE THE PERSONAL TELEVISION 4 When either Volume (Vol) button is pressed, the volume level indicator will appear on the screen IMPORTANT: Before operating the television, you for a few seconds. must connect an antenna, a 75 ohm CATV cable, or a VCR to the 75 ohm antenna terminal on the tread- To use earphones or headphones (not included), mill, a VCR or DVD player to the three audio/video plug them into the headphone jack beside the key
ページ19に含まれる内容の要旨
Press the TV button again and add or delete HOW TO USE THE INFORMATION MODE 3 channels. The console features an information mode that allows After all valid channels available in your area have you to view treadmill usage information, select a sys- been saved into the television’s memory (see step tem of measurement for the console, and turn on and 5 on this page), you can manually add channels turn off the demo mode. The information mode also al- or delete unwanted channels. lows you to adjust
ページ20に含まれる内容の要旨
THE OPTIONAL CHEST PULSE SENSOR An optional chest pulse sensor offers hands-free oper- ation as it monitors your heart rate during your work- outs. To purchase the optional chest pulse sensor, call the toll-free telephone number on the front cover of this manual. 20
