ページ1に含まれる内容の要旨
TM TM TM
Burlington • Denali • Tacoma
6530-680, Rev. B
ページ2に含まれる内容の要旨
Attention New Spa Owner! Congratulations on the purchase of your new Sundance® 680 series spa! The following is a list of automated functions and maintenance recommendations for your new spa. Automated functions have been listed below in an attempt to suppress any operational concerns you may have during startup and the first 24-hours of ownership! Maintenance recommendations are listed in an attempt to stress their importance in protecting your new spa. Automated Operations Approximately
ページ3に含まれる内容の要旨
Table of Contents 1.0 Important Spa Owner Information ..................................1 2.0 FCC Notice ........................................................................1 3.0 Important Safety Instructions .........................................2 3.1 Important CSA Safety Information (Canada Only) .............4 3.2 Hyperthermia .....................................................................5 3.3 Cautions .................................................................
ページ4に含まれる内容の要旨
11.0 Spa Maintenance ............................................................25 11.1 Cleaning The Filter...........................................................25 11.2 Draining and Refilling .......................................................25 11.3 Cleaning The Spa Interior ................................................27 11.4 Maintaining The Cover .....................................................27 11.5 Maintaining The Synthetic Cabinet ..................
ページ5に含まれる内容の要旨
1.0 Important Spa Owner Information Your Sundance® 680 series spa is constructed to the highest standards and is capable of providing many years of trouble-free use. However, because heat retentive materials are utilized to insulate the spa for effi- cient operation, an uncovered spa surface directly exposed to sunlight and high temperatures for an extended period is subject to permanent damage. Damage caused by exposing the spa to this abuse is not covered by warranty. We recommend that yo
ページ6に含まれる内容の要旨
3.0 Important Safety Instructions READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY! When installing and using this electrical equipment, basic safety precau- tions should always be followed, including: . WARNINg: To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times. 2. WARNINg: A grounding wire connector is provided on this unit to 2 connect a minimum No. 8 AWG (8.4mm ) solid copper conduc- tor between this unit and any metal e
ページ7に含まれる内容の要旨
National Electrical Code/USA, ANSI/NFPA 70. The disconnect must be readily accessible and visible to the spa occupant but installed at least 5 feet ( .5m) from the spa water. 8. WARNINg: To Reduce the Risk of Injury: 9. The water in a spa should never exceed 04°F (40°C). Water temperatures between 00°F (38°C) and 04°F (40°C) are consid- ered safe for a healthy adult. Lower water temperatures are recom- mended for young children and when spa use exceeds 0 minutes. 0. Since excessiv
ページ8に含まれる内容の要旨
3.1 ImpORTANT CSA SAFETY INSTRUCTIONS (CANADA ONLY) When using this electrical equipment, basic safety precautions should always be followed, including the following: 1. READ AND FOLLOW ALL INSTRUCTIONS. 2. A green colored terminal or a terminal marked G, Gr, Ground, Grounding or the symbol* is located inside the supply terminal box or compartment. To reduce the risk of electric shock, this terminal must be connected to the grounding means provided in the electric supply service panel
ページ9に含まれる内容の要旨
WARNINg : Pregnant or possibly pregnant women should consult a physician before using a spa. WARNINg : Water temperature in excess of 38°C ( 04°F) may be injurious to your health. WARNINg : Before entering the spa, measure the water temperature with an accurate thermometer. WARNINg : Do not use a spa immediately following strenuous exercise. WARNINg : Prolonged immersion in a spa may be injurious to your health. WARNINg : Do not permit electric appliances (such as light, telephone, radio
ページ10に含まれる内容の要旨
3.3 CAUTIONS . Persons suffering from heart disease, diabetes, high or low blood pressure, and any condition requiring medical treatment, pregnant women, the elderly, or infants should consult with a physician before using a spa. 2. The Consumer Products Safety Commission/USA has stated that the water temperature in a spa should not exceed 04°F (40°C). Immersion in water in excess of 04°F (40°C) can be hazardous to your health. 3. Observe a reasonable time limit when using the spa
ページ11に含まれる内容の要旨
this point and any ground metal equipment, metal water pipe or conduit within 5 feet ( .5m) of the spa, or copper clad grounding rod buried within 5 feet ( .5m) of the spa. Bonding wire must be at least No. 8 2 AWG (8.4mm ) solid copper wire. This is a most important safety assur- ance feature. Before installing your spa, check with your local building department to insure installation conforms to local building codes. 120/240 Volt Denali And Tacoma Convertible models A spa connected to
ページ12に含まれる内容の要旨
4.1 Outdoor Location In selecting the ideal outdoor location for your spa, we suggest that you take into consideration the following: • The proximity to changing area and shelter (especially in regions subject to cold weather). • The pathway to and from your spa (this should be free of debris so that dirt and leaves are not easily tracked into the spa). • The closeness to trees and shrubbery (remember that leaves and birds could create extra work in keeping the spa clean). • A sheltere
ページ13に含まれる内容の要旨
5.0 power Requirements Sundance® spas are designed to provide optimum performance and flexibility of use when connected to the maximum electrical service listed in the tables below. If you prefer, your dealer can perform a minor circuit board modification to allow your spa to accept an electrical service other than the factory setting. US/Canada Denali/Tacoma 1-pump Convertible models (60Hz) 120V/15A* 240V/30A* 240V/40A** Voltage: 20 VAC 240 VAC 240 VAC # of Wires: 3 ( 5A GFCI Cord - 4
ページ14に含まれる内容の要旨
Export Denali/Tacoma 1-pump models (50Hz) 230V/20A* 230V/30A** Voltage: 230 VAC 230 VAC # of Wires: 3 3 Frequency: 50Hz 50Hz Current Draw: 5A 2 A Circuit Breaker: 20A 30A * In the 20A configuration, the heater will not operate while either jets pump is running in high speed.. This is the factory setting. ** In the 30A configuration, the heater will operate with one pump running at high speed. Export Burlington 2-pump model (50Hz) 230V/20A* 230V/30A** V
ページ15に含まれる内容の要旨
6.0 Electrical Wiring Instructions IMPORTANT NOTICE: The electrical wiring of this spa must meet the requirements of the National Electrical Code/USA (NEC) and any applicable state or local codes. The electrical circuit must be installed by a qualified electrician and approved by a local building/electrical inspection authority. 1. Convertible 120/240V Denali/Tacoma Models Only: • 120V “Plug-in” Operation: This spa must operate on the supplied 120V GFCI cord at its original length or must
ページ16に含まれる内容の要旨
ANSI/NFPA 70. The disconnecting means must be readily accessible to the spa’s occupant but installed at least 5 feet (1.5m) from spa water. 6. The electrical circuit supplied for the spa must include a suitable ground fault circuit interruptor (GFCI) as required by NEC Article 680-42. 7. To gain access to the spa’s power terminal block, remove the screws securing the cabinet panel on the side of the spa under the control panel (page 20). Then remove the four control box door
ページ17に含まれる内容の要旨
Figure-B - Control Box 2 TB 1 . Terminal Block 2. Bonding Lug 3. Grounding Terminal 3 Figure-C Figure-D WHT TB1 TB1 WHT WHT WHT RED 1 1 BLK BLK BLK BLK BLK BLK 2 2 to Circuit RED RED Board 3 3 to Circuit Board GRN GRN All US/Canada Denali/Tacoma Convertible All US/Canada Denali/Tacoma Convertible Models: 120 VAC, 3-Wire Connection (60Hz) Models: 120/240 VAC, 4-Wire Connection (60Hz) Figure-E Figure-F RED BLUE TB1 TB1 RED RED BLUE 1 1 BLK BROWN BLK BLK BROWN 2 2 to Circuit to Circuit Green
ページ18に含まれる内容の要旨
7.0 Spa Fill Up procedure FOR BEST RESULTS, READ EACH STEP IN ITS ENTIRETY BEFORE PROCEEDING WITH THAT STEP. 1. prepare The Spa For Filling • Clear all debris from the spa. (Although the spa shell has been polished at the factory, you may want to treat it with a specially formulated spa cleaner. Consult your authorized Sundance dealer for additional information prior to filling spa. • Remove filter/skimmer lid (page 20), then remove filter cartridge as outlined in section . (page
ページ19に含まれる内容の要旨
5. Add Start-Up Chemicals Add the spa water chemicals as recommended by your autho- rized Sundance dealer. See section titled “WATER QUALITY MAINTENANCE” (page 29) for general guidance. 6. Establish A Stable Sanitizer Reading Establish a stable sanitizer reading between 3 ppm and 5 ppm chlorine or 4 ppm and 6 ppm bromine. To ensure healthy water conditions, always maintain a constant sanitizer reading within the levels recommended by the Association of Pool And Spa Profession- als/USA pr
ページ20に含まれる内容の要旨
B 8. place Cover On Spa • Keeping the insulating cover in place anytime the spa is not in use will reduce the time required for heating, thereby minimizing operating costs. • The time required for initial heat-up will vary depending on the starting water temperature. DANg ER: Risk of injury, always check water temperature carefully before entering spa! Decontamination procedure (Steps 9-15) Steps 9- 5 below are only required when sanitizer levels are unstable after performing s
